@@ -1011,10 +1011,15 @@ static void enetc_get_offloads(struct enetc_bdr *rx_ring,
/* TODO: hashing */
if (rx_ring->ndev->features & NETIF_F_RXCSUM) {
- u16 inet_csum = le16_to_cpu(rxbd->r.inet_csum);
-
- skb->csum = csum_unfold((__force __sum16)~htons(inet_csum));
- skb->ip_summed = CHECKSUM_COMPLETE;
+ if (priv->active_offloads & ENETC_F_RXCSUM &&
+ le16_to_cpu(rxbd->r.flags) & ENETC_RXBD_FLAG_L4_CSUM_OK) {
+ skb->ip_summed = CHECKSUM_UNNECESSARY;
+ } else {
+ u16 inet_csum = le16_to_cpu(rxbd->r.inet_csum);
+
+ skb->csum = csum_unfold((__force __sum16)~htons(inet_csum));
+ skb->ip_summed = CHECKSUM_COMPLETE;
+ }
}
if (le16_to_cpu(rxbd->r.flags) & ENETC_RXBD_FLAG_VLAN) {
@@ -3281,6 +3286,7 @@ static const struct enetc_drvdata enetc_pf_data = {
static const struct enetc_drvdata enetc4_pf_data = {
.sysclk_freq = ENETC_CLK_333M,
.pmac_offset = ENETC4_PMAC_OFFSET,
+ .rx_csum = 1,
.eth_ops = &enetc4_pf_ethtool_ops,
};
@@ -234,6 +234,7 @@ enum enetc_errata {
struct enetc_drvdata {
u32 pmac_offset; /* Only valid for PSI which supports 802.1Qbu */
+ u8 rx_csum:1;
u64 sysclk_freq;
const struct ethtool_ops *eth_ops;
};
@@ -341,6 +342,7 @@ enum enetc_active_offloads {
ENETC_F_QBV = BIT(9),
ENETC_F_QCI = BIT(10),
ENETC_F_QBU = BIT(11),
+ ENETC_F_RXCSUM = BIT(12),
};
enum enetc_flags_bit {
@@ -645,6 +645,8 @@ union enetc_rx_bd {
#define ENETC_RXBD_LSTATUS(flags) ((flags) << 16)
#define ENETC_RXBD_FLAG_VLAN BIT(9)
#define ENETC_RXBD_FLAG_TSTMP BIT(10)
+/* UDP and TCP checksum offload, for ENETC 4.1 and later */
+#define ENETC_RXBD_FLAG_L4_CSUM_OK BIT(12)
#define ENETC_RXBD_FLAG_TPID GENMASK(1, 0)
#define ENETC_MAC_ADDR_FILT_CNT 8 /* # of supported entries per port */
@@ -119,6 +119,9 @@ void enetc_pf_netdev_setup(struct enetc_si *si, struct net_device *ndev,
ndev->priv_flags |= IFF_UNICAST_FLT;
+ if (si->drvdata->rx_csum)
+ priv->active_offloads |= ENETC_F_RXCSUM;
+
/* TODO: currently, i.MX95 ENETC driver does not support advanced features */
if (!is_enetc_rev1(si)) {
ndev->hw_features &= ~(NETIF_F_HW_VLAN_CTAG_FILTER | NETIF_F_LOOPBACK);