@@ -243,7 +243,7 @@ static int synic_set_msr(struct kvm_vcpu_hv_synic *synic,
struct kvm_vcpu *vcpu = hv_synic_to_vcpu(synic);
int ret;
- if (!synic->active && !host)
+ if (!synic->active && (!host || data))
return 1;
trace_kvm_hv_synic_set_msr(vcpu->vcpu_id, msr, data, host);
@@ -289,6 +289,9 @@ static int synic_set_msr(struct kvm_vcpu_hv_synic *synic,
case HV_X64_MSR_EOM: {
int i;
+ if (!synic->active)
+ break;
+
for (i = 0; i < ARRAY_SIZE(synic->sint); i++)
kvm_hv_notify_acked_sint(vcpu, i);
break;
@@ -668,7 +671,7 @@ static int stimer_set_config(struct kvm_vcpu_hv_stimer *stimer, u64 config,
struct kvm_vcpu_hv *hv_vcpu = to_hv_vcpu(vcpu);
struct kvm_vcpu_hv_synic *synic = to_hv_synic(vcpu);
- if (!synic->active && !host)
+ if (!synic->active && (!host || config))
return 1;
if (unlikely(!host && hv_vcpu->enforce_cpuid && new_config.direct_mode &&
@@ -697,7 +700,7 @@ static int stimer_set_count(struct kvm_vcpu_hv_stimer *stimer, u64 count,
struct kvm_vcpu *vcpu = hv_stimer_to_vcpu(stimer);
struct kvm_vcpu_hv_synic *synic = to_hv_synic(vcpu);
- if (!synic->active && !host)
+ if (!synic->active && (!host || count))
return 1;
trace_kvm_hv_stimer_set_count(hv_stimer_to_vcpu(stimer)->vcpu_id,
Setting non-zero values to SYNIC/STIMER MSRs activates certain features, this should not happen when KVM_CAP_HYPERV_SYNIC{,2} was not activated. Note, it would've been better to forbid writing anything to SYNIC/STIMER MSRs, including zeroes, however, at least QEMU tries clearing HV_X64_MSR_STIMER0_CONFIG without SynIC. HV_X64_MSR_EOM MSR is somewhat 'special' as writing zero there triggers an action, this also should not happen when SynIC wasn't activated. Signed-off-by: Vitaly Kuznetsov <vkuznets@redhat.com> --- arch/x86/kvm/hyperv.c | 9 ++++++--- 1 file changed, 6 insertions(+), 3 deletions(-)