@@ -252,6 +252,32 @@ temperature-sensor@1c {
reg = <0x1c>;
};
+ ptn5110: usb-typec@50 {
+ compatible = "nxp,ptn5110", "tcpci";
+ reg = <0x50>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&pinctrl_typec>;
+ interrupt-parent = <&gpio1>;
+ interrupts = <2 IRQ_TYPE_EDGE_FALLING>;
+
+ connector {
+ compatible = "usb-c-connector";
+ label = "X17";
+ power-role = "dual";
+ data-role = "dual";
+ try-power-role = "sink";
+ typec-power-opmode = "default";
+ pd-disable;
+ self-powered;
+
+ port {
+ typec_con_hs: endpoint {
+ remote-endpoint = <&typec_hs>;
+ };
+ };
+ };
+ };
+
eeprom2: eeprom@54 {
compatible = "nxp,se97b", "atmel,24c02";
reg = <0x54>;
@@ -433,6 +459,41 @@ &tpm5 {
pinctrl-0 = <&pinctrl_tpm5>;
};
+&usbotg1 {
+ dr_mode = "otg";
+ hnp-disable;
+ srp-disable;
+ adp-disable;
+ usb-role-switch;
+ disable-over-current;
+ samsung,picophy-pre-emp-curr-control = <3>;
+ samsung,picophy-dc-vol-level-adjust = <7>;
+ status = "okay";
+
+ port {
+ typec_hs: endpoint {
+ remote-endpoint = <&typec_con_hs>;
+ };
+ };
+};
+
+&usbotg2 {
+ dr_mode = "host";
+ #address-cells = <1>;
+ #size-cells = <0>;
+ disable-over-current;
+ samsung,picophy-pre-emp-curr-control = <3>;
+ samsung,picophy-dc-vol-level-adjust = <7>;
+ status = "okay";
+
+ hub_2_0: hub@1 {
+ compatible = "usb424,2517";
+ reg = <1>;
+ reset-gpios = <&expander1 2 GPIO_ACTIVE_LOW>;
+ vdd-supply = <®_3v3>;
+ };
+};
+
&usdhc2 {
pinctrl-names = "default", "state_100mhz", "state_200mhz";
pinctrl-0 = <&pinctrl_usdhc2_hs>, <&pinctrl_usdhc2_gpio>;
This adds support for both USB host and USB Type-C ports. This includes the on-board USB hub. Signed-off-by: Alexander Stein <alexander.stein@ew.tq-group.com> --- .../freescale/imx93-tqma9352-mba93xxla.dts | 61 +++++++++++++++++++ 1 file changed, 61 insertions(+)