| Message ID | 20090219195616.20757.42079.stgit@bob.kio (mailing list archive) |
|---|---|
| State | Accepted |
| Headers | show |
applied thanks, Len Brown, Intel Open Source Technology Center On Thu, 19 Feb 2009, Bjorn Helgaas wrote: > Remove CONFIG_ACPI_SYSTEM. It was always set the same as CONFIG_ACPI, > and it had no menu label, so there was no way to set it to anything > other than "y". > > Some things under CONFIG_ACPI_SYSTEM (acpi_irq_handled, acpi_os_gpe_count(), > event_is_open, register_acpi_notifier(), etc.) are used unconditionally > by the CA, the OSPM, and drivers, so we depend on them always being > present. > > Signed-off-by: Bjorn Helgaas <bjorn.helgaas@hp.com> > --- > drivers/acpi/Kconfig | 7 ------- > drivers/acpi/Makefile | 2 +- > 2 files changed, 1 insertions(+), 8 deletions(-) > > diff --git a/drivers/acpi/Kconfig b/drivers/acpi/Kconfig > index a7799a9..8a851d0 100644 > --- a/drivers/acpi/Kconfig > +++ b/drivers/acpi/Kconfig > @@ -254,13 +254,6 @@ config ACPI_PCI_SLOT > help you correlate PCI bus addresses with the physical geography > of your slots. If you are unsure, say N. > > -config ACPI_SYSTEM > - bool > - default y > - help > - This driver will enable your system to shut down using ACPI, and > - dump your ACPI DSDT table using /proc/acpi/dsdt. > - > config X86_PM_TIMER > bool "Power Management Timer Support" if EMBEDDED > depends on X86 > diff --git a/drivers/acpi/Makefile b/drivers/acpi/Makefile > index 65d90c7..b130ea0 100644 > --- a/drivers/acpi/Makefile > +++ b/drivers/acpi/Makefile > @@ -52,7 +52,7 @@ obj-$(CONFIG_ACPI_PROCESSOR) += processor.o > obj-$(CONFIG_ACPI_CONTAINER) += container.o > obj-$(CONFIG_ACPI_THERMAL) += thermal.o > obj-y += power.o > -obj-$(CONFIG_ACPI_SYSTEM) += system.o event.o > +obj-y += system.o event.o > obj-$(CONFIG_ACPI_DEBUG) += debug.o > obj-$(CONFIG_ACPI_NUMA) += numa.o > obj-$(CONFIG_ACPI_HOTPLUG_MEMORY) += acpi_memhotplug.o > > -- > To unsubscribe from this list: send the line "unsubscribe linux-acpi" in > the body of a message to majordomo@vger.kernel.org > More majordomo info at http://vger.kernel.org/majordomo-info.html > -- To unsubscribe from this list: send the line "unsubscribe linux-acpi" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html
diff --git a/drivers/acpi/Kconfig b/drivers/acpi/Kconfig index a7799a9..8a851d0 100644 --- a/drivers/acpi/Kconfig +++ b/drivers/acpi/Kconfig @@ -254,13 +254,6 @@ config ACPI_PCI_SLOT help you correlate PCI bus addresses with the physical geography of your slots. If you are unsure, say N. -config ACPI_SYSTEM - bool - default y - help - This driver will enable your system to shut down using ACPI, and - dump your ACPI DSDT table using /proc/acpi/dsdt. - config X86_PM_TIMER bool "Power Management Timer Support" if EMBEDDED depends on X86 diff --git a/drivers/acpi/Makefile b/drivers/acpi/Makefile index 65d90c7..b130ea0 100644 --- a/drivers/acpi/Makefile +++ b/drivers/acpi/Makefile @@ -52,7 +52,7 @@ obj-$(CONFIG_ACPI_PROCESSOR) += processor.o obj-$(CONFIG_ACPI_CONTAINER) += container.o obj-$(CONFIG_ACPI_THERMAL) += thermal.o obj-y += power.o -obj-$(CONFIG_ACPI_SYSTEM) += system.o event.o +obj-y += system.o event.o obj-$(CONFIG_ACPI_DEBUG) += debug.o obj-$(CONFIG_ACPI_NUMA) += numa.o obj-$(CONFIG_ACPI_HOTPLUG_MEMORY) += acpi_memhotplug.o
Remove CONFIG_ACPI_SYSTEM. It was always set the same as CONFIG_ACPI, and it had no menu label, so there was no way to set it to anything other than "y". Some things under CONFIG_ACPI_SYSTEM (acpi_irq_handled, acpi_os_gpe_count(), event_is_open, register_acpi_notifier(), etc.) are used unconditionally by the CA, the OSPM, and drivers, so we depend on them always being present. Signed-off-by: Bjorn Helgaas <bjorn.helgaas@hp.com> --- drivers/acpi/Kconfig | 7 ------- drivers/acpi/Makefile | 2 +- 2 files changed, 1 insertions(+), 8 deletions(-) -- To unsubscribe from this list: send the line "unsubscribe linux-acpi" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html