@@ -1058,22 +1058,27 @@ static const struct media_entity_operations tvp5150_sd_media_ops = {
static int tvp5150_s_stream(struct v4l2_subdev *sd, int enable)
{
struct tvp5150 *decoder = to_tvp5150(sd);
- /* Output format: 8-bit ITU-R BT.656 with embedded syncs */
- int val = TVP5150_MISC_CTL_YCBCR_OE | TVP5150_MISC_CTL_CLOCK_OE;
-
- /* Output format: 8-bit 4:2:2 YUV with discrete sync */
- if (decoder->mbus_type == V4L2_MBUS_PARALLEL)
- val = TVP5150_MISC_CTL_YCBCR_OE | TVP5150_MISC_CTL_SYNC_OE
- | TVP5150_MISC_CTL_CLOCK_OE;
+ int val;
- /* Initializes TVP5150 to its default values */
- /* # set PCLK (27MHz) */
- tvp5150_write(sd, TVP5150_CONF_SHARED_PIN, 0x00);
+ /* Enable or disable the video output signals. */
+ val = tvp5150_read(sd, TVP5150_MISC_CTL);
+ if (val < 0)
+ return val;
+
+ val &= ~(TVP5150_MISC_CTL_YCBCR_OE | TVP5150_MISC_CTL_SYNC_OE |
+ TVP5150_MISC_CTL_CLOCK_OE);
+
+ if (enable) {
+ /*
+ * Enable the YCbCr and clock outputs. In discrete sync mode
+ * (non-BT.656) additionally enable the the sync outputs.
+ */
+ val |= TVP5150_MISC_CTL_YCBCR_OE | TVP5150_MISC_CTL_CLOCK_OE;
+ if (decoder->mbus_type == V4L2_MBUS_PARALLEL)
+ val |= TVP5150_MISC_CTL_SYNC_OE;
+ }
- if (enable)
- tvp5150_write(sd, TVP5150_MISC_CTL, val);
- else
- tvp5150_write(sd, TVP5150_MISC_CTL, 0x00);
+ tvp5150_write(sd, TVP5150_MISC_CTL, val);
return 0;
}
The s_stream() handler incorrectly writes the whole MISC_CTL register to enable or disable the outputs, overriding the output pinmuxing configuration. Fix it to only touch the output enable bits. The CONF_SHARED_PIN register is also written by the same function, resulting in muxing the INTREQ signal instead of the VBLK/GPCL signal on the INTREQ/GPCL/VBLK pin. As the driver doesn't support interrupts this is obviously incorrect, and breaks operation on other devices. Fix it by removing the write. Signed-off-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com> --- drivers/media/i2c/tvp5150.c | 33 +++++++++++++++++++-------------- 1 file changed, 19 insertions(+), 14 deletions(-)