@@ -1219,6 +1219,8 @@ static void mmc_select_driver_type(struct mmc_card *card)
static int mmc_select_hs200(struct mmc_card *card)
{
struct mmc_host *host = card->host;
+ bool send_status = true;
+ unsigned int old_timing;
int err = -EINVAL;
u8 val;
@@ -1234,6 +1236,9 @@ static int mmc_select_hs200(struct mmc_card *card)
mmc_select_driver_type(card);
+ if (host->caps & MMC_CAP_WAIT_WHILE_BUSY)
+ send_status = false;
+
/*
* Set the bus width(4 or 8) with host's support and
* switch to HS200 mode if bus width is set successfully.
@@ -1245,11 +1250,25 @@ static int mmc_select_hs200(struct mmc_card *card)
err = __mmc_switch(card, EXT_CSD_CMD_SET_NORMAL,
EXT_CSD_HS_TIMING, val,
card->ext_csd.generic_cmd6_time,
- true, true, true);
- if (!err)
- mmc_set_timing(host, MMC_TIMING_MMC_HS200);
+ true, send_status, true);
+ if (err)
+ goto err;
+ old_timing = host->ios.timing;
+ mmc_set_timing(host, MMC_TIMING_MMC_HS200);
+ if (!send_status) {
+ err = mmc_switch_status(card);
+ /*
+ * mmc_select_timing() assumes timing has not changed if
+ * it is a switch error.
+ */
+ if (err == -EBADMSG)
+ mmc_set_timing(host, old_timing);
+ }
}
err:
+ if (err)
+ pr_err("%s: %s failed, error %d\n", mmc_hostname(card->host),
+ __func__, err);
return err;
}
Currently mmc_select_hs200() uses __mmc_switch() which checks the success of the switch to HS200 mode using CMD13 (SEND_STATUS). The problem is that it does that using the timing settings of legacy mode. That is prone to error, not least because the timing parameters for legacy mode are tighter than the timing parameters for HS200 mode. In the case when CMD13 polling is used (i.e. not MMC_CAP_WAIT_WHILE_BUSY) with the switch command, it must be assumed that using different modes on the card and host must work. However in the case when CMD13 polling is not used (i.e. MMC_CAP_WAIT_WHILE_BUSY) mmc_select_hs200() can be made more reliable by setting the host to the correct timing before sending CMD13. This patch does that. A complication is that the caller, mmc_select_timing(), will ignore a switch error (indicated by -EBADMSG), assume the old mode is valid and continue, so the old timing must be restored in that case. Signed-off-by: Adrian Hunter <adrian.hunter@intel.com> --- drivers/mmc/core/mmc.c | 25 ++++++++++++++++++++++--- 1 file changed, 22 insertions(+), 3 deletions(-)