@@ -616,8 +616,10 @@ intel_dp_mode_valid(struct drm_connector *connector,
{
struct intel_dp *intel_dp = intel_attached_dp(connector);
struct intel_connector *intel_connector = to_intel_connector(connector);
+ struct intel_encoder *intel_encoder = intel_attached_encoder(connector);
struct drm_display_mode *fixed_mode = intel_connector->panel.fixed_mode;
struct drm_i915_private *dev_priv = to_i915(connector->dev);
+ struct intel_lspcon *lspcon = enc_to_intel_lspcon(&intel_encoder->base);
int target_clock = mode->clock;
int max_rate, mode_rate, max_lanes, max_link_clock;
int max_dotclk;
@@ -639,6 +641,21 @@ intel_dp_mode_valid(struct drm_connector *connector,
target_clock = fixed_mode->clock;
}
+ /*
+ * Reducing Blanking to incorporate DP and HDMI timing/link bandwidth
+ * limitations for CEA modes (4k@60 at 10 bpp). DP can drive 17.28Gbs
+ * while 4k modes (VIC97 etc) at 10 bpp required 17.8 Gbps. This will
+ * cause mode to blank out. Reduced Htotal by shortening the back porch
+ * and front porch within permissible limits.
+ */
+ if (lspcon->active && lspcon->hdr_supported &&
+ mode->clock > 570000) {
+ mode->clock = 570000;
+ mode->htotal -= 180;
+ mode->hsync_start -= 72;
+ mode->hsync_end -= 72;
+ }
+
max_link_clock = intel_dp_max_link_rate(intel_dp);
max_lanes = intel_dp_max_lane_count(intel_dp);
Blanking needs to be reduced to incorporate DP and HDMI timing/link bandwidth limitations for CEA modes (4k@60 at 10 bpp). DP can drive 17.28Gbs while 4k modes (VIC97 etc) at 10 bpp required 17.8 Gbps. This will cause mode to blank out. Reduced Htotal by shortening the back porch and front porch within permissible limits. v2: This is marked as Not for merge and the responsibilty to program these custom timings will be on userspace. This patch is just for reference purposes. This is based on Ville's recommendation. Signed-off-by: Uma Shankar <uma.shankar@intel.com> --- drivers/gpu/drm/i915/display/intel_dp.c | 17 +++++++++++++++++ 1 file changed, 17 insertions(+)