diff mbox series

[v2,3/7] ARM: dts: meson8: add the temperature calibration data for the SAR ADC

Message ID 20190118225227.6516-4-martin.blumenstingl@googlemail.com (mailing list archive)
State Mainlined
Commit f4c6e8e223c2c77cd3bdde4c9da280fb2338aa5b
Headers show
Series ARM: dts: meson: chip temperature (hwmon) support | expand

Commit Message

Martin Blumenstingl Jan. 18, 2019, 10:52 p.m. UTC 
The SAR ADC can measure the chip temperature of the SoC. This only
works if the chip is calibrated and if the calibration data is written
to the correct registers. The calibration data is stored in the upper
two bytes of eFuse offset 0x1f4.

This adds the eFuse cell for the temperature calibration data and
passes it to the SAR ADC. We also need to pass the HHI sysctrl node to
the SAR ADC because the 4th TSC (temperature sensor calibration
coefficient) bit is stored in the HHI region (unlike bits [3:0] which
are stored directly inside the SAR ADC's register area).

On boards that have the SAR ADC enabled channel 8 can be used to
measure the chip temperature.

Signed-off-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com>
---
 arch/arm/boot/dts/meson8.dtsi | 8 ++++++++
 1 file changed, 8 insertions(+)
diff mbox series

Patch

diff --git a/arch/arm/boot/dts/meson8.dtsi b/arch/arm/boot/dts/meson8.dtsi
index 829984be4ed8..c9bd46120cb5 100644
--- a/arch/arm/boot/dts/meson8.dtsi
+++ b/arch/arm/boot/dts/meson8.dtsi
@@ -449,6 +449,11 @@ 
 	compatible = "amlogic,meson8-efuse";
 	clocks = <&clkc CLKID_EFUSE>;
 	clock-names = "core";
+
+	temperature_calib: calib@1f4 {
+		/* only the upper two bytes are relevant */
+		reg = <0x1f4 0x4>;
+	};
 };
 
 &ethmac {
@@ -536,6 +541,9 @@ 
 	clocks = <&clkc CLKID_XTAL>,
 		<&clkc CLKID_SAR_ADC>;
 	clock-names = "clkin", "core";
+	amlogic,hhi-sysctrl = <&hhi>;
+	nvmem-cells = <&temperature_calib>;
+	nvmem-cell-names = "temperature_calib";
 };
 
 &sdio {