@@ -40,6 +40,15 @@ struct i915_params i915_modparams __read_mostly = {
#undef MEMBER
};
+/*
+ * Note: As a rule, keep module parameter sysfs permissions read-only
+ * 0400. Runtime changes are only supported through i915 debugfs.
+ *
+ * For any exceptions requiring write access and runtime changes through module
+ * parameter sysfs, prevent debugfs file creation by setting the parameter's
+ * debugfs mode to 0.
+ */
+
i915_param_named(modeset, int, 0400,
"Use kernel modesetting [KMS] (0=disable, "
"1=on, -1=force vga console preference [default])");
@@ -48,7 +57,7 @@ i915_param_named_unsafe(enable_dc, int, 0400,
"Enable power-saving display C-states. "
"(-1=auto [default]; 0=disable; 1=up to DC5; 2=up to DC6)");
-i915_param_named_unsafe(enable_fbc, int, 0600,
+i915_param_named_unsafe(enable_fbc, int, 0400,
"Enable frame buffer compression for power savings "
"(default: -1 (use per-chip default))");
@@ -56,7 +65,7 @@ i915_param_named_unsafe(lvds_channel_mode, int, 0400,
"Specify LVDS channel mode "
"(0=probe BIOS [default], 1=single-channel, 2=dual-channel)");
-i915_param_named_unsafe(panel_use_ssc, int, 0600,
+i915_param_named_unsafe(panel_use_ssc, int, 0400,
"Use Spread Spectrum Clock with panels [LVDS/eDP] "
"(default: auto from VBT)");
@@ -64,25 +73,25 @@ i915_param_named_unsafe(vbt_sdvo_panel_type, int, 0400,
"Override/Ignore selection of SDVO panel mode in the VBT "
"(-2=ignore, -1=auto [default], index in VBT BIOS table)");
-i915_param_named_unsafe(reset, int, 0600,
+i915_param_named_unsafe(reset, int, 0400,
"Attempt GPU resets (0=disabled, 1=full gpu reset, 2=engine reset [default])");
i915_param_named_unsafe(vbt_firmware, charp, 0400,
"Load VBT from specified file under /lib/firmware");
#if IS_ENABLED(CONFIG_DRM_I915_CAPTURE_ERROR)
-i915_param_named(error_capture, bool, 0600,
+i915_param_named(error_capture, bool, 0400,
"Record the GPU state following a hang. "
"This information in /sys/class/drm/card<N>/error is vital for "
"triaging and debugging hangs.");
#endif
-i915_param_named_unsafe(enable_hangcheck, bool, 0600,
+i915_param_named_unsafe(enable_hangcheck, bool, 0400,
"Periodically check GPU activity for detecting hangs. "
"WARNING: Disabling this can cause system wide hangs. "
"(default: true)");
-i915_param_named_unsafe(enable_psr, int, 0600,
+i915_param_named_unsafe(enable_psr, int, 0400,
"Enable PSR "
"(0=disabled, 1=enabled) "
"Default: -1 (use per-chip default)");
@@ -95,24 +104,24 @@ i915_param_named_unsafe(disable_power_well, int, 0400,
"Disable display power wells when possible "
"(-1=auto [default], 0=power wells always on, 1=power wells disabled when possible)");
-i915_param_named_unsafe(enable_ips, int, 0600, "Enable IPS (default: true)");
+i915_param_named_unsafe(enable_ips, int, 0400, "Enable IPS (default: true)");
-i915_param_named(fastboot, bool, 0600,
+i915_param_named(fastboot, bool, 0400,
"Try to skip unnecessary mode sets at boot time (default: false)");
-i915_param_named_unsafe(prefault_disable, bool, 0600,
+i915_param_named_unsafe(prefault_disable, bool, 0400,
"Disable page prefaulting for pread/pwrite/reloc (default:false). "
"For developers only.");
-i915_param_named_unsafe(load_detect_test, bool, 0600,
+i915_param_named_unsafe(load_detect_test, bool, 0400,
"Force-enable the VGA load detect code for testing (default:false). "
"For developers only.");
-i915_param_named_unsafe(force_reset_modeset_test, bool, 0600,
+i915_param_named_unsafe(force_reset_modeset_test, bool, 0400,
"Force a modeset during gpu reset for testing (default:false). "
"For developers only.");
-i915_param_named_unsafe(invert_brightness, int, 0600,
+i915_param_named_unsafe(invert_brightness, int, 0400,
"Invert backlight brightness "
"(-1 force normal, 0 machine defaults, 1 force inversion), please "
"report PCI device ID, subsystem vendor and subsystem device ID "
@@ -122,10 +131,11 @@ i915_param_named_unsafe(invert_brightness, int, 0600,
i915_param_named(disable_display, bool, 0400,
"Disable display (default: false)");
-i915_param_named(mmio_debug, int, 0600,
+i915_param_named(mmio_debug, int, 0400,
"Enable the MMIO debug code for the first N failures (default: off). "
"This may negatively affect performance.");
+/* Special case writable file */
i915_param_named(verbose_state_checks, bool, 0600,
"Enable verbose logs (ie. WARN_ON()) in case of unexpected hw state conditions.");
@@ -156,10 +166,10 @@ i915_param_named_unsafe(huc_firmware_path, charp, 0400,
i915_param_named_unsafe(dmc_firmware_path, charp, 0400,
"DMC firmware path to use instead of the default one");
-i915_param_named_unsafe(enable_dp_mst, bool, 0600,
+i915_param_named_unsafe(enable_dp_mst, bool, 0400,
"Enable multi-stream transport (MST) for new DisplayPort sinks. (default: true)");
-i915_param_named(enable_dpcd_backlight, bool, 0600,
+i915_param_named(enable_dpcd_backlight, bool, 0400,
"Enable support for DPCD backlight control (default:false)");
#if IS_ENABLED(CONFIG_DRM_I915_GVT)
Only support runtime changes through the debugfs. i915.verbose_state_checks remains an exception, and is not exposed via debugfs. FIXME: Before this gets applied, IGT needs to be changed to use the debugfs for modifying the parameters. IGT changes at least the following through module parameter sysfs: * enable_fbc * reset * enable_hangcheck * enable_psr * fastboot * prefault_disable * load_detect_test * force_reset_modeset_test Signed-off-by: Jani Nikula <jani.nikula@intel.com> --- drivers/gpu/drm/i915/i915_params.c | 40 ++++++++++++++++++++++++-------------- 1 file changed, 25 insertions(+), 15 deletions(-)