@@ -80,6 +80,19 @@
};
};
+&apb {
+ usb2_phy2: phy@78040 {
+ compatible = "amlogic,meson-gxl-usb2-phy";
+ #phy-cells = <0>;
+ reg = <0x0 0x78040 0x0 0x20>;
+ clocks = <&clkc CLKID_USB>;
+ clock-names = "phy";
+ resets = <&reset RESET_USB_OTG>;
+ reset-names = "phy";
+ status = "okay";
+ };
+};
+
&clkc_AO {
compatible = "amlogic,meson-gxm-aoclkc", "amlogic,meson-gx-aoclkc";
};
@@ -100,3 +113,7 @@
&hdmi_tx {
compatible = "amlogic,meson-gxm-dw-hdmi", "amlogic,meson-gx-dw-hdmi";
};
+
+&dwc3 {
+ phys = <&usb3_phy>, <&usb2_phy0>, <&usb2_phy1>, <&usb2_phy2>;
+};
The USB configuration on GXM is slightly different than on GXL. The dwc3 controller's internal hub has three USB2 ports (instead of 2 on GXL) along with a dedicated USB2 PHY for this port. However, it seems that there are no pins on GXM which would allow connecting the third port to a physical USB port. Passing the third PHY is required though, because without it none of the other USB ports is working (this seems to be a limitation of how the internal USB hub works, if one PHY is disabled then no USB port works). Signed-off-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com> --- arch/arm64/boot/dts/amlogic/meson-gxm.dtsi | 17 +++++++++++++++++ 1 file changed, 17 insertions(+)