diff mbox

ARM: sun6i: a31s: primo81: Change USB OTG to OTG mode

Message ID 20170609160549.3566-1-wens@csie.org (mailing list archive)
State Mainlined, archived
Headers show

Commit Message

Chen-Yu Tsai June 9, 2017, 4:05 p.m. UTC 
Now that we have support for the AXP221 PMIC's USB VBUS detection and
DRIVEVBUS vbus control, we can use the USB OTG port in proper OTG mode.

This patch enables the aforementioned PMIC functions, adds the OTG ID
detection pin to the USB PHY node, and changes the mode of USB OTG to
"otg".

Signed-off-by: Chen-Yu Tsai <wens@csie.org>
---
 arch/arm/boot/dts/sun6i-a31s-primo81.dts | 16 ++++++++++++++--
 1 file changed, 14 insertions(+), 2 deletions(-)
diff mbox

Patch

diff --git a/arch/arm/boot/dts/sun6i-a31s-primo81.dts b/arch/arm/boot/dts/sun6i-a31s-primo81.dts
index f3712753fa42..73b163a7d9dd 100644
--- a/arch/arm/boot/dts/sun6i-a31s-primo81.dts
+++ b/arch/arm/boot/dts/sun6i-a31s-primo81.dts
@@ -158,6 +158,7 @@ 
 		reg = <0x68>;
 		interrupt-parent = <&nmi_intc>;
 		interrupts = <0 IRQ_TYPE_LEVEL_LOW>;
+		x-powers,drive-vbus-en;
 	};
 };
 
@@ -226,6 +227,11 @@ 
 	regulator-name = "vddio-csi";
 };
 
+&reg_drivevbus {
+	regulator-name = "usb0-vbus";
+	status = "okay";
+};
+
 &reg_eldo3 {
 	regulator-min-microvolt = <1080000>;
 	regulator-max-microvolt = <1320000>;
@@ -238,12 +244,18 @@ 
 };
 
 &usb_otg {
-	/* otg support requires support for AXP221 usb-power-supply and GPIO */
-	dr_mode = "host";
+	dr_mode = "otg";
+	status = "okay";
+};
+
+&usb_power_supply {
 	status = "okay";
 };
 
 &usbphy {
+	usb0_id_det-gpio = <&pio 0 15 GPIO_ACTIVE_HIGH>; /* PA15 */
+	usb0_vbus_power-supply = <&usb_power_supply>;
+	usb0_vbus-supply = <&reg_drivevbus>;
 	usb1_vbus-supply = <&reg_dldo1>;
 	status = "okay";
 };