diff mbox

KVM:VMX: Add support for Pause-Loop Exiting

Message ID 20090708033235.GA577@edwin-srv.sh.intel.com (mailing list archive)
State New, archived
Headers show

Commit Message

Zhai, Edwin July 8, 2009, 3:32 a.m. UTC
KVM:VMX: Add support for Pause-Loop Exiting

New NHM processors will support Pause-Loop Exiting by adding 2 VM-execution
control fields:
PLE_Gap    - upper bound on the amount of time between two successive
             executions of PAUSE in a loop.
PLE_Window - upper bound on the amount of time a guest is allowed to execute in
             a PAUSE loop

If the time, between this execution of PAUSE and previous one, exceeds the
PLE_Gap, processor consider this PAUSE belongs to a new loop.
Otherwise, processor determins the the total execution time of this loop(since
1st PAUSE in this loop), and triggers a VM exit if total time exceeds the
PLE_Window.
* Refer SDM volume 3b section 21.6.13 & 22.1.3.

Pause-Loop Exiting can be used to detect Lock-Holder Preemption, where one VP
is sched-out after hold a spinlock, then other VPs for same lock are sched-in
to waste the CPU time.

Our tests indicate that most spinlocks are held for less than 2^12 cycles.
Performance tests show that with 2X LP over-commitment we can get +2% perf
improvement for kernel build(Even more perf gain with more LPs).

Signed-off-by: Zhai Edwin <edwin.zhai@intel.com>
----
include/asm/vmx.h |    4 ++++
kvm/vmx.c         |   51 ++++++++++++++++++++++++++++++++++++++++++++++++++-
2 files changed, 54 insertions(+), 1 deletion(-)

--
To unsubscribe from this list: send the line "unsubscribe kvm" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html

Comments

Avi Kivity July 8, 2009, 4:43 a.m. UTC | #1
On 07/08/2009 06:32 AM, Zhai, Edwin wrote:
>
>   /*
> + * Indicate a busy-waiting vcpu in spinlock. We do not enable the PAUSE
> + * exiting, so only get here on cpu with PAUSE-Loop-Exiting.
> + */
> +static int handle_pause(struct kvm_vcpu *vcpu,
> +				struct kvm_run *kvm_run)
> +{
> +	skip_emulated_instruction(vcpu);
> +	yield();
> +	return 1;
> +}
> +
>    

yield() does nothing in Linux.  Please look at 
http://lkml.org/lkml/2009/5/11/294 for what needs to be added to the 
scheduler (that message is part of a thread discussing the same feature 
for svm).
diff mbox

Patch

Index: linux-2.6/arch/x86/include/asm/vmx.h
===================================================================
--- linux-2.6.orig/arch/x86/include/asm/vmx.h
+++ linux-2.6/arch/x86/include/asm/vmx.h
@@ -56,6 +56,7 @@ 
 #define SECONDARY_EXEC_ENABLE_VPID              0x00000020
 #define SECONDARY_EXEC_WBINVD_EXITING		0x00000040
 #define SECONDARY_EXEC_UNRESTRICTED_GUEST	0x00000080
+#define SECONDARY_EXEC_PAUSE_LOOP_EXITING	0x00000400
 
 
 #define PIN_BASED_EXT_INTR_MASK                 0x00000001
@@ -144,6 +145,8 @@  enum vmcs_field {
 	VM_ENTRY_INSTRUCTION_LEN        = 0x0000401a,
 	TPR_THRESHOLD                   = 0x0000401c,
 	SECONDARY_VM_EXEC_CONTROL       = 0x0000401e,
+	PLE_GAP                         = 0x00004020,
+	PLE_WINDOW                      = 0x00004022,
 	VM_INSTRUCTION_ERROR            = 0x00004400,
 	VM_EXIT_REASON                  = 0x00004402,
 	VM_EXIT_INTR_INFO               = 0x00004404,
@@ -248,6 +251,7 @@  enum vmcs_field {
 #define EXIT_REASON_MSR_READ            31
 #define EXIT_REASON_MSR_WRITE           32
 #define EXIT_REASON_MWAIT_INSTRUCTION   36
+#define EXIT_REASON_PAUSE_INSTRUCTION   40
 #define EXIT_REASON_MCE_DURING_VMENTRY	 41
 #define EXIT_REASON_TPR_BELOW_THRESHOLD 43
 #define EXIT_REASON_APIC_ACCESS         44
Index: linux-2.6/arch/x86/kvm/vmx.c
===================================================================
--- linux-2.6.orig/arch/x86/kvm/vmx.c
+++ linux-2.6/arch/x86/kvm/vmx.c
@@ -61,6 +61,25 @@  module_param_named(unrestricted_guest,
 static int __read_mostly emulate_invalid_guest_state = 0;
 module_param(emulate_invalid_guest_state, bool, S_IRUGO);
 
+/*
+ * These 2 parameters are used to config the controls for Pause-Loop Exiting:
+ * ple_gap:    upper bound on the amount of time between two successive
+ *             executions of PAUSE in a loop. Also indicate if ple enabled.
+ *             According to test, this time is usually small than 41 cycles.
+ * ple_window: upper bound on the amount of time a guest is allowed to execute
+ *             in a PAUSE loop. Tests indicate that most spinlocks are held for
+ *             less than 2^12 cycles
+ * Time is measured based on a counter that runs at the same rate as the TSC,
+ * refer SDM volume 3b section 21.6.13 & 22.1.3.
+ */
+#define KVM_VMX_DEFAULT_PLE_GAP    41
+#define KVM_VMX_DEFAULT_PLE_WINDOW 4096
+static int __read_mostly ple_gap = KVM_VMX_DEFAULT_PLE_GAP;
+module_param(ple_gap, int, S_IRUGO);
+
+static int __read_mostly ple_window = KVM_VMX_DEFAULT_PLE_WINDOW;
+module_param(ple_window, int, S_IRUGO);
+
 struct vmcs {
 	u32 revision_id;
 	u32 abort;
@@ -320,6 +339,12 @@  static inline int cpu_has_vmx_unrestrict
 		SECONDARY_EXEC_UNRESTRICTED_GUEST;
 }
 
+static inline int cpu_has_vmx_ple(void)
+{
+	return vmcs_config.cpu_based_2nd_exec_ctrl &
+		SECONDARY_EXEC_PAUSE_LOOP_EXITING;
+}
+
 static inline int vm_need_virtualize_apic_accesses(struct kvm *kvm)
 {
 	return flexpriority_enabled &&
@@ -1240,7 +1265,8 @@  static __init int setup_vmcs_config(stru
 			SECONDARY_EXEC_WBINVD_EXITING |
 			SECONDARY_EXEC_ENABLE_VPID |
 			SECONDARY_EXEC_ENABLE_EPT |
-			SECONDARY_EXEC_UNRESTRICTED_GUEST;
+			SECONDARY_EXEC_UNRESTRICTED_GUEST |
+			SECONDARY_EXEC_PAUSE_LOOP_EXITING;
 		if (adjust_vmx_controls(min2, opt2,
 					MSR_IA32_VMX_PROCBASED_CTLS2,
 					&_cpu_based_2nd_exec_control) < 0)
@@ -1387,6 +1413,9 @@  static __init int hardware_setup(void)
 	if (enable_ept && !cpu_has_vmx_ept_2m_page())
 		kvm_disable_largepages();
 
+	if (!cpu_has_vmx_ple())
+		ple_gap = 0;
+
 	return alloc_kvm_area();
 }
 
@@ -2301,9 +2330,16 @@  static int vmx_vcpu_setup(struct vcpu_vm
 			exec_control &= ~SECONDARY_EXEC_ENABLE_EPT;
 		if (!enable_unrestricted_guest)
 			exec_control &= ~SECONDARY_EXEC_UNRESTRICTED_GUEST;
+		if (!ple_gap)
+			exec_control &= ~SECONDARY_EXEC_PAUSE_LOOP_EXITING;
 		vmcs_write32(SECONDARY_VM_EXEC_CONTROL, exec_control);
 	}
 
+	if (ple_gap) {
+		vmcs_write32(PLE_GAP, ple_gap);
+		vmcs_write32(PLE_WINDOW, ple_window);
+	}
+
 	vmcs_write32(PAGE_FAULT_ERROR_CODE_MASK, !!bypass_guest_pf);
 	vmcs_write32(PAGE_FAULT_ERROR_CODE_MATCH, !!bypass_guest_pf);
 	vmcs_write32(CR3_TARGET_COUNT, 0);           /* 22.2.1 */
@@ -3351,6 +3387,18 @@  static void handle_invalid_guest_state(s
 }
 
 /*
+ * Indicate a busy-waiting vcpu in spinlock. We do not enable the PAUSE
+ * exiting, so only get here on cpu with PAUSE-Loop-Exiting.
+ */
+static int handle_pause(struct kvm_vcpu *vcpu,
+				struct kvm_run *kvm_run)
+{
+	skip_emulated_instruction(vcpu);
+	yield();
+	return 1;
+}
+
+/*
  * The exit handlers return 1 if the exit was handled fully and guest execution
  * may resume.  Otherwise they set the kvm_run parameter to indicate what needs
  * to be done to userspace and return 0.
@@ -3387,6 +3435,7 @@  static int (*kvm_vmx_exit_handlers[])(st
 	[EXIT_REASON_MCE_DURING_VMENTRY]      = handle_machine_check,
 	[EXIT_REASON_EPT_VIOLATION]	      = handle_ept_violation,
 	[EXIT_REASON_EPT_MISCONFIG]           = handle_ept_misconfig,
+	[EXIT_REASON_PAUSE_INSTRUCTION]       = handle_pause,
 };
 
 static const int kvm_vmx_max_exit_handlers =