@@ -778,6 +778,13 @@ int intel_parse_bios(struct drm_device *dev);
#define MIPI_DSI_UNDEFINED_PANEL_ID 0
#define MIPI_DSI_GENERIC_PANEL_ID 1
+/*
+ * PMIC vs SoC Backlight support specified in pwm_blc
+ * field in mipi_config block below.
+*/
+#define PPS_BLC_PMIC 0
+#define PPS_BLC_SOC 1
+
struct mipi_config {
u16 panel_id;
@@ -31,6 +31,7 @@
#include <drm/drm_panel.h>
#include <drm/drm_mipi_dsi.h>
#include <linux/slab.h>
+#include <linux/gpio/consumer.h>
#include "i915_drv.h"
#include "intel_drv.h"
#include "intel_dsi.h"
@@ -415,6 +416,12 @@ static void intel_dsi_pre_enable(struct intel_encoder *encoder)
DRM_DEBUG_KMS("\n");
+ /* Panel Enable over CRC PMIC */
+ if (intel_dsi->gpio_panel)
+ gpiod_set_value_cansleep(intel_dsi->gpio_panel, 1);
+
+ msleep(intel_dsi->panel_on_delay);
+
/* Disable DPOunit clock gating, can stall pipe
* and we need DPLL REFA always enabled */
tmp = I915_READ(DPLL(pipe));
@@ -432,8 +439,6 @@ static void intel_dsi_pre_enable(struct intel_encoder *encoder)
/* put device in ready state */
intel_dsi_device_ready(encoder);
- msleep(intel_dsi->panel_on_delay);
-
drm_panel_prepare(intel_dsi->panel);
for_each_dsi_port(port, intel_dsi->ports)
@@ -576,6 +581,10 @@ static void intel_dsi_post_disable(struct intel_encoder *encoder)
msleep(intel_dsi->panel_off_delay);
msleep(intel_dsi->panel_pwr_cycle_delay);
+
+ /* Panel Disable over CRC PMIC */
+ if (intel_dsi->gpio_panel)
+ gpiod_set_value_cansleep(intel_dsi->gpio_panel, 0);
}
static bool intel_dsi_get_hw_state(struct intel_encoder *encoder,
@@ -955,6 +964,11 @@ static void intel_dsi_encoder_destroy(struct drm_encoder *encoder)
/* XXX: Logically this call belongs in the panel driver. */
drm_panel_remove(intel_dsi->panel);
}
+
+ /* dispose of the gpios */
+ if (intel_dsi->gpio_panel)
+ gpiod_put(intel_dsi->gpio_panel);
+
intel_encoder_destroy(encoder);
}
@@ -1071,6 +1085,20 @@ void intel_dsi_init(struct drm_device *dev)
goto err;
}
+ /*
+ * In case of BYT with CRC PMIC, we need to use GPIO for
+ * Panel control.
+ */
+ if (dev_priv->vbt.dsi.config->pwm_blc == PPS_BLC_PMIC) {
+ intel_dsi->gpio_panel =
+ gpiod_get(dev->dev, "panel", GPIOD_OUT_HIGH);
+
+ if (IS_ERR(intel_dsi->gpio_panel)) {
+ DRM_ERROR("Failed to own gpio for panel control\n");
+ intel_dsi->gpio_panel = NULL;
+ }
+ }
+
intel_encoder->type = INTEL_OUTPUT_DSI;
intel_encoder->cloneable = 0;
drm_connector_init(dev, connector, &intel_dsi_connector_funcs,
@@ -42,6 +42,9 @@ struct intel_dsi {
struct drm_panel *panel;
struct intel_dsi_host *dsi_hosts[I915_MAX_PORTS];
+ /* GPIO Desc for CRC based Panel control */
+ struct gpio_desc *gpio_panel;
+
struct intel_connector *attached_connector;
/* bit mask of ports being driven */