@@ -50,9 +50,7 @@ static void pxa2xx_spi_dma_transfer_complete(struct driver_data *drv_data,
if (error) {
/* In case we got an error we disable the SSP now */
- pxa2xx_spi_write(drv_data, SSCR0,
- pxa2xx_spi_read(drv_data, SSCR0)
- & ~SSCR0_SSE);
+ pxa_ssp_disable(drv_data->ssp);
msg->status = -EIO;
}
@@ -286,13 +286,11 @@ static u32 pxa2xx_configure_sscr0(const struct driver_data *drv_data,
case QUARK_X1000_SSP:
return clk_div
| QUARK_X1000_SSCR0_Motorola
- | QUARK_X1000_SSCR0_DataSize(bits > 32 ? 8 : bits)
- | SSCR0_SSE;
+ | QUARK_X1000_SSCR0_DataSize(bits > 32 ? 8 : bits);
default:
return clk_div
| SSCR0_Motorola
| SSCR0_DataSize(bits > 16 ? bits - 16 : bits)
- | SSCR0_SSE
| (bits > 16 ? SSCR0_EDSS : 0);
}
}
@@ -498,8 +496,7 @@ static void pxa2xx_spi_off(struct driver_data *drv_data)
if (is_mmp2_ssp(drv_data))
return;
- pxa2xx_spi_write(drv_data, SSCR0,
- pxa2xx_spi_read(drv_data, SSCR0) & ~SSCR0_SSE);
+ pxa_ssp_disable(drv_data->ssp);
}
static int null_writer(struct driver_data *drv_data)
@@ -1098,25 +1095,26 @@ static int pxa2xx_spi_transfer_one(struct spi_controller *controller,
(pxa2xx_spi_read(drv_data, DDS_RATE) != chip->dds_rate))
pxa2xx_spi_write(drv_data, DDS_RATE, chip->dds_rate);
+ /* Stop the SSP */
+ if (!is_mmp2_ssp(drv_data))
+ pxa_ssp_disable(drv_data->ssp);
+
+ if (!pxa25x_ssp_comp(drv_data))
+ pxa2xx_spi_write(drv_data, SSTO, chip->timeout);
+
/* see if we need to reload the config registers */
if ((pxa2xx_spi_read(drv_data, SSCR0) != cr0)
|| (pxa2xx_spi_read(drv_data, SSCR1) & change_mask)
!= (cr1 & change_mask)) {
- /* stop the SSP, and update the other bits */
- if (!is_mmp2_ssp(drv_data))
- pxa2xx_spi_write(drv_data, SSCR0, cr0 & ~SSCR0_SSE);
- if (!pxa25x_ssp_comp(drv_data))
- pxa2xx_spi_write(drv_data, SSTO, chip->timeout);
/* first set CR1 without interrupt and service enables */
pxa2xx_spi_write(drv_data, SSCR1, cr1 & change_mask);
- /* restart the SSP */
+ /* Update the other bits */
pxa2xx_spi_write(drv_data, SSCR0, cr0);
-
- } else {
- if (!pxa25x_ssp_comp(drv_data))
- pxa2xx_spi_write(drv_data, SSTO, chip->timeout);
}
+ /* Restart the SSP */
+ pxa_ssp_enable(drv_data->ssp);
+
if (is_mmp2_ssp(drv_data)) {
u8 tx_level = (pxa2xx_spi_read(drv_data, SSSR)
& SSSR_TFL_MASK) >> 8;
@@ -1786,8 +1784,9 @@ static int pxa2xx_spi_probe(struct platform_device *pdev)
controller->min_speed_hz =
DIV_ROUND_UP(controller->max_speed_hz, 512);
+ pxa_ssp_disable(ssp);
+
/* Load default SSP configuration */
- pxa2xx_spi_write(drv_data, SSCR0, 0);
switch (drv_data->ssp_type) {
case QUARK_X1000_SSP:
tmp = QUARK_X1000_SSCR1_RxTresh(RX_THRESH_QUARK_X1000_DFLT) |
@@ -1928,7 +1927,7 @@ static int pxa2xx_spi_remove(struct platform_device *pdev)
spi_unregister_controller(drv_data->controller);
/* Disable the SSP at the peripheral and SOC level */
- pxa2xx_spi_write(drv_data, SSCR0, 0);
+ pxa_ssp_disable(ssp);
clk_disable_unprepare(ssp->clk);
/* Release DMA */
@@ -1957,7 +1956,8 @@ static int pxa2xx_spi_suspend(struct device *dev)
status = spi_controller_suspend(drv_data->controller);
if (status != 0)
return status;
- pxa2xx_spi_write(drv_data, SSCR0, 0);
+
+ pxa_ssp_disable(ssp);
if (!pm_runtime_suspended(dev))
clk_disable_unprepare(ssp->clk);
@@ -254,6 +254,22 @@ static inline u32 pxa_ssp_read_reg(struct ssp_device *dev, u32 reg)
return __raw_readl(dev->mmio_base + reg);
}
+static inline void pxa_ssp_enable(struct ssp_device *ssp)
+{
+ u32 sscr0;
+
+ sscr0 = pxa_ssp_read_reg(ssp, SSCR0) | SSCR0_SSE;
+ pxa_ssp_write_reg(ssp, SSCR0, sscr0);
+}
+
+static inline void pxa_ssp_disable(struct ssp_device *ssp)
+{
+ u32 sscr0;
+
+ sscr0 = pxa_ssp_read_reg(ssp, SSCR0) & ~SSCR0_SSE;
+ pxa_ssp_write_reg(ssp, SSCR0, sscr0);
+}
+
#if IS_ENABLED(CONFIG_PXA_SSP)
struct ssp_device *pxa_ssp_request(int port, const char *label);
void pxa_ssp_free(struct ssp_device *);
@@ -61,22 +61,6 @@ static void dump_registers(struct ssp_device *ssp)
pxa_ssp_read_reg(ssp, SSACD));
}
-static void pxa_ssp_enable(struct ssp_device *ssp)
-{
- uint32_t sscr0;
-
- sscr0 = __raw_readl(ssp->mmio_base + SSCR0) | SSCR0_SSE;
- __raw_writel(sscr0, ssp->mmio_base + SSCR0);
-}
-
-static void pxa_ssp_disable(struct ssp_device *ssp)
-{
- uint32_t sscr0;
-
- sscr0 = __raw_readl(ssp->mmio_base + SSCR0) & ~SSCR0_SSE;
- __raw_writel(sscr0, ssp->mmio_base + SSCR0);
-}
-
static void pxa_ssp_set_dma_params(struct ssp_device *ssp, int width4,
int out, struct snd_dmaengine_dai_dma_data *dma)
{
There are few places that repeat the logic of pxa_ssp_enable() and pxa_ssp_disable(). Use them instead of open coded variants. Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com> --- drivers/spi/spi-pxa2xx-dma.c | 4 +--- drivers/spi/spi-pxa2xx.c | 36 ++++++++++++++++++------------------ include/linux/pxa2xx_ssp.h | 16 ++++++++++++++++ sound/soc/pxa/pxa-ssp.c | 16 ---------------- 4 files changed, 35 insertions(+), 37 deletions(-)