[v3,6/9] vfs: Copy should use file_out rather than file_in
diff mbox

Message ID 1443214096-12769-7-git-send-email-Anna.Schumaker@Netapp.com
State New
Headers show

Commit Message

Anna Schumaker Sept. 25, 2015, 8:48 p.m. UTC
The way to think about this is that the destination filesystem reads the
data from the source file and processes it accordingly.  This is
especially important to avoid an infinate loop when doing a "server to
server" copy on NFS.

Signed-off-by: Anna Schumaker <Anna.Schumaker@Netapp.com>
---
 fs/read_write.c | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

Patch
diff mbox

diff --git a/fs/read_write.c b/fs/read_write.c
index 8e7cb33..6f74f1f 100644
--- a/fs/read_write.c
+++ b/fs/read_write.c
@@ -1355,7 +1355,7 @@  ssize_t vfs_copy_file_range(struct file *file_in, loff_t pos_in,
 	if (!(file_in->f_mode & FMODE_READ) ||
 	    !(file_out->f_mode & FMODE_WRITE) ||
 	    (file_out->f_flags & O_APPEND) ||
-	    !file_in->f_op || !file_in->f_op->copy_file_range)
+	    !file_out->f_op || !file_out->f_op->copy_file_range)
 		return -EBADF;
 
 	inode_in = file_inode(file_in);
@@ -1378,8 +1378,8 @@  ssize_t vfs_copy_file_range(struct file *file_in, loff_t pos_in,
 	if (ret)
 		return ret;
 
-	ret = file_in->f_op->copy_file_range(file_in, pos_in, file_out, pos_out,
-					     len, flags);
+	ret = file_out->f_op->copy_file_range(file_in, pos_in, file_out, pos_out,
+					      len, flags);
 	if (ret > 0) {
 		fsnotify_access(file_in);
 		add_rchar(current, ret);