@@ -429,12 +429,8 @@ static int st7703_prepare(struct drm_panel *panel)
return 0;
DRM_DEV_DEBUG_DRIVER(ctx->dev, "Resetting the panel\n");
- ret = regulator_enable(ctx->vcc);
- if (ret < 0) {
- DRM_DEV_ERROR(ctx->dev,
- "Failed to enable vcc supply: %d\n", ret);
- return ret;
- }
+ gpiod_set_value_cansleep(ctx->reset_gpio, 1);
+
ret = regulator_enable(ctx->iovcc);
if (ret < 0) {
DRM_DEV_ERROR(ctx->dev,
@@ -442,10 +438,18 @@ static int st7703_prepare(struct drm_panel *panel)
goto disable_vcc;
}
- gpiod_set_value_cansleep(ctx->reset_gpio, 1);
- usleep_range(20, 40);
+ ret = regulator_enable(ctx->vcc);
+ if (ret < 0) {
+ DRM_DEV_ERROR(ctx->dev,
+ "Failed to enable vcc supply: %d\n", ret);
+ return ret;
+ }
+
+ /* Give power supplies time to stabilize before deasserting reset. */
+ usleep_range(10000, 20000);
+
gpiod_set_value_cansleep(ctx->reset_gpio, 0);
- msleep(20);
+ usleep_range(15000, 20000);
ctx->prepared = true;
The datasheet specifies that it's better to keep reset asserted while powering up the supplies, and that IOVCC should be enabled first. There also needs to be a delay after enabling the supplies and before deasserting the reset. The datasheet specifies 1ms after the supplies reach the required voltage. Use 10-20ms to also give the power supplies some time to reach the required voltage, too. This fixes intermittent panel initialization failures and screen corruption during resume from sleep on PinePhone. Reported-by: Samuel Holland <samuel@sholland.org> Signed-off-by: Ondrej Jirman <megous@megous.com> --- drivers/gpu/drm/panel/panel-sitronix-st7703.c | 22 +++++++++++-------- 1 file changed, 13 insertions(+), 9 deletions(-)