diff mbox series

[2/7] ARM: dts: amlogic: meson8b: enable UART RX and TX pull up by default

Message ID 20250329185855.854186-3-martin.blumenstingl@googlemail.com (mailing list archive)
State Accepted
Headers show
Series dts: amlogic: enable UART RX and TX pull up by default | expand

Commit Message

Martin Blumenstingl March 29, 2025, 6:58 p.m. UTC 
Some boards have noise on the UART RX line when the UART pins are not
connected to another device (such as an USB UART adapter). This can
be addressed by using a pull up resistor. Not all boards may provide
such a pull up resistor on the PCB so enable the SoC's pull-up on the
UART RX and TX pads by default. This matches the default (from u-boot
or SoC hardware) state for the pinmux configuration on these pads.

Signed-off-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com>
---
 arch/arm/boot/dts/amlogic/meson8b.dtsi | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)
diff mbox series

Patch

diff --git a/arch/arm/boot/dts/amlogic/meson8b.dtsi b/arch/arm/boot/dts/amlogic/meson8b.dtsi
index 0876611ce26a..faf09f77c605 100644
--- a/arch/arm/boot/dts/amlogic/meson8b.dtsi
+++ b/arch/arm/boot/dts/amlogic/meson8b.dtsi
@@ -368,7 +368,7 @@  uart_ao_a_pins: uart_ao_a {
 			mux {
 				groups = "uart_tx_ao_a", "uart_rx_ao_a";
 				function = "uart_ao";
-				bias-disable;
+				bias-pull-up;
 			};
 		};
 
@@ -521,7 +521,7 @@  mux {
 				groups = "uart_tx_b0",
 				       "uart_rx_b0";
 				function = "uart_b";
-				bias-disable;
+				bias-pull-up;
 			};
 		};