Context |
Check |
Description |
tedd_an/pre-ci_am |
success
|
Success
|
tedd_an/checkpatch |
success
|
Checkpatch PASS
|
tedd_an/gitlint |
fail
|
[v3,1/2] dt-bindings: net: broadcom-bluetooth: Add property for autobaud mode
14: B1 Line exceeds max length (93>80): " https://lore.kernel.org/linux-devicetree/e6e83743-1441-dc53-fd1f-cdfb9a24932a@linaro.org/"
|
tedd_an/subjectprefix |
fail
|
"Bluetooth: " is not specified in the subject
|
tedd_an/buildkernel |
success
|
Build Kernel PASS
|
tedd_an/buildkernel32 |
success
|
Build Kernel32 PASS
|
tedd_an/incremental_build |
success
|
Pass
|
tedd_an/testrunnersetup |
success
|
Test Runner Setup PASS
|
tedd_an/testrunnerl2cap-tester |
success
|
Total: 40, Passed: 40 (100.0%), Failed: 0, Not Run: 0
|
tedd_an/testrunnerbnep-tester |
success
|
Total: 1, Passed: 1 (100.0%), Failed: 0, Not Run: 0
|
tedd_an/testrunnermgmt-tester |
success
|
Total: 493, Passed: 493 (100.0%), Failed: 0, Not Run: 0
|
tedd_an/testrunnerrfcomm-tester |
success
|
Total: 10, Passed: 10 (100.0%), Failed: 0, Not Run: 0
|
tedd_an/testrunnersco-tester |
success
|
Total: 12, Passed: 12 (100.0%), Failed: 0, Not Run: 0
|
tedd_an/testrunnersmp-tester |
success
|
Total: 8, Passed: 8 (100.0%), Failed: 0, Not Run: 0
|
tedd_an/testrunneruserchan-tester |
success
|
Total: 4, Passed: 4 (100.0%), Failed: 0, Not Run: 0
|
@@ -92,6 +92,13 @@ properties:
pcm-sync-mode: slave, master
pcm-clock-mode: slave, master
+ brcm,requires-autobaud-mode:
+ type: boolean
+ description:
+ Set this property if autobaud mode is required. Autobaud mode is required
+ if the device's initial baud rate in normal mode is not supported by the
+ host or if the device requires autobaud mode startup before loading FW.
+
interrupts:
items:
- description: Handle to the line HOST_WAKE used to wake
Add property, "brcm,requires-autobaud-mode", to enable autobaud mode selection. Some devices (e.g. CYW5557x) require autobaud mode to enable FW loading. Autobaud mode can also be required on some boards where the controller device is using a non-standard baud rate when first powered on. Signed-off-by: Hakan Jansson <hakan.jansson@infineon.com> --- V2 -> V3: - Rename DT property and modify description https://lore.kernel.org/linux-devicetree/e6e83743-1441-dc53-fd1f-cdfb9a24932a@linaro.org/ V1 -> V2: - Modify property description .../devicetree/bindings/net/broadcom-bluetooth.yaml | 7 +++++++ 1 file changed, 7 insertions(+)