@@ -1684,8 +1684,7 @@ struct snd_emu1010 {
unsigned int clock_fallback;
unsigned int optical_in; /* 0:SPDIF, 1:ADAT */
unsigned int optical_out; /* 0:SPDIF, 1:ADAT */
- struct work_struct firmware_work;
- struct work_struct clock_work;
+ struct work_struct work;
};
struct snd_emu10k1 {
@@ -189,8 +189,7 @@ static int snd_emu10k1_suspend(struct device *dev)
emu->suspend = 1;
- cancel_work_sync(&emu->emu1010.firmware_work);
- cancel_work_sync(&emu->emu1010.clock_work);
+ cancel_work_sync(&emu->emu1010.work);
snd_ac97_suspend(emu->ac97);
@@ -765,19 +765,10 @@ static void snd_emu1010_load_dock_firmware(struct snd_emu10k1 *emu)
msleep(10);
}
-static void emu1010_firmware_work(struct work_struct *work)
+static void emu1010_dock_event(struct snd_emu10k1 *emu)
{
- struct snd_emu10k1 *emu;
u32 reg;
- emu = container_of(work, struct snd_emu10k1,
- emu1010.firmware_work);
- if (emu->card->shutdown)
- return;
-#ifdef CONFIG_PM_SLEEP
- if (emu->suspend)
- return;
-#endif
snd_emu1010_fpga_read(emu, EMU_HANA_OPTION_CARDS, ®); /* OPTIONS: Which cards are attached to the EMU */
if (reg & EMU_HANA_OPTION_DOCK_OFFLINE) {
/* Audio Dock attached */
@@ -792,43 +783,54 @@ static void emu1010_firmware_work(struct work_struct *work)
}
}
-static void emu1010_clock_work(struct work_struct *work)
+static void emu1010_clock_event(struct snd_emu10k1 *emu)
{
- struct snd_emu10k1 *emu;
struct snd_ctl_elem_id id;
- emu = container_of(work, struct snd_emu10k1,
- emu1010.clock_work);
- if (emu->card->shutdown)
- return;
-#ifdef CONFIG_PM_SLEEP
- if (emu->suspend)
- return;
-#endif
-
spin_lock_irq(&emu->reg_lock);
// This is the only thing that can actually happen.
emu->emu1010.clock_source = emu->emu1010.clock_fallback;
emu->emu1010.wclock = 1 - emu->emu1010.clock_source;
snd_emu1010_update_clock(emu);
spin_unlock_irq(&emu->reg_lock);
snd_ctl_build_ioff(&id, emu->ctl_clock_source, 0);
snd_ctl_notify(emu->card, SNDRV_CTL_EVENT_MASK_VALUE, &id);
}
-static void emu1010_interrupt(struct snd_emu10k1 *emu)
+static void emu1010_work(struct work_struct *work)
{
+ struct snd_emu10k1 *emu;
u32 sts;
+ emu = container_of(work, struct snd_emu10k1, emu1010.work);
+ if (emu->card->shutdown)
+ return;
+#ifdef CONFIG_PM_SLEEP
+ if (emu->suspend)
+ return;
+#endif
+
snd_emu1010_fpga_read(emu, EMU_HANA_IRQ_STATUS, &sts);
// The distinction of the IRQ status bits is unreliable,
// so we dispatch later based on option card status.
if (sts & (EMU_HANA_IRQ_DOCK | EMU_HANA_IRQ_DOCK_LOST))
- schedule_work(&emu->emu1010.firmware_work);
+ emu1010_dock_event(emu);
if (sts & EMU_HANA_IRQ_WCLK_CHANGED)
- schedule_work(&emu->emu1010.clock_work);
+ emu1010_clock_event(emu);
+}
+
+static void emu1010_interrupt(struct snd_emu10k1 *emu)
+{
+ // We get an interrupt on each GPIO input pin change, but we
+ // care only about the ones triggered by the dedicated pin.
+ u16 sts = inw(emu->port + A_GPIO);
+ u16 bit = emu->card_capabilities->ca0108_chip ? 0x2000 : 0x8000;
+ if (!(sts & bit))
+ return;
+
+ schedule_work(&emu->emu1010.work);
}
/*
@@ -969,8 +971,7 @@ static void snd_emu10k1_free(struct snd_card *card)
/* Disable 48Volt power to Audio Dock */
snd_emu1010_fpga_write(emu, EMU_HANA_DOCK_PWR, 0);
}
- cancel_work_sync(&emu->emu1010.firmware_work);
- cancel_work_sync(&emu->emu1010.clock_work);
+ cancel_work_sync(&emu->emu1010.work);
release_firmware(emu->firmware);
release_firmware(emu->dock_fw);
snd_util_memhdr_free(emu->memhdr);
@@ -1549,8 +1550,7 @@ int snd_emu10k1_create(struct snd_card *card,
emu->irq = -1;
emu->synth = NULL;
emu->get_synth_voice = NULL;
- INIT_WORK(&emu->emu1010.firmware_work, emu1010_firmware_work);
- INIT_WORK(&emu->emu1010.clock_work, emu1010_clock_work);
+ INIT_WORK(&emu->emu1010.work, emu1010_work);
/* read revision & serial */
emu->revision = pci->revision;
pci_read_config_dword(pci, PCI_SUBSYSTEM_VENDOR_ID, &emu->serial);
The actual event processing was already done by workqueue items. We can move the event dispatching there as well, rather than doing it already in the interrupt handler callback. This change has a rather profound "side effect" on the reliability of the FPGA programming: once we enter programming mode, we must not issue any snd_emu1010_fpga_{read,write}() calls until we're done, as these would badly mess up the programming protocol. But exactly that would happen when trying to program the dock, as that triggers GPIO interrupts as a side effect. This is mitigated by deferring the actual interrupt handling, as workqueue items are not re-entrant. To avoid scheduling the dispatcher on non-events, we now explicitly ignore GPIO IRQs triggered by "uninteresting" pins, which happens a lot as a side effect of calling snd_emu1010_fpga_{read,write}(). Fixes: fbb64eedf5a3 (ALSA: emu10k1: make E-MU dock monitoring interrupt-driven) Link: https://bugzilla.kernel.org/show_bug.cgi?id=218584 Signed-off-by: Oswald Buddenhagen <oswald.buddenhagen@gmx.de> --- include/sound/emu10k1.h | 3 +- sound/pci/emu10k1/emu10k1.c | 3 +- sound/pci/emu10k1/emu10k1_main.c | 56 ++++++++++++++++---------------- 3 files changed, 30 insertions(+), 32 deletions(-)