@@ -1382,17 +1382,16 @@ static int ironlake_drpc_info(struct seq_file *m)
intel_runtime_pm_put(dev_priv);
mutex_unlock(&dev->struct_mutex);
- seq_printf(m, "HD boost: %s\n", (rgvmodectl & MEMMODE_BOOST_EN) ?
- "yes" : "no");
+ seq_printf(m, "HD boost: %s\n", yesno(rgvmodectl & MEMMODE_BOOST_EN));
seq_printf(m, "Boost freq: %d\n",
(rgvmodectl & MEMMODE_BOOST_FREQ_MASK) >>
MEMMODE_BOOST_FREQ_SHIFT);
seq_printf(m, "HW control enabled: %s\n",
- rgvmodectl & MEMMODE_HWIDLE_EN ? "yes" : "no");
+ yesno(rgvmodectl & MEMMODE_HWIDLE_EN));
seq_printf(m, "SW control enabled: %s\n",
- rgvmodectl & MEMMODE_SWMODE_EN ? "yes" : "no");
+ yesno(rgvmodectl & MEMMODE_SWMODE_EN));
seq_printf(m, "Gated voltage change: %s\n",
- rgvmodectl & MEMMODE_RCLK_GATE ? "yes" : "no");
+ yesno(rgvmodectl & MEMMODE_RCLK_GATE));
seq_printf(m, "Starting frequency: P%d\n",
(rgvmodectl & MEMMODE_FSTART_MASK) >> MEMMODE_FSTART_SHIFT);
seq_printf(m, "Max P-state: P%d\n",
@@ -1401,7 +1400,7 @@ static int ironlake_drpc_info(struct seq_file *m)
seq_printf(m, "RS1 VID: %d\n", (crstandvid & 0x3f));
seq_printf(m, "RS2 VID: %d\n", ((crstandvid >> 8) & 0x3f));
seq_printf(m, "Render standby enabled: %s\n",
- (rstdbyctl & RCX_SW_EXIT) ? "no" : "yes");
+ yesno(!(rstdbyctl & RCX_SW_EXIT)));
seq_puts(m, "Current RS state: ");
switch (rstdbyctl & RSX_STATUS_MASK) {
case RSX_STATUS_ON:
@@ -2842,8 +2841,7 @@ static void intel_dp_info(struct seq_file *m,
struct intel_dp *intel_dp = enc_to_intel_dp(&intel_encoder->base);
seq_printf(m, "\tDPCD rev: %x\n", intel_dp->dpcd[DP_DPCD_REV]);
- seq_printf(m, "\taudio support: %s\n", intel_dp->has_audio ? "yes" :
- "no");
+ seq_printf(m, "\taudio support: %s\n", yesno(intel_dp->has_audio));
if (intel_encoder->type == INTEL_OUTPUT_EDP)
intel_panel_info(m, &intel_connector->panel);
}
@@ -2854,8 +2852,7 @@ static void intel_hdmi_info(struct seq_file *m,
struct intel_encoder *intel_encoder = intel_connector->encoder;
struct intel_hdmi *intel_hdmi = enc_to_intel_hdmi(&intel_encoder->base);
- seq_printf(m, "\taudio support: %s\n", intel_hdmi->has_audio ? "yes" :
- "no");
+ seq_printf(m, "\taudio support: %s\n", yesno(intel_hdmi->has_audio));
}
static void intel_lvds_info(struct seq_file *m,
@@ -4050,8 +4050,8 @@ intel_dp_get_dpcd(struct intel_dp *intel_dp)
}
DRM_DEBUG_KMS("Display Port TPS3 support: source %s, sink %s\n",
- intel_dp_source_supports_hbr2(dev) ? "yes" : "no",
- intel_dp_tps3_supported(intel_dp->dpcd) ? "yes" : "no");
+ yesno(intel_dp_source_supports_hbr2(dev)),
+ yesno(intel_dp_tps3_supported(intel_dp->dpcd)));
/* Intermediate frequency support */
if (is_edp(intel_dp) &&
@@ -5549,7 +5549,7 @@ static void cherryview_enable_rps(struct drm_device *dev)
/* RPS code assumes GPLL is used */
WARN_ONCE((val & GPLLENABLE) == 0, "GPLL not enabled\n");
- DRM_DEBUG_DRIVER("GPLL enabled? %s\n", val & GPLLENABLE ? "yes" : "no");
+ DRM_DEBUG_DRIVER("GPLL enabled? %s\n", yesno(val & GPLLENABLE));
DRM_DEBUG_DRIVER("GPU status: 0x%08x\n", val);
dev_priv->rps.cur_freq = (val >> 8) & 0xff;
@@ -5639,7 +5639,7 @@ static void valleyview_enable_rps(struct drm_device *dev)
/* RPS code assumes GPLL is used */
WARN_ONCE((val & GPLLENABLE) == 0, "GPLL not enabled\n");
- DRM_DEBUG_DRIVER("GPLL enabled? %s\n", val & GPLLENABLE ? "yes" : "no");
+ DRM_DEBUG_DRIVER("GPLL enabled? %s\n", yesno(val & GPLLENABLE));
DRM_DEBUG_DRIVER("GPU status: 0x%08x\n", val);
dev_priv->rps.cur_freq = (val >> 8) & 0xff;
Signed-off-by: Jani Nikula <jani.nikula@intel.com> --- drivers/gpu/drm/i915/i915_debugfs.c | 17 +++++++---------- drivers/gpu/drm/i915/intel_dp.c | 4 ++-- drivers/gpu/drm/i915/intel_pm.c | 4 ++-- 3 files changed, 11 insertions(+), 14 deletions(-)