diff mbox

[1/5,v1] PM / Domains: Set device state to "active" during system resume

Message ID 201107062250.54261.rjw@sisk.pl (mailing list archive)
State Superseded, archived
Headers show

Commit Message

Rafael Wysocki July 6, 2011, 8:50 p.m. UTC 
From: Rafael J. Wysocki <rjw@sisk.pl>

The runtime PM status of devices in a power domain that is not
powered off in pm_genpd_complete() should be set to "active", because
those devices are operational at this point.  Some of them may not be
in use, though, so make pm_genpd_complete() call pm_runtime_idle()
in addition to pm_runtime_set_active() for each of them.

Signed-off-by: Rafael J. Wysocki <rjw@sisk.pl>
---
 drivers/base/power/domain.c |    2 ++
 1 file changed, 2 insertions(+)
diff mbox

Patch

Index: linux-2.6/drivers/base/power/domain.c
===================================================================
--- linux-2.6.orig/drivers/base/power/domain.c
+++ linux-2.6/drivers/base/power/domain.c
@@ -786,7 +786,9 @@  static void pm_genpd_complete(struct dev
 
 	if (run_complete) {
 		pm_generic_complete(dev);
+		pm_runtime_set_active(dev);
 		pm_runtime_enable(dev);
+		pm_runtime_idle(dev);
 	}
 }