| Message ID | 20231208-s4-dts-v2-2-5a93fa356c5d@amlogic.com (mailing list archive) |
|---|---|
| State | New, archived |
| Headers | show |
| Series | Add some devices nodes for S4. | expand |
On 08/12/2023 08:16, Xianwei Zhao via B4 Relay wrote: > From: Xianwei Zhao <xianwei.zhao@amlogic.com> > > Add reserved memory for board AQ222 which is used by ATF. > Enable NAND, SPICC nodes for board AQ222. > > Signed-off-by: Xianwei Zhao <xianwei.zhao@amlogic.com> > --- > .../boot/dts/amlogic/meson-s4-s805x2-aq222.dts | 56 ++++++++++++++++++++++ > 1 file changed, 56 insertions(+) > > diff --git a/arch/arm64/boot/dts/amlogic/meson-s4-s805x2-aq222.dts b/arch/arm64/boot/dts/amlogic/meson-s4-s805x2-aq222.dts > index c1f322c73982..18789242f05f 100644 > --- a/arch/arm64/boot/dts/amlogic/meson-s4-s805x2-aq222.dts > +++ b/arch/arm64/boot/dts/amlogic/meson-s4-s805x2-aq222.dts > @@ -23,6 +23,17 @@ memory@0 { > reg = <0x0 0x0 0x0 0x40000000>; > }; > > + reserved-memory { > + #address-cells = <2>; > + #size-cells = <2>; > + ranges; > + > + /* 52 MiB reserved for ARM Trusted Firmware */ > + secmon_reserved: secmon@5000000 { > + reg = <0x0 0x05000000 0x0 0x3400000>; > + no-map; > + }; > + }; > }; > > &uart_B { > @@ -34,3 +45,48 @@ &ir { > pinctrl-0 = <&remote_pins>; > pinctrl-names = "default"; > }; > + > +&nand { > + status = "okay"; > + #address-cells = <1>; > + #size-cells = <0>; > + > + pinctrl-0 = <&nand_pins>; > + pinctrl-names = "default"; > + > + nand@0 { > + reg = <0>; > + #address-cells = <1>; > + #size-cells = <1>; > + > + nand-on-flash-bbt; > + > + partition@0 { > + label = "boot"; > + reg = <0x0 0x00200000>; > + }; > + partition@200000 { > + label = "env"; > + reg = <0x00200000 0x00400000>; > + }; > + partition@600000 { > + label = "system"; > + reg = <0x00600000 0x00a00000>; > + }; > + partition@1000000 { > + label = "rootfs"; > + reg = <0x01000000 0x03000000>; > + }; > + partition@4000000 { > + label = "media"; > + reg = <0x04000000 0x8000000>; > + }; > + }; > +}; > + > +&spicc0 { > + status = "okay"; > + pinctrl-names = "default"; > + pinctrl-0 = <&spicc0_pins_x>; > + cs-gpios = <&gpio GPIOX_10 GPIO_ACTIVE_LOW>; > +}; > Reviewed-by: Neil Armstrong <neil.armstrong@linaro.org>
diff --git a/arch/arm64/boot/dts/amlogic/meson-s4-s805x2-aq222.dts b/arch/arm64/boot/dts/amlogic/meson-s4-s805x2-aq222.dts index c1f322c73982..18789242f05f 100644 --- a/arch/arm64/boot/dts/amlogic/meson-s4-s805x2-aq222.dts +++ b/arch/arm64/boot/dts/amlogic/meson-s4-s805x2-aq222.dts @@ -23,6 +23,17 @@ memory@0 { reg = <0x0 0x0 0x0 0x40000000>; }; + reserved-memory { + #address-cells = <2>; + #size-cells = <2>; + ranges; + + /* 52 MiB reserved for ARM Trusted Firmware */ + secmon_reserved: secmon@5000000 { + reg = <0x0 0x05000000 0x0 0x3400000>; + no-map; + }; + }; }; &uart_B { @@ -34,3 +45,48 @@ &ir { pinctrl-0 = <&remote_pins>; pinctrl-names = "default"; }; + +&nand { + status = "okay"; + #address-cells = <1>; + #size-cells = <0>; + + pinctrl-0 = <&nand_pins>; + pinctrl-names = "default"; + + nand@0 { + reg = <0>; + #address-cells = <1>; + #size-cells = <1>; + + nand-on-flash-bbt; + + partition@0 { + label = "boot"; + reg = <0x0 0x00200000>; + }; + partition@200000 { + label = "env"; + reg = <0x00200000 0x00400000>; + }; + partition@600000 { + label = "system"; + reg = <0x00600000 0x00a00000>; + }; + partition@1000000 { + label = "rootfs"; + reg = <0x01000000 0x03000000>; + }; + partition@4000000 { + label = "media"; + reg = <0x04000000 0x8000000>; + }; + }; +}; + +&spicc0 { + status = "okay"; + pinctrl-names = "default"; + pinctrl-0 = <&spicc0_pins_x>; + cs-gpios = <&gpio GPIOX_10 GPIO_ACTIVE_LOW>; +};