Bluetooth: btrtl: Add the support for RTL8851B

Commit Message

Max Chou April 18, 2023, 5:43 a.m. UTC

From: Max Chou <[e-mail]>

Add the support for RTL8851B BT controller on USB interface.
The necessary firmware will be submitted to linux-firmware project.

Note that the Bluetooth devices WITH the VID=0x0bda would be set the
feature quirk in btrtl_setup_realtek(). It's able to ignore the
feature flag set for the specific VID and PID in blacklist_table[] of
btusb.c. (check [1])

If Realtek Bluetooth chips WITHOUT the VID=0x0bda, it shall be added
the feature flag for the specific VID and PID in blacklist_table[] of
btusb.c. (check [2])

[1] '9ab9235fe5cf ("Bluetooth: btrtl: Enable WBS for the specific
    Realtek devices")'
[2] '73280f13c9bb ("Bluetooth: btusb: Add the more support IDs for
    Realtek RTL8822CE")'

The device info from /sys/kernel/debug/usb/devices as below.

T:  Bus=03 Lev=01 Prnt=01 Port=00 Cnt=01 Dev#= 33 Spd=480  MxCh= 0
D:  Ver= 2.00 Cls=ef(misc ) Sub=02 Prot=01 MxPS=64 #Cfgs=  1
P:  Vendor=0bda ProdID=b851 Rev= 0.00
S:  Manufacturer=Realtek
S:  Product=802.11ax WLAN Adapter
S:  SerialNumber=00E04C885A01
C:* #Ifs= 3 Cfg#= 1 Atr=80 MxPwr=500mA
A:  FirstIf#= 0 IfCount= 2 Cls=e0(wlcon) Sub=01 Prot=01
I:* If#= 0 Alt= 0 #EPs= 3 Cls=e0(wlcon) Sub=01 Prot=01 Driver=btusb
E:  Ad=81(I) Atr=03(Int.) MxPS=  16 Ivl=1ms
E:  Ad=02(O) Atr=02(Bulk) MxPS= 512 Ivl=0ms
E:  Ad=82(I) Atr=02(Bulk) MxPS= 512 Ivl=0ms
I:* If#= 1 Alt= 0 #EPs= 2 Cls=e0(wlcon) Sub=01 Prot=01 Driver=btusb
E:  Ad=03(O) Atr=01(Isoc) MxPS=   0 Ivl=1ms
E:  Ad=83(I) Atr=01(Isoc) MxPS=   0 Ivl=1ms
I:  If#= 1 Alt= 1 #EPs= 2 Cls=e0(wlcon) Sub=01 Prot=01 Driver=btusb
E:  Ad=03(O) Atr=01(Isoc) MxPS=   9 Ivl=1ms
E:  Ad=83(I) Atr=01(Isoc) MxPS=   9 Ivl=1ms
I:  If#= 1 Alt= 2 #EPs= 2 Cls=e0(wlcon) Sub=01 Prot=01 Driver=btusb
E:  Ad=03(O) Atr=01(Isoc) MxPS=  17 Ivl=1ms
E:  Ad=83(I) Atr=01(Isoc) MxPS=  17 Ivl=1ms
I:  If#= 1 Alt= 3 #EPs= 2 Cls=e0(wlcon) Sub=01 Prot=01 Driver=btusb
E:  Ad=03(O) Atr=01(Isoc) MxPS=  25 Ivl=1ms
E:  Ad=83(I) Atr=01(Isoc) MxPS=  25 Ivl=1ms
I:  If#= 1 Alt= 4 #EPs= 2 Cls=e0(wlcon) Sub=01 Prot=01 Driver=btusb
E:  Ad=03(O) Atr=01(Isoc) MxPS=  33 Ivl=1ms
E:  Ad=83(I) Atr=01(Isoc) MxPS=  33 Ivl=1ms
I:  If#= 1 Alt= 5 #EPs= 2 Cls=e0(wlcon) Sub=01 Prot=01 Driver=btusb
E:  Ad=03(O) Atr=01(Isoc) MxPS=  49 Ivl=1ms
E:  Ad=83(I) Atr=01(Isoc) MxPS=  49 Ivl=1ms
I:* If#= 2 Alt= 0 #EPs= 8 Cls=ff(vend.) Sub=ff Prot=ff Driver=(none)
E:  Ad=84(I) Atr=02(Bulk) MxPS= 512 Ivl=0ms
E:  Ad=05(O) Atr=02(Bulk) MxPS= 512 Ivl=0ms
E:  Ad=06(O) Atr=02(Bulk) MxPS= 512 Ivl=0ms
E:  Ad=07(O) Atr=02(Bulk) MxPS= 512 Ivl=0ms
E:  Ad=09(O) Atr=02(Bulk) MxPS= 512 Ivl=0ms
E:  Ad=0a(O) Atr=02(Bulk) MxPS= 512 Ivl=0ms
E:  Ad=0b(O) Atr=02(Bulk) MxPS= 512 Ivl=0ms
E:  Ad=0c(O) Atr=02(Bulk) MxPS= 512 Ivl=0ms

Signed-off-by: Max Chou <[e-mail]>
---
 drivers/bluetooth/btrtl.c | 15 +++++++++++++++
 1 file changed, 15 insertions(+)

Comments

[e-mail] April 18, 2023, 6:36 a.m. UTC | #1

This is automated email and please do not reply to this email!

Dear submitter,

Thank you for submitting the patches to the linux bluetooth mailing list.
This is a CI test results with your patch series:
PW Link:https://patchwork.kernel.org/project/bluetooth/list/?series=740762

---Test result---

Test Summary:
CheckPatch                    PASS      0.64 seconds
GitLint                       PASS      0.29 seconds
SubjectPrefix                 PASS      0.10 seconds
BuildKernel                   PASS      33.69 seconds
CheckAllWarning               PASS      36.83 seconds
CheckSparse                   PASS      41.43 seconds
CheckSmatch                   PASS      112.30 seconds
BuildKernel32                 PASS      32.27 seconds
TestRunnerSetup               PASS      462.85 seconds
TestRunner_l2cap-tester       PASS      17.23 seconds
TestRunner_iso-tester         PASS      21.09 seconds
TestRunner_bnep-tester        PASS      5.59 seconds
TestRunner_mgmt-tester        PASS      117.55 seconds
TestRunner_rfcomm-tester      PASS      9.05 seconds
TestRunner_sco-tester         PASS      8.40 seconds
TestRunner_ioctl-tester       PASS      9.80 seconds
TestRunner_mesh-tester        PASS      7.14 seconds
TestRunner_smp-tester         PASS      8.25 seconds
TestRunner_userchan-tester    PASS      5.93 seconds
IncrementalBuild              PASS      30.53 seconds



---
Regards,
Linux Bluetooth

[e-mail] April 20, 2023, midnight UTC | #2

Hello:

This patch was applied to bluetooth/bluetooth-next.git (master)
by Luiz Augusto von Dentz <[e-mail]>:

On Tue, 18 Apr 2023 13:43:54 +0800 you wrote:
> From: Max Chou <[e-mail]>
> 
> Add the support for RTL8851B BT controller on USB interface.
> The necessary firmware will be submitted to linux-firmware project.
> 
> Note that the Bluetooth devices WITH the VID=0x0bda would be set the
> feature quirk in btrtl_setup_realtek(). It's able to ignore the
> feature flag set for the specific VID and PID in blacklist_table[] of
> btusb.c. (check [1])
> 
> [...]

Here is the summary with links:
  - Bluetooth: btrtl: Add the support for RTL8851B
    https://git.kernel.org/bluetooth/bluetooth-next/c/9b4f511443f7

You are awesome, thank you!

Patch

diff --git a/drivers/bluetooth/btrtl.c b/drivers/bluetooth/btrtl.c
index 2ced74f8f87d..2915c82d719d 100644
--- a/drivers/bluetooth/btrtl.c
+++ b/drivers/bluetooth/btrtl.c
@@ -29,6 +29,7 @@ 
 #define RTL_ROM_LMP_8761A	0x8761
 #define RTL_ROM_LMP_8822B	0x8822
 #define RTL_ROM_LMP_8852A	0x8852
+#define RTL_ROM_LMP_8851B	0x8851
 #define RTL_CONFIG_MAGIC	0x8723ab55
 
 #define IC_MATCH_FL_LMPSUBV	(1 << 0)
@@ -65,6 +66,7 @@  enum btrtl_chip_id {
 	CHIP_ID_8852A = 18,
 	CHIP_ID_8852B = 20,
 	CHIP_ID_8852C = 25,
+	CHIP_ID_8851B = 36,
 };
 
 struct id_table {
@@ -271,6 +273,14 @@  static const struct id_table ic_id_table[] = {
 	  .has_msft_ext = true,
 	  .fw_name  = "rtl_bt/rtl8852cu_fw.bin",
 	  .cfg_name = "rtl_bt/rtl8852cu_config" },
+
+	/* 8851B */
+	{ IC_INFO(RTL_ROM_LMP_8851B, 0xb, 0xc, HCI_USB),
+	  .config_needed = false,
+	  .has_rom_version = true,
+	  .has_msft_ext = false,
+	  .fw_name  = "rtl_bt/rtl8851bu_fw.bin",
+	  .cfg_name = "rtl_bt/rtl8851bu_config" },
 	};
 
 static const struct id_table *btrtl_match_ic(u16 lmp_subver, u16 hci_rev,
@@ -607,6 +617,7 @@  static int rtlbt_parse_firmware(struct hci_dev *hdev,
 		{ RTL_ROM_LMP_8852A, 18 },	/* 8852A */
 		{ RTL_ROM_LMP_8852A, 20 },	/* 8852B */
 		{ RTL_ROM_LMP_8852A, 25 },	/* 8852C */
+		{ RTL_ROM_LMP_8851B, 36 },	/* 8851B */
 	};
 
 	if (btrtl_dev->fw_len <= 8)
@@ -1134,6 +1145,7 @@  int btrtl_download_firmware(struct hci_dev *hdev,
 	case RTL_ROM_LMP_8822B:
 	case RTL_ROM_LMP_8852A:
 	case RTL_ROM_LMP_8703B:
+	case RTL_ROM_LMP_8851B:
 		return btrtl_setup_rtl8723b(hdev, btrtl_dev);
 	default:
 		rtl_dev_info(hdev, "assuming no firmware upload needed");
@@ -1158,6 +1170,7 @@  void btrtl_set_quirks(struct hci_dev *hdev, struct btrtl_device_info *btrtl_dev)
 	case CHIP_ID_8852A:
 	case CHIP_ID_8852B:
 	case CHIP_ID_8852C:
+	case CHIP_ID_8851B:
 		set_bit(HCI_QUIRK_VALID_LE_STATES, &hdev->quirks);
 		set_bit(HCI_QUIRK_WIDEBAND_SPEECH_SUPPORTED, &hdev->quirks);
 
@@ -1370,3 +1383,5 @@  MODULE_FIRMWARE("rtl_bt/rtl8852bu_fw.bin");
 MODULE_FIRMWARE("rtl_bt/rtl8852bu_config.bin");
 MODULE_FIRMWARE("rtl_bt/rtl8852cu_fw.bin");
 MODULE_FIRMWARE("rtl_bt/rtl8852cu_config.bin");
+MODULE_FIRMWARE("rtl_bt/rtl8851bu_fw.bin");
+MODULE_FIRMWARE("rtl_bt/rtl8851bu_config.bin");