[v5,0/8] Add Rockchip SFC(serial flash controller) support

Message

Jon Lin June 7, 2021, 12:42 p.m. UTC

Changes in v5:
- Add support in device trees for rv1126
- Support sfc tx_dual, tx_quad
- Simplify the code, such as remove "rockchip_sfc_register_all"
- Support SFC ver4 ver5

Changes in v4:
- Changing patch back to an "RFC". An engineer from Rockchip
  reached out to me to let me know they are working on this patch for
  upstream, I am submitting this v4 for the community to see however
  I expect Jon Lin ([e-mail]) will submit new patches
  soon and these are the ones we should pursue for mainlining. Jon's
  patch series should include support for more hardware than this
  series.
- Clean up documentation more and ensure it is correct per
  make dt_binding_check.
- Add support in device trees for rk3036, rk3308, and rv1108.
- Add ahb clock (hclk_sfc) support for rk3036.
- Change rockchip_sfc_wait_fifo_ready() to use a switch statement.
- Change IRQ code to only mark IRQ as handled if it handles the
  specific IRQ (DMA transfer finish) it is supposed to handle.

Changes in v3:
- Changed the name of the clocks to sfc/ahb (from clk-sfc/clk-hsfc).
- Changed the compatible string from rockchip,sfc to
  rockchip,rk3036-sfc. A quick glance at the datasheets suggests this
  driver should work for the PX30, RK180x, RK3036, RK312x, RK3308 and
  RV1108 SoCs, and possibly more. However, I am currently only able
  to test this on a PX30 (an RK3326). The technical reference manuals
  appear to list the same registers for each device.
- Corrected devicetree documentation for formatting and to note these
  changes.
- Replaced the maintainer with Heiko Stuebner and myself, as we will
  take ownership of this going forward.
- Noted that the device (per the reference manual) supports 4 CS, but
  I am only able to test a single CS (CS 0).
- Reordered patches to comply with upstream rules.

Changes in v2:
- Reimplemented driver using spi-mem subsystem.
- Removed power management code as I couldn't get it working properly.
- Added device tree bindings for Odroid Go Advance.

Changes in v1:
hanges made in this new series versus the v8 of the old series:
- Added function to read spi-rx-bus-width from device tree, in the
  event that the SPI chip supports 4x mode but only has 2 pins
  wired (such as the Odroid Go Advance).
- Changed device tree documentation from txt to yaml format.
- Made "reset" message a dev_dbg from a dev_info.
- Changed read and write fifo functions to remove redundant checks.
- Changed the write and read from relaxed to non-relaxed when
  starting the DMA transfer or reading the DMA IRQ.
- Changed from dma_coerce_mask_and_coherent to just
  dma_set_mask_and_coherent.
- Changed name of get_if_type to rockchip_sfc_get_if_type.

Chris Morgan (8):
  dt-bindings: rockchip-sfc: Bindings for Rockchip serial flash
    controller
  spi: rockchip-sfc: add rockchip serial flash controller
  arm64: dts: rockchip: Add SFC to PX30
  clk: rockchip: Add support for hclk_sfc on rk3036
  arm: dts: rockchip: Add SFC to RK3036
  arm: dts: rockchip: Add SFC to RV1108
  arm64: dts: rockchip: Add SFC to RK3308
  arm64: dts: rockchip: Enable SFC for Odroid Go Advance

 .../devicetree/bindings/spi/rockchip-sfc.yaml |  86 ++
 arch/arm/boot/dts/rk3036.dtsi                 |  42 +
 arch/arm/boot/dts/rv1108.dtsi                 |  37 +
 arch/arm64/boot/dts/rockchip/px30.dtsi        |  38 +
 arch/arm64/boot/dts/rockchip/rk3308.dtsi      |  37 +
 .../boot/dts/rockchip/rk3326-odroid-go2.dts   |  16 +
 drivers/clk/rockchip/clk-rk3036.c             |   2 +-
 drivers/spi/Kconfig                           |   9 +
 drivers/spi/Makefile                          |   1 +
 drivers/spi/spi-rockchip-sfc.c                | 863 ++++++++++++++++++
 include/dt-bindings/clock/rk3036-cru.h        |   1 +
 11 files changed, 1131 insertions(+), 1 deletion(-)
 create mode 100644 Documentation/devicetree/bindings/spi/rockchip-sfc.yaml
 create mode 100644 drivers/spi/spi-rockchip-sfc.c