@@ -1276,7 +1276,7 @@ static int mmc_select_hs200(struct mmc_card *card)
* switch to HS200 mode if bus width is set successfully.
*/
err = mmc_select_bus_width(card);
- if (!err) {
+ if (err > 0) {
val = EXT_CSD_TIMING_HS200 |
card->drive_strength << EXT_CSD_DRV_STR_SHIFT;
err = __mmc_switch(card, EXT_CSD_CMD_SET_NORMAL,
@@ -1583,7 +1583,7 @@ static int mmc_init_card(struct mmc_host *host, u32 ocr,
} else if (mmc_card_hs(card)) {
/* Select the desired bus width optionally */
err = mmc_select_bus_width(card);
- if (!err) {
+ if (err > 0) {
err = mmc_select_hs_ddr(card);
if (err)
goto free_card;
mmc_select_bus_width() returns bus width (4 or 8) on success or zero if unsupported. If bus width is set successfully we then wish to switch to HS200 mode. This avoids the following error message in v4.70-rc2 [ 2.523674] mmc0: mmc_select_hs200 failed, error 3 [ 2.528516] mmc0: error 3 whilst initialising MMC card With this patch card is enumerated correctly [ 2.468065] mmc0: new HS200 MMC card at address 0001 [ 2.468335] mmcblk0: mmc0:0001 P1XXXX 7.20 GiB [ 2.468441] mmcblk0boot0: mmc0:0001 P1XXXX partition 1 2.00 MiB [ 2.468552] mmcblk0boot1: mmc0:0001 P1XXXX partition 2 2.00 MiB [ 2.468651] mmcblk0rpmb: mmc0:0001 P1XXXX partition 3 128 KiB [ 2.469269] mmcblk0: p1 Fixes: 287980e (remove lots of IS_ERR_VALUE abuses) Signed-off-by: Peter Griffin <peter.griffin@linaro.org> Cc: Arnd Bergmann <arnd@arndb.de> --- drivers/mmc/core/mmc.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)