[v3,0/3] arm64: dts: Add InnoComm WB15-EVK support

Message

Sascha Hauer Sept. 19, 2022, 8:24 a.m. UTC

The InnoComm WB15-EVK [1] board is a Eval base board for the WB15 SoM
[2] which is based on the NXP i.MX8MM. This series adds InnoComm as a
vendor prefix and the necessary dts/dtsi files.

[1] https://www.innocomm.com/product_inner.aspx?num=2233
[2] https://www.innocomm.com/product_inner.aspx?num=2232

Changes since v2:
- Fix another remaining s/innocom/innocomm/
- Don't use underscores in node names
- Use IRQ_TYPE_LEVEL_LOW to specify interrupt polarity

Changes since v1:
- Fix spelling of InnoComm:
  s/innocom/innocomm/
  s/Innocom/InnoComm/

Sascha Hauer (3):
  dt-bindings: vendor-prefixes: Add prefix for InnoComm
  dt-bindings: arm: fsl: Add InnoComm WB15 EVK
  arm64: dts: freescale: Add InnoComm i.MX8MM based WB15 SoM and EVK

 .../devicetree/bindings/arm/fsl.yaml          |   1 +
 .../devicetree/bindings/vendor-prefixes.yaml  |   2 +
 arch/arm64/boot/dts/freescale/Makefile        |   1 +
 .../freescale/imx8mm-innocomm-wb15-evk.dts    | 147 ++++++
 .../dts/freescale/imx8mm-innocomm-wb15.dtsi   | 480 ++++++++++++++++++
 5 files changed, 631 insertions(+)
 create mode 100644 arch/arm64/boot/dts/freescale/imx8mm-innocomm-wb15-evk.dts
 create mode 100644 arch/arm64/boot/dts/freescale/imx8mm-innocomm-wb15.dtsi