[7/9] drm/i915: Check pixel clock when setting mode for CRT

Commit Message

Mika Kahola July 3, 2015, 11:35 a.m. UTC

It is possible the we request to have a mode that has
higher pixel clock than our HW can support. This patch
checks if requested pixel clock is lower than the one
supported by the HW. The requested mode is discarded
if we cannot support the requested pixel clock.

This patch applies to CRT.

Signed-off-by: Mika Kahola <[e-mail]>
---
 drivers/gpu/drm/i915/intel_crt.c | 24 +++++++++++++++++++++++-
 1 file changed, 23 insertions(+), 1 deletion(-)

Patch

diff --git a/drivers/gpu/drm/i915/intel_crt.c b/drivers/gpu/drm/i915/intel_crt.c
index 521af2c..0980f32 100644
--- a/drivers/gpu/drm/i915/intel_crt.c
+++ b/drivers/gpu/drm/i915/intel_crt.c
@@ -283,13 +283,32 @@  static void intel_crt_dpms(struct drm_connector *connector, int mode)
 	intel_modeset_check_state(connector->dev);
 }
 
+static int
+intel_crt_max_pixclk(struct intel_crt *intel_crt)
+{
+	struct drm_device *dev = intel_crt->base.base.dev;
+	struct drm_i915_private *dev_priv = to_i915(dev);
+	struct intel_crtc *intel_crtc = to_intel_crtc(intel_crt->base.base.crtc);
+
+	if (IS_CHERRYVIEW(dev))
+		return  DIV_ROUND_UP(dev_priv->max_cdclk_freq * 100, 95);
+	else if (IS_VALLEYVIEW(dev))
+		return  DIV_ROUND_UP(dev_priv->max_cdclk_freq * 100, 90);
+	else if (IS_BROADWELL(dev) && intel_crtc->config->ips_enabled)
+		return  DIV_ROUND_UP(dev_priv->max_cdclk_freq * 100, 95);
+	else
+		return dev_priv->max_cdclk_freq;
+}
+
 static enum drm_mode_status
 intel_crt_mode_valid(struct drm_connector *connector,
 		     struct drm_display_mode *mode)
 {
 	struct drm_device *dev = connector->dev;
-
+	struct intel_crt *intel_crt = intel_attached_crt(connector);
+	int max_pixclk = intel_crt_max_pixclk(intel_crt);
 	int max_clock = 0;
+
 	if (mode->flags & DRM_MODE_FLAG_DBLSCAN)
 		return MODE_NO_DBLESCAN;
 
@@ -303,6 +322,9 @@  intel_crt_mode_valid(struct drm_connector *connector,
 	if (mode->clock > max_clock)
 		return MODE_CLOCK_HIGH;
 
+	if (mode->clock > max_pixclk)
+		return MODE_CLOCK_HIGH;
+
 	/* The FDI receiver on LPT only supports 8bpc and only has 2 lanes. */
 	if (HAS_PCH_LPT(dev) &&
 	    (ironlake_get_lanes_required(mode->clock, 270000, 24) > 2))