@@ -72,6 +72,16 @@ led-0 {
};
};
+ panel {
+ compatible = "eink,ed103tc2";
+
+ port {
+ panel_in_ebc: endpoint {
+ remote-endpoint = <&ebc_out_panel>;
+ };
+ };
+ };
+
sdio_pwrseq: sdio-pwrseq {
compatible = "mmc-pwrseq-simple";
clocks = <&rk817 1>;
@@ -213,6 +223,20 @@ &cpu3 {
cpu-supply = <&vdd_cpu>;
};
+&ebc {
+ io-channels = <&ebc_pmic 0>;
+ panel-supply = <&v3p3>;
+ vcom-supply = <&vcom>;
+ vdrive-supply = <&vdrive>;
+ status = "okay";
+
+ port {
+ ebc_out_panel: endpoint {
+ remote-endpoint = <&panel_in_ebc>;
+ };
+ };
+};
+
&i2c0 {
status = "okay";
@@ -466,6 +490,47 @@ led@1 {
default-brightness = <0>;
};
};
+
+ /* TODO: write binding */
+ ebc_pmic: pmic@68 {
+ compatible = "ti,tps65185";
+ reg = <0x68>;
+ interrupt-parent = <&gpio3>;
+ interrupts = <RK_PA6 IRQ_TYPE_LEVEL_LOW>;
+ #io-channel-cells = <1>;
+ pinctrl-0 = <&ebc_pmic_pins>;
+ pinctrl-names = "default";
+ powerup-gpios = <&gpio3 RK_PB0 GPIO_ACTIVE_HIGH>;
+ pwr_good-gpios = <&gpio3 RK_PA7 GPIO_ACTIVE_HIGH>;
+ vcom_ctrl-gpios = <&gpio4 RK_PB2 GPIO_ACTIVE_HIGH>;
+ vin-supply = <&vcc_bat>;
+ vin3p3-supply = <&vcc_3v3>;
+ wakeup-gpios = <&gpio3 RK_PA5 GPIO_ACTIVE_HIGH>;
+ ti,up-sequence = <1>, <0>, <2>, <3>;
+ ti,up-delay-ms = <3>, <3>, <3>, <3>;
+ ti,down-sequence = <2>, <3>, <1>, <0>;
+ ti,down-delay-ms = <3>, <6>, <6>, <6>;
+
+ regulators {
+ v3p3: v3p3 {
+ regulator-name = "v3p3";
+ regulator-always-on;
+ regulator-min-microvolt = <3300000>;
+ regulator-max-microvolt = <3300000>;
+ };
+
+ vcom: vcom {
+ regulator-name = "vcom";
+ /* voltage range is board-specific */
+ };
+
+ vdrive: vdrive {
+ regulator-name = "vdrive";
+ regulator-min-microvolt = <15000000>;
+ regulator-max-microvolt = <15000000>;
+ };
+ };
+ };
};
&i2s1_8ch {
@@ -508,6 +573,21 @@ bt_wake_h: bt-wake-h {
};
};
+ ebc-pmic {
+ ebc_pmic_pins: ebc-pmic-pins {
+ rockchip,pins = /* wakeup */
+ <3 RK_PA5 RK_FUNC_GPIO &pcfg_pull_none>,
+ /* int */
+ <3 RK_PA6 RK_FUNC_GPIO &pcfg_pull_up>,
+ /* pwr_good */
+ <3 RK_PA7 RK_FUNC_GPIO &pcfg_pull_none>,
+ /* pwrup */
+ <3 RK_PB0 RK_FUNC_GPIO &pcfg_pull_none>,
+ /* vcom_ctrl */
+ <4 RK_PB2 RK_FUNC_GPIO &pcfg_pull_none>;
+ };
+ };
+
led {
led_pin: led-pin {
rockchip,pins = <3 RK_PC5 RK_FUNC_GPIO &pcfg_pull_none>;
The PineNote contains an eInk ED103TC2 panel connected to the EBC, powered by a TI TPS651851 PMIC. Signed-off-by: Samuel Holland <samuel@sholland.org> --- .../boot/dts/rockchip/rk3566-pinenote.dtsi | 80 +++++++++++++++++++ 1 file changed, 80 insertions(+)