@@ -8,6 +8,7 @@ Required properties:
- compatible: should be one of the following:
- "allwinner,sun4i-a10-i2s"
- "allwinner,sun6i-a31-i2s"
+ - "allwinner,sun8i-a83t-i2s"
- "allwinner,sun8i-h3-i2s"
- reg: physical base address of the controller and length of memory mapped
region.
@@ -23,6 +24,7 @@ Required properties:
Required properties for the following compatibles:
- "allwinner,sun6i-a31-i2s"
+ - "allwinner,sun8i-a83t-i2s"
- "allwinner,sun8i-h3-i2s"
- resets: phandle to the reset line for this codec
@@ -921,6 +921,23 @@ static const struct sun4i_i2s_quirks sun6i_a31_i2s_quirks = {
.field_rxchansel = REG_FIELD(SUN4I_I2S_RX_CHAN_SEL_REG, 0, 2),
};
+static const struct sun4i_i2s_quirks sun8i_a83t_i2s_quirks = {
+ .has_reset = true,
+ .reg_offset_txdata = SUN8I_I2S_FIFO_TX_REG,
+ .sun4i_i2s_regmap = &sun4i_i2s_regmap_config,
+ .field_clkdiv_mclk_en = REG_FIELD(SUN4I_I2S_CLK_DIV_REG, 7, 7),
+ .field_fmt_wss = REG_FIELD(SUN4I_I2S_FMT0_REG, 2, 3),
+ .field_fmt_sr = REG_FIELD(SUN4I_I2S_FMT0_REG, 4, 5),
+ .field_fmt_bclk = REG_FIELD(SUN4I_I2S_FMT0_REG, 6, 6),
+ .field_fmt_lrclk = REG_FIELD(SUN4I_I2S_FMT0_REG, 7, 7),
+ .has_slave_select_bit = true,
+ .field_fmt_mode = REG_FIELD(SUN4I_I2S_FMT0_REG, 0, 1),
+ .field_txchanmap = REG_FIELD(SUN4I_I2S_TX_CHAN_MAP_REG, 0, 31),
+ .field_rxchanmap = REG_FIELD(SUN4I_I2S_RX_CHAN_MAP_REG, 0, 31),
+ .field_txchansel = REG_FIELD(SUN4I_I2S_TX_CHAN_SEL_REG, 0, 2),
+ .field_rxchansel = REG_FIELD(SUN4I_I2S_RX_CHAN_SEL_REG, 0, 2),
+};
+
static const struct sun4i_i2s_quirks sun8i_h3_i2s_quirks = {
.has_reset = true,
.reg_offset_txdata = SUN8I_I2S_FIFO_TX_REG,
@@ -1144,6 +1161,10 @@ static const struct of_device_id sun4i_i2s_match[] = {
.compatible = "allwinner,sun6i-a31-i2s",
.data = &sun6i_a31_i2s_quirks,
},
+ {
+ .compatible = "allwinner,sun8i-a83t-i2s",
+ .data = &sun8i_a83t_i2s_quirks,
+ },
{
.compatible = "allwinner,sun8i-h3-i2s",
.data = &sun8i_h3_i2s_quirks,
The I2S controller in the A83T is mostly compatible with the one found in earlier SoCs such as the A20 and A31. While the documents publicly available for the A83T do not cover this hardware, the officially released BSP kernel does have register definitions for it. These were matched against the A20 user manual. The only difference is the TX FIFO and interrupt status registers have been swapped around, like what we have seen with the SPDIF controller. This patch adds support for this hardware. Signed-off-by: Chen-Yu Tsai <wens@csie.org> --- .../devicetree/bindings/sound/sun4i-i2s.txt | 2 ++ sound/soc/sunxi/sun4i-i2s.c | 21 +++++++++++++++++++++ 2 files changed, 23 insertions(+)