| Message ID | 20230721151816.2080453-1-sbinding@opensource.cirrus.com (mailing list archive) |
|---|---|
| Headers | show |
| Series | Fix support for System Suspend for CS35L41 HDA | expand |
On Fri, 21 Jul 2023 17:18:05 +0200, Stefan Binding wrote: > > There have been a couple of customer reports of intermittant issues after > system resume, where sometimes the DSP firmware stops responding. > Investigations into this issue show that there is a race between receiving > a prepare from the HDA core, and the firmware reload which is started by > the system resume. This can causes the Global Enable on the CS35L41 to be > enabled during the firmware load, which can sometimes cause issues in the > DSP. > > The existing system resume behaviour also did not resume the audio, if > audio was previously playing when it was suspended. > In addition, during investigation, it was found there were additional > problems in the System Resume sequence, as well as the Playback sequence > with External Boost, where the driver does not correctly follow its > enable sequence for this mode. This can cause additional issues such as > pops and clicks. > > This chain intends to correct the sequences for playback and system > suspend/resume so that the driver: obeys the external boost enable sequence; > resumes audio on system resume; and avoids the race condition on firmware > load and playback during system resume. > > Changes since v1: > - Split patch 1 into 2 separate patches > - Combine Patches 6 and 9 > > Stefan Binding (11): > ALSA: cs35l41: Use mbox command to enable speaker output for external > boost > ALSA: cs35l41: Poll for Power Up/Down rather than waiting a fixed > delay > ALSA: hda: cs35l41: Check mailbox status of pause command after > firmware load > ALSA: hda: cs35l41: Ensure we correctly re-sync regmap before system > suspending. > ALSA: hda: cs35l41: Ensure we pass up any errors during system > suspend. > ALSA: hda: cs35l41: Move Play and Pause into separate functions > ALSA: hda: hda_component: Add pre and post playback hooks to > hda_component > ALSA: hda: cs35l41: Use pre and post playback hooks > ALSA: hda: cs35l41: Rework System Suspend to ensure correct call > separation > ALSA: hda: cs35l41: Add device_link between HDA and cs35l41_hda > ALSA: hda: cs35l41: Ensure amp is only unmuted during playback Applied all patches now to for-next branch. thanks, Takashi
On Mon, 24 Jul 2023 11:00:38 +0200, Takashi Iwai wrote: > > On Fri, 21 Jul 2023 17:18:05 +0200, > Stefan Binding wrote: > > > > There have been a couple of customer reports of intermittant issues after > > system resume, where sometimes the DSP firmware stops responding. > > Investigations into this issue show that there is a race between receiving > > a prepare from the HDA core, and the firmware reload which is started by > > the system resume. This can causes the Global Enable on the CS35L41 to be > > enabled during the firmware load, which can sometimes cause issues in the > > DSP. > > > > The existing system resume behaviour also did not resume the audio, if > > audio was previously playing when it was suspended. > > In addition, during investigation, it was found there were additional > > problems in the System Resume sequence, as well as the Playback sequence > > with External Boost, where the driver does not correctly follow its > > enable sequence for this mode. This can cause additional issues such as > > pops and clicks. > > > > This chain intends to correct the sequences for playback and system > > suspend/resume so that the driver: obeys the external boost enable sequence; > > resumes audio on system resume; and avoids the race condition on firmware > > load and playback during system resume. > > > > Changes since v1: > > - Split patch 1 into 2 separate patches > > - Combine Patches 6 and 9 > > > > Stefan Binding (11): > > ALSA: cs35l41: Use mbox command to enable speaker output for external > > boost > > ALSA: cs35l41: Poll for Power Up/Down rather than waiting a fixed > > delay > > ALSA: hda: cs35l41: Check mailbox status of pause command after > > firmware load > > ALSA: hda: cs35l41: Ensure we correctly re-sync regmap before system > > suspending. > > ALSA: hda: cs35l41: Ensure we pass up any errors during system > > suspend. > > ALSA: hda: cs35l41: Move Play and Pause into separate functions > > ALSA: hda: hda_component: Add pre and post playback hooks to > > hda_component > > ALSA: hda: cs35l41: Use pre and post playback hooks > > ALSA: hda: cs35l41: Rework System Suspend to ensure correct call > > separation > > ALSA: hda: cs35l41: Add device_link between HDA and cs35l41_hda > > ALSA: hda: cs35l41: Ensure amp is only unmuted during playback > > Applied all patches now to for-next branch. It seems that this patch set causes occasional freeze at suspend: https://bugzilla.suse.com/show_bug.cgi?id=1213745 Could you take a look? thanks, Takashi
On 28/07/2023 12:10, Takashi Iwai wrote: > On Mon, 24 Jul 2023 11:00:38 +0200, > Takashi Iwai wrote: >> On Fri, 21 Jul 2023 17:18:05 +0200, >> Stefan Binding wrote: >>> There have been a couple of customer reports of intermittant issues after >>> system resume, where sometimes the DSP firmware stops responding. >>> Investigations into this issue show that there is a race between receiving >>> a prepare from the HDA core, and the firmware reload which is started by >>> the system resume. This can causes the Global Enable on the CS35L41 to be >>> enabled during the firmware load, which can sometimes cause issues in the >>> DSP. >>> >>> The existing system resume behaviour also did not resume the audio, if >>> audio was previously playing when it was suspended. >>> In addition, during investigation, it was found there were additional >>> problems in the System Resume sequence, as well as the Playback sequence >>> with External Boost, where the driver does not correctly follow its >>> enable sequence for this mode. This can cause additional issues such as >>> pops and clicks. >>> >>> This chain intends to correct the sequences for playback and system >>> suspend/resume so that the driver: obeys the external boost enable sequence; >>> resumes audio on system resume; and avoids the race condition on firmware >>> load and playback during system resume. >>> >>> Changes since v1: >>> - Split patch 1 into 2 separate patches >>> - Combine Patches 6 and 9 >>> >>> Stefan Binding (11): >>> ALSA: cs35l41: Use mbox command to enable speaker output for external >>> boost >>> ALSA: cs35l41: Poll for Power Up/Down rather than waiting a fixed >>> delay >>> ALSA: hda: cs35l41: Check mailbox status of pause command after >>> firmware load >>> ALSA: hda: cs35l41: Ensure we correctly re-sync regmap before system >>> suspending. >>> ALSA: hda: cs35l41: Ensure we pass up any errors during system >>> suspend. >>> ALSA: hda: cs35l41: Move Play and Pause into separate functions >>> ALSA: hda: hda_component: Add pre and post playback hooks to >>> hda_component >>> ALSA: hda: cs35l41: Use pre and post playback hooks >>> ALSA: hda: cs35l41: Rework System Suspend to ensure correct call >>> separation >>> ALSA: hda: cs35l41: Add device_link between HDA and cs35l41_hda >>> ALSA: hda: cs35l41: Ensure amp is only unmuted during playback >> Applied all patches now to for-next branch. > It seems that this patch set causes occasional freeze at suspend: > https://bugzilla.suse.com/show_bug.cgi?id=1213745 > > Could you take a look? > > > thanks, > > Takashi Hi Takashi, The initial bug report shows one of the original issues that this patch chain was trying to fix. From what I can tell from the second issue, something has caused the CS35L41 to stop responding, which in turn caused the system suspend call to fail, and the error is passed up. Since system suspend failed, there was no corresponding system resume, which means the CS35L41 was stuck broken. I'm not sure what was meant by "freeze" and "overheating" in the bug report, since the log seems to indicate the laptop is still responsive, even if audio is broken. There is some oddity in the log, since one of the errors that was printed should only be printed when the CS35L41 is using External Boost, but I think this laptop is supposed to use Internal Boost. We'll investigate further. Thanks, Stefan Binding
There have been a couple of customer reports of intermittant issues after system resume, where sometimes the DSP firmware stops responding. Investigations into this issue show that there is a race between receiving a prepare from the HDA core, and the firmware reload which is started by the system resume. This can causes the Global Enable on the CS35L41 to be enabled during the firmware load, which can sometimes cause issues in the DSP. The existing system resume behaviour also did not resume the audio, if audio was previously playing when it was suspended. In addition, during investigation, it was found there were additional problems in the System Resume sequence, as well as the Playback sequence with External Boost, where the driver does not correctly follow its enable sequence for this mode. This can cause additional issues such as pops and clicks. This chain intends to correct the sequences for playback and system suspend/resume so that the driver: obeys the external boost enable sequence; resumes audio on system resume; and avoids the race condition on firmware load and playback during system resume. Changes since v1: - Split patch 1 into 2 separate patches - Combine Patches 6 and 9 Stefan Binding (11): ALSA: cs35l41: Use mbox command to enable speaker output for external boost ALSA: cs35l41: Poll for Power Up/Down rather than waiting a fixed delay ALSA: hda: cs35l41: Check mailbox status of pause command after firmware load ALSA: hda: cs35l41: Ensure we correctly re-sync regmap before system suspending. ALSA: hda: cs35l41: Ensure we pass up any errors during system suspend. ALSA: hda: cs35l41: Move Play and Pause into separate functions ALSA: hda: hda_component: Add pre and post playback hooks to hda_component ALSA: hda: cs35l41: Use pre and post playback hooks ALSA: hda: cs35l41: Rework System Suspend to ensure correct call separation ALSA: hda: cs35l41: Add device_link between HDA and cs35l41_hda ALSA: hda: cs35l41: Ensure amp is only unmuted during playback include/sound/cs35l41.h | 5 +- sound/pci/hda/cs35l41_hda.c | 288 +++++++++++++++++++++++++-------- sound/pci/hda/hda_component.h | 2 + sound/pci/hda/patch_realtek.c | 10 +- sound/soc/codecs/cs35l41-lib.c | 118 ++++++++++++-- sound/soc/codecs/cs35l41.c | 18 +-- 6 files changed, 343 insertions(+), 98 deletions(-)