[v2,60/65] clk: stm32: composite: Switch to determine_rate

Commit Message

Maxime Ripard Nov. 4, 2022, 1:18 p.m. UTC

The STM32 composite clocks implements a mux with a set_parent hook, but
doesn't provide a determine_rate implementation.

This is a bit odd, since set_parent() is there to, as its name implies,
change the parent of a clock. However, the most likely candidate to
trigger that parent change is a call to clk_set_rate(), with
determine_rate() figuring out which parent is the best suited for a
given rate.

The other trigger would be a call to clk_set_parent(), but it's far less
used, and it doesn't look like there's any obvious user for that clock.

So, the set_parent hook is effectively unused, possibly because of an
oversight. However, it could also be an explicit decision by the
original author to avoid any reparenting but through an explicit call to
clk_set_parent().

The driver does implement round_rate() though, which means that we can
change the rate of the clock, but we will never get to change the
parent.

However, It's hard to tell whether it's been done on purpose or not.

Since we'll start mandating a determine_rate() implementation, let's
convert the round_rate() implementation to a determine_rate(), which
will also make the current behavior explicit. And if it was an
oversight, the clock behaviour can be adjusted later on.

Signed-off-by: Maxime Ripard <[e-mail]>
---
 drivers/clk/stm32/clk-stm32-core.c | 31 +++++++++++++++++++++----------
 1 file changed, 21 insertions(+), 10 deletions(-)

Patch

diff --git a/drivers/clk/stm32/clk-stm32-core.c b/drivers/clk/stm32/clk-stm32-core.c
index 3247539683c9..4027ca7d9806 100644
--- a/drivers/clk/stm32/clk-stm32-core.c
+++ b/drivers/clk/stm32/clk-stm32-core.c
@@ -349,14 +349,15 @@  static int clk_stm32_divider_set_rate(struct clk_hw *hw, unsigned long rate,
 	return ret;
 }
 
-static long clk_stm32_divider_round_rate(struct clk_hw *hw, unsigned long rate,
-					 unsigned long *prate)
+static int clk_stm32_divider_determine_rate(struct clk_hw *hw,
+					    struct clk_rate_request *req)
 {
 	struct clk_stm32_div *div = to_clk_stm32_divider(hw);
 	const struct stm32_div_cfg *divider;
+	unsigned long rate;
 
 	if (div->div_id == NO_STM32_DIV)
-		return rate;
+		return 0;
 
 	divider = &div->clock_data->dividers[div->div_id];
 
@@ -367,14 +368,24 @@  static long clk_stm32_divider_round_rate(struct clk_hw *hw, unsigned long rate,
 		val =  readl(div->base + divider->offset) >> divider->shift;
 		val &= clk_div_mask(divider->width);
 
-		return divider_ro_round_rate(hw, rate, prate, divider->table,
-				divider->width, divider->flags,
-				val);
+		rate = divider_ro_round_rate(hw, req->rate, &req->best_parent_rate,
+					     divider->table, divider->width, divider->flags,
+					     val);
+		if (rate < 0)
+			return rate;
+
+		req->rate = rate;
+		return 0;
 	}
 
-	return divider_round_rate_parent(hw, clk_hw_get_parent(hw),
-					 rate, prate, divider->table,
-					 divider->width, divider->flags);
+	rate = divider_round_rate_parent(hw, clk_hw_get_parent(hw),
+					 req->rate, &req->best_parent_rate,
+					 divider->table, divider->width, divider->flags);
+	if (rate < 0)
+		return rate;
+
+	req->rate = rate;
+	return 0;
 }
 
 static unsigned long clk_stm32_divider_recalc_rate(struct clk_hw *hw,
@@ -602,7 +613,7 @@  static void clk_stm32_composite_disable_unused(struct clk_hw *hw)
 const struct clk_ops clk_stm32_composite_ops = {
 	.set_rate	= clk_stm32_composite_set_rate,
 	.recalc_rate	= clk_stm32_composite_recalc_rate,
-	.round_rate	= clk_stm32_composite_round_rate,
+	.determine_rate	= clk_stm32_composite_determine_rate,
 	.get_parent	= clk_stm32_composite_get_parent,
 	.set_parent	= clk_stm32_composite_set_parent,
 	.enable		= clk_stm32_composite_gate_enable,