@@ -713,7 +713,7 @@ static int intel_crt_set_property(struct drm_connector *connector,
return 0;
}
-static void intel_crt_reset(struct drm_encoder *encoder)
+void intel_crt_reset(struct drm_encoder *encoder)
{
struct drm_device *dev = encoder->dev;
struct drm_i915_private *dev_priv = dev->dev_private;
@@ -1075,7 +1075,7 @@ void gen8_irq_power_well_pre_disable(struct drm_i915_private *dev_priv,
/* intel_crt.c */
void intel_crt_init(struct drm_device *dev);
-
+void intel_crt_reset(struct drm_encoder *encoder);
/* intel_ddi.c */
void intel_ddi_clk_select(struct intel_encoder *encoder,
@@ -1065,6 +1065,7 @@ static void vlv_init_display_clock_gating(struct drm_i915_private *dev_priv)
static void vlv_display_power_well_init(struct drm_i915_private *dev_priv)
{
+ struct intel_encoder *encoder;
enum pipe pipe;
/*
@@ -1100,6 +1101,12 @@ static void vlv_display_power_well_init(struct drm_i915_private *dev_priv)
intel_hpd_init(dev_priv);
+ /* Re-enable the ADPA, if we have one */
+ for_each_intel_encoder(dev_priv->dev, encoder) {
+ if (encoder->type == INTEL_OUTPUT_ANALOG)
+ intel_crt_reset(&encoder->base);
+ }
+
i915_redisable_vga_power_on(dev_priv->dev);
}
While VGA hotplugging worked(ish) before, it looks like that was mainly because we'd unintentionally enable it in valleyview_crt_detect_hotplug() when we did a force trigger. This doesn't work reliably enough because whenever the display powerwell on vlv gets disabled, the values set in VLV_ADPA get cleared and consequently VGA hotplugging gets disabled. This causes bugs such as one we found on an Intel NUC, where doing the following sequence of hotplugs: - Disconnect all monitors - Connect VGA - Disconnect VGA - Connect HDMI Would result in VGA hotplugging becoming disabled, due to the powerwells getting toggled in the process of connecting HDMI. Changes since v3: - Expose intel_crt_reset() through intel_drv.h and call that in vlv_display_power_well_init() instead of encoder->base.funcs->reset(&encoder->base); Changes since v2: - Use intel_encoder structs instead of drm_encoder structs Changes since v1: - Instead of handling the register writes ourself, we just reuse intel_crt_detect() - Instead of resetting the ADPA during display IRQ installation, we now reset them in vlv_display_power_well_init() Cc: stable@vger.kernel.org Acked-by: Daniel Vetter <daniel.vetter@ffwll.ch> Signed-off-by: Lyude <cpaul@redhat.com> Reviewed-by: Ville Syrjälä <ville.syrjala@linux.intel.com> --- drivers/gpu/drm/i915/intel_crt.c | 2 +- drivers/gpu/drm/i915/intel_drv.h | 2 +- drivers/gpu/drm/i915/intel_runtime_pm.c | 7 +++++++ 3 files changed, 9 insertions(+), 2 deletions(-)