@@ -121,7 +121,7 @@ static const struct cs8409_i2c_param cs42l42_init_reg_seq[] = {
{ CS42L42_MIXER_CHA_VOL, 0x3F },
{ CS42L42_MIXER_CHB_VOL, 0x3F },
{ CS42L42_MIXER_ADC_VOL, 0x3f },
- { CS42L42_HP_CTL, 0x03 },
+ { CS42L42_HP_CTL, 0x0D },
{ CS42L42_MIC_DET_CTL1, 0xB6 },
{ CS42L42_TIPSENSE_CTL, 0xC2 },
{ CS42L42_HS_CLAMP_DISABLE, 0x01 },
@@ -315,7 +315,7 @@ static const struct cs8409_i2c_param dolphin_c0_init_reg_seq[] = {
{ CS42L42_ASP_TX_SZ_EN, 0x01 },
{ CS42L42_PWR_CTL1, 0x0A },
{ CS42L42_PWR_CTL2, 0x84 },
- { CS42L42_HP_CTL, 0x03 },
+ { CS42L42_HP_CTL, 0x0D },
{ CS42L42_MIXER_CHA_VOL, 0x3F },
{ CS42L42_MIXER_CHB_VOL, 0x3F },
{ CS42L42_MIXER_ADC_VOL, 0x3f },
@@ -371,7 +371,7 @@ static const struct cs8409_i2c_param dolphin_c1_init_reg_seq[] = {
{ CS42L42_ASP_TX_SZ_EN, 0x00 },
{ CS42L42_PWR_CTL1, 0x0E },
{ CS42L42_PWR_CTL2, 0x84 },
- { CS42L42_HP_CTL, 0x01 },
+ { CS42L42_HP_CTL, 0x0D },
{ CS42L42_MIXER_CHA_VOL, 0x3F },
{ CS42L42_MIXER_CHB_VOL, 0x3F },
{ CS42L42_MIXER_ADC_VOL, 0x3f },
@@ -876,7 +876,7 @@ static void cs42l42_resume(struct sub_codec *cs42l42)
{ CS42L42_DET_INT_STATUS2, 0x00 },
{ CS42L42_TSRS_PLUG_STATUS, 0x00 },
};
- int fsv_old, fsv_new;
+ unsigned int fsv;
/* Bring CS42L42 out of Reset */
spec->gpio_data = snd_hda_codec_read(codec, CS8409_PIN_AFG, 0, AC_VERB_GET_GPIO_DATA, 0);
@@ -893,13 +893,15 @@ static void cs42l42_resume(struct sub_codec *cs42l42)
/* Clear interrupts, by reading interrupt status registers */
cs8409_i2c_bulk_read(cs42l42, irq_regs, ARRAY_SIZE(irq_regs));
- fsv_old = cs8409_i2c_read(cs42l42, CS42L42_HP_CTL);
- if (cs42l42->full_scale_vol == CS42L42_FULL_SCALE_VOL_0DB)
- fsv_new = fsv_old & ~CS42L42_FULL_SCALE_VOL_MASK;
- else
- fsv_new = fsv_old & CS42L42_FULL_SCALE_VOL_MASK;
- if (fsv_new != fsv_old)
- cs8409_i2c_write(cs42l42, CS42L42_HP_CTL, fsv_new);
+ fsv = cs8409_i2c_read(cs42l42, CS42L42_HP_CTL);
+ if (cs42l42->full_scale_vol) {
+ // Set the full scale volume bit
+ fsv |= CS42L42_FULL_SCALE_VOL_MASK;
+ cs8409_i2c_write(cs42l42, CS42L42_HP_CTL, fsv);
+ }
+ // Unmute analog channels A and B
+ fsv = (fsv & ~CS42L42_ANA_MUTE_AB);
+ cs8409_i2c_write(cs42l42, CS42L42_HP_CTL, fsv);
/* we have to explicitly allow unsol event handling even during the
* resume phase so that the jack event is processed properly
@@ -920,7 +922,7 @@ static void cs42l42_suspend(struct sub_codec *cs42l42)
{ CS42L42_MIXER_CHA_VOL, 0x3F },
{ CS42L42_MIXER_ADC_VOL, 0x3F },
{ CS42L42_MIXER_CHB_VOL, 0x3F },
- { CS42L42_HP_CTL, 0x0F },
+ { CS42L42_HP_CTL, 0x0D },
{ CS42L42_ASP_RX_DAI0_EN, 0x00 },
{ CS42L42_ASP_CLK_CFG, 0x00 },
{ CS42L42_PWR_CTL1, 0xFE },
@@ -230,9 +230,10 @@ enum cs8409_coefficient_index_registers {
#define CS42L42_PDN_TIMEOUT_US (250000)
#define CS42L42_PDN_SLEEP_US (2000)
#define CS42L42_INIT_TIMEOUT_MS (45)
+#define CS42L42_ANA_MUTE_AB (0x0C)
#define CS42L42_FULL_SCALE_VOL_MASK (2)
-#define CS42L42_FULL_SCALE_VOL_0DB (1)
-#define CS42L42_FULL_SCALE_VOL_MINUS6DB (0)
+#define CS42L42_FULL_SCALE_VOL_0DB (0)
+#define CS42L42_FULL_SCALE_VOL_MINUS6DB (1)
/* Dell BULLSEYE / WARLOCK / CYBORG Specific Definitions */
This patch corrects the full-scale volume setting logic. On certain platforms, the full-scale volume bit is required. The current logic mistakenly sets this bit and incorrectly clears reserved bit 0, causing the headphone output to be muted. Fixies: 342b6b610ae2 (ALSA: hda/cs8409: Fix Full Scale Volume setting for all variants) Signed-off-by: Vitaly Rodionov <vitalyr@opensource.cirrus.com> --- sound/pci/hda/patch_cs8409-tables.c | 6 +++--- sound/pci/hda/patch_cs8409.c | 20 +++++++++++--------- sound/pci/hda/patch_cs8409.h | 5 +++-- 3 files changed, 17 insertions(+), 14 deletions(-)