new file mode 100644
@@ -0,0 +1,119 @@
+# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
+%YAML 1.2
+---
+$id: http://devicetree.org/schemas/display/ti/ti,am625-oldi.yaml#
+$schema: http://devicetree.org/meta-schemas/core.yaml#
+
+title: Texas Instruments AM625 OLDI Transmitter
+
+maintainers:
+ - Tomi Valkeinen <tomi.valkeinen@ideasonboard.com>
+ - Aradhya Bhatia <aradhya.bhatia@linux.dev>
+
+description:
+ The AM625 TI Keystone OpenLDI transmitter (OLDI TX) supports serialized RGB
+ pixel data transmission between host and flat panel display over LVDS (Low
+ Voltage Differential Sampling) interface. The OLDI TX consists of 7-to-1 data
+ serializers, and 4-data and 1-clock LVDS outputs. It supports the LVDS output
+ formats "jeida-18", "jeida-24" and "vesa-18", and can accept 24-bit RGB or
+ padded and un-padded 18-bit RGB bus formats as input.
+
+properties:
+ reg:
+ maxItems: 1
+
+ clocks:
+ maxItems: 1
+ description: serial clock input for the OLDI transmitters
+
+ clock-names:
+ const: serial
+
+ ti,companion-oldi:
+ $ref: /schemas/types.yaml#/definitions/phandle
+ description:
+ phandle to companion OLDI transmitter. This property is mandatory for the
+ primarty OLDI TX if the OLDI TXes are expected to work either in dual-lvds
+ mode or in clone mode. This property should point to the secondary OLDI
+ TX.
+
+ ti,secondary-oldi:
+ type: boolean
+ description:
+ Boolean property to mark the OLDI transmitter as the secondary one, when the
+ OLDI hardware is expected to run as a companion HW, in cases of dual-lvds
+ mode or clone mode. The primary OLDI hardware is responsible for all the
+ hardware configuration.
+
+ ti,oldi-io-ctrl:
+ $ref: /schemas/types.yaml#/definitions/phandle
+ description:
+ phandle to syscon device node mapping OLDI IO_CTRL registers found in the
+ control MMR region. These registers are required to toggle the I/O lane
+ power, and control its electrical characteristics.
+
+ ports:
+ $ref: /schemas/graph.yaml#/properties/ports
+
+ properties:
+ port@0:
+ $ref: /schemas/graph.yaml#/properties/port
+ description: Parallel RGB input port
+
+ port@1:
+ $ref: /schemas/graph.yaml#/properties/port
+ description: LVDS output port
+
+ required:
+ - port@0
+ - port@1
+
+allOf:
+ - if:
+ required:
+ - ti,secondary-oldi
+ then:
+ properties:
+ ti,companion-oldi: false
+
+required:
+ - reg
+ - clocks
+ - clock-names
+ - ti,oldi-io-ctrl
+ - ports
+
+additionalProperties: false
+
+examples:
+ - |
+ #include <dt-bindings/soc/ti,sci_pm_domain.h>
+
+ oldi-transmitters {
+ #address-cells = <1>;
+ #size-cells = <0>;
+ oldi: oldi@0 {
+ reg = <0>;
+ clocks = <&k3_clks 186 0>;
+ clock-names = "serial";
+ ti,oldi-io-ctrl = <&dss_oldi_io_ctrl>;
+ ports {
+ #address-cells = <1>;
+ #size-cells = <0>;
+ port@0 {
+ reg = <0>;
+ oldi_in: endpoint {
+ remote-endpoint = <&dpi_out>;
+ };
+ };
+ port@1 {
+ reg = <1>;
+ oldi_out: endpoint {
+ remote-endpoint = <&panel_in>;
+ };
+ };
+ };
+ };
+ };
+
+...
@@ -91,6 +91,24 @@ properties:
For AM625 DSS, the internal DPI output port node from video
port 1.
For AM62A7 DSS, the port is tied off inside the SoC.
+ properties:
+ endpoint@0:
+ $ref: /schemas/graph.yaml#/properties/endpoint
+ description:
+ For AM625 DSS, VP Connection to OLDI0.
+ For AM65X DSS, OLDI output from the SoC.
+
+ endpoint@1:
+ $ref: /schemas/graph.yaml#/properties/endpoint
+ description:
+ For AM625 DSS, VP Connection to OLDI1.
+
+ anyOf:
+ - required:
+ - endpoint
+ - required:
+ - endpoint@0
+ - endpoint@1
port@1:
$ref: /schemas/graph.yaml#/properties/port
@@ -112,6 +130,26 @@ properties:
Input memory (from main memory to dispc) bandwidth limit in
bytes per second
+ oldi-transmitters:
+ description:
+ Child node under the DSS, to describe all the OLDI transmitters connected
+ to the DSS videoports.
+ type: object
+ additionalProperties: false
+ properties:
+ "#address-cells":
+ const: 1
+
+ "#size-cells":
+ const: 0
+
+ patternProperties:
+ '^oldi@[0-1]$':
+ type: object
+ $ref: ti,am625-oldi.yaml#
+ unevaluatedProperties: false
+ description: OLDI transmitters connected to the DSS VPs
+
allOf:
- if:
properties:
@@ -123,6 +161,19 @@ allOf:
ports:
properties:
port@0: false
+ oldi-transmitters: false
+
+ - if:
+ properties:
+ compatible:
+ contains:
+ const: ti,am65x-dss
+ then:
+ properties:
+ oldi-transmitters: false
+ port@0:
+ properties:
+ endpoint@1: false
required:
- compatible
@@ -171,3 +222,105 @@ examples:
};
};
};
+
+ - |
+ #include <dt-bindings/interrupt-controller/arm-gic.h>
+ #include <dt-bindings/interrupt-controller/irq.h>
+ #include <dt-bindings/soc/ti,sci_pm_domain.h>
+
+ bus {
+ #address-cells = <2>;
+ #size-cells = <2>;
+ dss1: dss@30200000 {
+ compatible = "ti,am625-dss";
+ reg = <0x00 0x30200000 0x00 0x1000>, /* common */
+ <0x00 0x30202000 0x00 0x1000>, /* vidl1 */
+ <0x00 0x30206000 0x00 0x1000>, /* vid */
+ <0x00 0x30207000 0x00 0x1000>, /* ovr1 */
+ <0x00 0x30208000 0x00 0x1000>, /* ovr2 */
+ <0x00 0x3020a000 0x00 0x1000>, /* vp1 */
+ <0x00 0x3020b000 0x00 0x1000>, /* vp2 */
+ <0x00 0x30201000 0x00 0x1000>; /* common1 */
+ reg-names = "common", "vidl1", "vid",
+ "ovr1", "ovr2", "vp1", "vp2", "common1";
+ power-domains = <&k3_pds 186 TI_SCI_PD_EXCLUSIVE>;
+ clocks = <&k3_clks 186 6>,
+ <&vp1_clock>,
+ <&k3_clks 186 2>;
+ clock-names = "fck", "vp1", "vp2";
+ interrupts = <GIC_SPI 84 IRQ_TYPE_LEVEL_HIGH>;
+ oldi-transmitters {
+ #address-cells = <1>;
+ #size-cells = <0>;
+ oldi0: oldi@0 {
+ reg = <0>;
+ clocks = <&k3_clks 186 0>;
+ clock-names = "serial";
+ ti,companion-oldi = <&oldi1>;
+ ti,oldi-io-ctrl = <&dss_oldi_io_ctrl>;
+ ports {
+ #address-cells = <1>;
+ #size-cells = <0>;
+ port@0 {
+ reg = <0>;
+ oldi0_in: endpoint {
+ remote-endpoint = <&dpi0_out0>;
+ };
+ };
+ port@1 {
+ reg = <1>;
+ oldi0_out: endpoint {
+ remote-endpoint = <&panel_in0>;
+ };
+ };
+ };
+ };
+ oldi1: oldi@1 {
+ reg = <1>;
+ clocks = <&k3_clks 186 0>;
+ clock-names = "serial";
+ ti,secondary-oldi;
+ ti,oldi-io-ctrl = <&dss_oldi_io_ctrl>;
+ ports {
+ #address-cells = <1>;
+ #size-cells = <0>;
+ port@0 {
+ reg = <0>;
+ oldi1_in: endpoint {
+ remote-endpoint = <&dpi0_out1>;
+ };
+ };
+ port@1 {
+ reg = <1>;
+ oldi1_out: endpoint {
+ remote-endpoint = <&panel_in1>;
+ };
+ };
+ };
+ };
+ };
+ ports {
+ #address-cells = <1>;
+ #size-cells = <0>;
+ port@0 {
+ #address-cells = <1>;
+ #size-cells = <0>;
+ reg = <0>;
+ dpi0_out0: endpoint@0 {
+ reg = <0>;
+ remote-endpoint = <&oldi0_in>;
+ };
+ dpi0_out1: endpoint@1 {
+ reg = <1>;
+ remote-endpoint = <&oldi1_in>;
+ };
+ };
+ port@1 {
+ reg = <1>;
+ dpi1_out: endpoint {
+ remote-endpoint = <&hdmi_bridge>;
+ };
+ };
+ };
+ };
+ };
@@ -7817,6 +7817,7 @@ M: Tomi Valkeinen <tomi.valkeinen@ideasonboard.com>
L: dri-devel@lists.freedesktop.org
S: Maintained
T: git https://gitlab.freedesktop.org/drm/misc/kernel.git
+F: Documentation/devicetree/bindings/display/ti/ti,am625-oldi.yaml
F: Documentation/devicetree/bindings/display/ti/ti,am65x-dss.yaml
F: Documentation/devicetree/bindings/display/ti/ti,j721e-dss.yaml
F: Documentation/devicetree/bindings/display/ti/ti,k2g-dss.yaml