diff mbox series

[10/14] drm/i915/dp: Check min bpc DSC limits for dsc_force_bpc also

Message ID 20230524142210.3779331-11-ankit.k.nautiyal@intel.com (mailing list archive)
State New, archived
Headers show
Series DSC misc fixes | expand

Commit Message

Nautiyal, Ankit K May 24, 2023, 2:22 p.m. UTC
For DSC the min BPC is 8 for ICL+ and so the min pipe_bpp is 24.
Check this condition for cases where bpc is forced by debugfs flag
dsc_force_bpc. If the check fails, then WARN and ignore the debugfs
flag.

For MST case the pipe_bpp is already computed (hardcoded to be 24),
and this check is not required.

Signed-off-by: Ankit Nautiyal <ankit.k.nautiyal@intel.com>
---
 drivers/gpu/drm/i915/display/intel_dp.c | 48 ++++++++++++++++---------
 1 file changed, 31 insertions(+), 17 deletions(-)
diff mbox series

Patch

diff --git a/drivers/gpu/drm/i915/display/intel_dp.c b/drivers/gpu/drm/i915/display/intel_dp.c
index c060e6cb042e..9d5da49f1180 100644
--- a/drivers/gpu/drm/i915/display/intel_dp.c
+++ b/drivers/gpu/drm/i915/display/intel_dp.c
@@ -1647,6 +1647,13 @@  static bool intel_dp_dsc_supports_format(struct intel_dp *intel_dp,
 	return drm_dp_dsc_sink_supports_format(intel_dp->dsc_dpcd, sink_dsc_format);
 }
 
+static
+bool is_dsc_pipe_bpp_sufficient(int pipe_bpp)
+{
+	/* Min Input BPC for ICL+ is 8 */
+	return (pipe_bpp < 8 * 3);
+}
+
 int intel_dp_dsc_compute_config(struct intel_dp *intel_dp,
 				struct intel_crtc_state *pipe_config,
 				struct drm_connector_state *conn_state,
@@ -1658,7 +1665,6 @@  int intel_dp_dsc_compute_config(struct intel_dp *intel_dp,
 	struct drm_i915_private *dev_priv = to_i915(dig_port->base.base.dev);
 	const struct drm_display_mode *adjusted_mode =
 		&pipe_config->hw.adjusted_mode;
-	int pipe_bpp;
 	int ret;
 
 	pipe_config->fec_enable = !intel_dp_is_edp(intel_dp) &&
@@ -1670,28 +1676,36 @@  int intel_dp_dsc_compute_config(struct intel_dp *intel_dp,
 	if (!intel_dp_dsc_supports_format(intel_dp, pipe_config->output_format))
 		return -EINVAL;
 
-	if (intel_dp->force_dsc_bpc && compute_pipe_bpp) {
-		pipe_bpp = intel_dp->force_dsc_bpc * 3;
-		drm_dbg_kms(&dev_priv->drm, "Input DSC BPP forced to %d\n", pipe_bpp);
-	} else if (compute_pipe_bpp) {
-		pipe_bpp = intel_dp_dsc_compute_bpp(intel_dp, conn_state->max_requested_bpc);
-	} else {
-		pipe_bpp = pipe_config->pipe_bpp;
-	}
+	if (compute_pipe_bpp) {
+		int pipe_bpp;
+		int forced_bpp = intel_dp->force_dsc_bpc * 3;
 
-	/* Min Input BPC for ICL+ is 8 */
-	if (pipe_bpp < 8 * 3) {
-		drm_dbg_kms(&dev_priv->drm,
-			    "No DSC support for less than 8bpc\n");
-		return -EINVAL;
+		if (forced_bpp && is_dsc_pipe_bpp_sufficient(forced_bpp)) {
+			pipe_bpp = forced_bpp;
+			drm_dbg_kms(&dev_priv->drm, "Input DSC BPP forced to %d\n", pipe_bpp);
+		} else {
+			drm_WARN(&dev_priv->drm,
+				 forced_bpp && !is_dsc_pipe_bpp_sufficient(forced_bpp),
+				 "Cannot force dsc bpc:%d, due to dsc bpc limits\n",
+				 intel_dp->force_dsc_bpc);
+
+			pipe_bpp = intel_dp_dsc_compute_bpp(intel_dp,
+							    conn_state->max_requested_bpc);
+
+			if (!is_dsc_pipe_bpp_sufficient(pipe_bpp)) {
+				drm_dbg_kms(&dev_priv->drm, "No DSC support for less than 8bpc\n");
+				return -EINVAL;
+			}
+		}
+
+		pipe_config->pipe_bpp = pipe_bpp;
 	}
 
 	/*
-	 * For now enable DSC for max bpp, max link rate, max lane count.
+	 * For now enable DSC for max link rate, max lane count.
 	 * Optimize this later for the minimum possible link rate/lane count
 	 * with DSC enabled for the requested mode.
 	 */
-	pipe_config->pipe_bpp = pipe_bpp;
 	pipe_config->port_clock = limits->max_rate;
 	pipe_config->lane_count = limits->max_lane_count;
 
@@ -1720,7 +1734,7 @@  int intel_dp_dsc_compute_config(struct intel_dp *intel_dp,
 								    adjusted_mode->crtc_hdisplay,
 								    pipe_config->bigjoiner_pipes,
 								    pipe_config->output_format,
-								    pipe_bpp,
+								    pipe_config->pipe_bpp,
 								    timeslots);
 			/*
 			 * According to DSC 1.2a Section 4.1.1 Table 4.1 the maximum