@@ -932,25 +932,20 @@ static int pca9450_i2c_probe(struct i2c_client *i2c)
pca9450->regmap = devm_regmap_init_i2c(i2c,
&pca9450_regmap_config);
- if (IS_ERR(pca9450->regmap)) {
- dev_err(&i2c->dev, "regmap initialization failed\n");
- return PTR_ERR(pca9450->regmap);
- }
+ if (IS_ERR(pca9450->regmap))
+ return dev_err_probe(&i2c->dev, PTR_ERR(pca9450->regmap),
+ "regmap initialization failed\n");
ret = regmap_read(pca9450->regmap, PCA9450_REG_DEV_ID, &device_id);
- if (ret) {
- dev_err(&i2c->dev, "Read device id error\n");
- return ret;
- }
+ if (ret)
+ return dev_err_probe(&i2c->dev, ret, "Read device id error\n");
/* Check your board and dts for match the right pmic */
if (((device_id >> 4) != 0x1 && type == PCA9450_TYPE_PCA9450A) ||
((device_id >> 4) != 0x3 && type == PCA9450_TYPE_PCA9450BC) ||
- ((device_id >> 4) != 0x9 && type == PCA9450_TYPE_PCA9451A)) {
- dev_err(&i2c->dev, "Device id(%x) mismatched\n",
- device_id >> 4);
- return -EINVAL;
- }
+ ((device_id >> 4) != 0x9 && type == PCA9450_TYPE_PCA9451A))
+ return dev_err_probe(&i2c->dev, -EINVAL,
+ "Device id(%x) mismatched\n", device_id >> 4);
for (i = 0; i < pca9450->rcnt; i++) {
const struct regulator_desc *desc;
@@ -964,13 +959,9 @@ static int pca9450_i2c_probe(struct i2c_client *i2c)
config.dev = pca9450->dev;
rdev = devm_regulator_register(pca9450->dev, desc, &config);
- if (IS_ERR(rdev)) {
- ret = PTR_ERR(rdev);
- dev_err(pca9450->dev,
- "Failed to register regulator(%s): %d\n",
- desc->name, ret);
- return ret;
- }
+ if (IS_ERR(rdev))
+ return dev_err_probe(pca9450->dev, PTR_ERR(rdev),
+ "Failed to register regulator(%s)\n", desc->name);
}
if (pca9450->irq) {
@@ -978,29 +969,24 @@ static int pca9450_i2c_probe(struct i2c_client *i2c)
pca9450_irq_handler,
(IRQF_TRIGGER_FALLING | IRQF_ONESHOT),
"pca9450-irq", pca9450);
- if (ret != 0) {
- dev_err(pca9450->dev, "Failed to request IRQ: %d\n",
- pca9450->irq);
- return ret;
- }
+ if (ret != 0)
+ return dev_err_probe(pca9450->dev, ret, "Failed to request IRQ: %d\n",
+ pca9450->irq);
+
/* Unmask all interrupt except PWRON/WDOG/RSVD */
ret = regmap_update_bits(pca9450->regmap, PCA9450_REG_INT1_MSK,
IRQ_VR_FLT1 | IRQ_VR_FLT2 | IRQ_LOWVSYS |
IRQ_THERM_105 | IRQ_THERM_125,
IRQ_PWRON | IRQ_WDOGB | IRQ_RSVD);
- if (ret) {
- dev_err(&i2c->dev, "Unmask irq error\n");
- return ret;
- }
+ if (ret)
+ return dev_err_probe(&i2c->dev, ret, "Unmask irq error\n");
}
/* Clear PRESET_EN bit in BUCK123_DVS to use DVS registers */
ret = regmap_clear_bits(pca9450->regmap, PCA9450_REG_BUCK123_DVS,
BUCK123_PRESET_EN);
- if (ret) {
- dev_err(&i2c->dev, "Failed to clear PRESET_EN bit: %d\n", ret);
- return ret;
- }
+ if (ret)
+ return dev_err_probe(&i2c->dev, ret, "Failed to clear PRESET_EN bit\n");
if (of_property_read_bool(i2c->dev.of_node, "nxp,wdog_b-warm-reset"))
reset_ctrl = WDOG_B_CFG_WARM;
@@ -1010,20 +996,16 @@ static int pca9450_i2c_probe(struct i2c_client *i2c)
/* Set reset behavior on assertion of WDOG_B signal */
ret = regmap_update_bits(pca9450->regmap, PCA9450_REG_RESET_CTRL,
WDOG_B_CFG_MASK, reset_ctrl);
- if (ret) {
- dev_err(&i2c->dev, "Failed to set WDOG_B reset behavior\n");
- return ret;
- }
+ if (ret)
+ return dev_err_probe(&i2c->dev, ret, "Failed to set WDOG_B reset behavior\n");
if (of_property_read_bool(i2c->dev.of_node, "nxp,i2c-lt-enable")) {
/* Enable I2C Level Translator */
ret = regmap_update_bits(pca9450->regmap, PCA9450_REG_CONFIG2,
I2C_LT_MASK, I2C_LT_ON_STANDBY_RUN);
- if (ret) {
- dev_err(&i2c->dev,
- "Failed to enable I2C level translator\n");
- return ret;
- }
+ if (ret)
+ return dev_err_probe(&i2c->dev, ret,
+ "Failed to enable I2C level translator\n");
}
/*
@@ -1033,10 +1015,9 @@ static int pca9450_i2c_probe(struct i2c_client *i2c)
*/
pca9450->sd_vsel_gpio = gpiod_get_optional(pca9450->dev, "sd-vsel", GPIOD_OUT_HIGH);
- if (IS_ERR(pca9450->sd_vsel_gpio)) {
- dev_err(&i2c->dev, "Failed to get SD_VSEL GPIO\n");
- return PTR_ERR(pca9450->sd_vsel_gpio);
- }
+ if (IS_ERR(pca9450->sd_vsel_gpio))
+ return dev_err_probe(&i2c->dev, PTR_ERR(pca9450->sd_vsel_gpio),
+ "Failed to get SD_VSEL GPIO\n");
dev_info(&i2c->dev, "%s probed.\n",
type == PCA9450_TYPE_PCA9450A ? "pca9450a" :
Use dev_err_probe() to simplify code. Signed-off-by: Frank Li <Frank.Li@nxp.com> --- drivers/regulator/pca9450-regulator.c | 73 +++++++++++++---------------------- 1 file changed, 27 insertions(+), 46 deletions(-)