| Message ID | 1496372952-27110-4-git-send-email-bmarzins@redhat.com (mailing list archive) |
|---|---|
| State | Not Applicable, archived |
| Delegated to: | christophe varoqui |
| Headers | show |
diff --git a/libmultipath/debug.c b/libmultipath/debug.c index fbe171a..f89b264 100644 --- a/libmultipath/debug.c +++ b/libmultipath/debug.c @@ -11,6 +11,7 @@ #include "../third-party/valgrind/drd.h" #include "vector.h" #include "config.h" +#include "defaults.h" void dlog (int sink, int prio, const char * fmt, ...) { @@ -21,7 +22,7 @@ void dlog (int sink, int prio, const char * fmt, ...) va_start(ap, fmt); conf = get_multipath_config(); ANNOTATE_IGNORE_READS_BEGIN(); - thres = (conf) ? conf->verbosity : 0; + thres = (conf) ? conf->verbosity : DEFAULT_VERBOSITY; ANNOTATE_IGNORE_READS_END(); put_multipath_config(conf);
condlog was setting the verbosity to 0 if there was no configuration. This keeps multipath from printing warning messages about config file problems that are found while loading the configuration. Instead, it should use the default config level until it loads the configuration to find the current value. Signed-off-by: Benjamin Marzinski <bmarzins@redhat.com> --- libmultipath/debug.c | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-)