diff mbox series

[v2,2/3] ASoC: es8316: Do not set rate constraints for unsupported MCLKs

Message ID 20230530181140.483936-3-cristian.ciocaltea@collabora.com (mailing list archive)
State Accepted
Commit 60413129ee2b38a80347489270af7f6e1c1de4d0
Headers show
Series ES8316 audio codec fixes on Rock5B | expand

Commit Message

Cristian Ciocaltea May 30, 2023, 6:11 p.m. UTC
When using the codec through the generic audio graph card, there are at
least two calls of es8316_set_dai_sysclk(), with the effect of limiting
the allowed sample rates according to the MCLK/LRCK ratios supported by
the codec:

1. During audio card setup, to set the initial MCLK - see
   asoc_simple_init_dai().

2. Before opening a stream, to update MCLK, according to the stream
   sample rate and the multiplication factor - see
   asoc_simple_hw_params().

In some cases the initial MCLK might be set to a frequency that doesn't
match any of the supported ratios, e.g. 12287999 instead of 12288000,
which is only 1 Hz below the supported clock, as that is what the
hardware reports. This creates an empty list of rate constraints, which
is further passed to snd_pcm_hw_constraint_list() via
es8316_pcm_startup(), and causes the following error on the very first
access of the sound card:

  $ speaker-test -D hw:Analog,0 -F S16_LE -c 2 -t wav
  Broken configuration for playback: no configurations available: Invalid argument
  Setting of hwparams failed: Invalid argument

Note that all subsequent retries succeed thanks to the updated MCLK set
at point 2 above, which uses a computed frequency value instead of a
reading from the hardware registers. Normally this would have mitigated
the issue, but es8316_pcm_startup() executes before the 2nd call to
es8316_set_dai_sysclk(), hence it cannot make use of the updated
constraints.

Since es8316_pcm_hw_params() performs anyway a final validation of MCLK
against the stream sample rate and the supported MCLK/LRCK ratios, fix
the issue by ensuring that sysclk_constraints list is only set when at
least one supported sample rate is autodetected by the codec.

Fixes: b8b88b70875a ("ASoC: add es8316 codec driver")
Signed-off-by: Cristian Ciocaltea <cristian.ciocaltea@collabora.com>
---
 sound/soc/codecs/es8316.c | 14 +++++++-------
 1 file changed, 7 insertions(+), 7 deletions(-)
diff mbox series

Patch

diff --git a/sound/soc/codecs/es8316.c b/sound/soc/codecs/es8316.c
index 8f0625b45b7c..069f1ce1cd50 100644
--- a/sound/soc/codecs/es8316.c
+++ b/sound/soc/codecs/es8316.c
@@ -369,13 +369,11 @@  static int es8316_set_dai_sysclk(struct snd_soc_dai *codec_dai,
 	int count = 0;
 
 	es8316->sysclk = freq;
+	es8316->sysclk_constraints.list = NULL;
+	es8316->sysclk_constraints.count = 0;
 
-	if (freq == 0) {
-		es8316->sysclk_constraints.list = NULL;
-		es8316->sysclk_constraints.count = 0;
-
+	if (freq == 0)
 		return 0;
-	}
 
 	ret = clk_set_rate(es8316->mclk, freq);
 	if (ret)
@@ -391,8 +389,10 @@  static int es8316_set_dai_sysclk(struct snd_soc_dai *codec_dai,
 			es8316->allowed_rates[count++] = freq / ratio;
 	}
 
-	es8316->sysclk_constraints.list = es8316->allowed_rates;
-	es8316->sysclk_constraints.count = count;
+	if (count) {
+		es8316->sysclk_constraints.list = es8316->allowed_rates;
+		es8316->sysclk_constraints.count = count;
+	}
 
 	return 0;
 }