Show patches with: Submitter = Stephen Boyd       |    State = Action Required       |   1318 patches
« 1 2 ... 3 4 5 … 13 14 »
Patch Series A/R/T S/W/F Date Submitter Delegate State
[v3,2/3] clk: stm32: Add clock driver for STM32F4[23]xxx devices - - - --- 2015-06-22 Stephen Boyd New
[10/10] ARM: dts: qcom: msm8974-sony-xperia-honami: Use stdout-path - - - --- 2015-06-16 Stephen Boyd New
[09/10] ARM: dts: qcom: msm8960-cdp: Use stdout-path - - - --- 2015-06-16 Stephen Boyd New
[08/10] ARM: dts: qcom: msm8660-surf: Use stdout-path - - - --- 2015-06-16 Stephen Boyd New
[07/10] ARM: dts: qcom: ipq8064-ap148: Use stdout-path - - - --- 2015-06-16 Stephen Boyd New
[06/10] ARM: dts: qcom: apq8084-mtp: Use stdout-path - - - --- 2015-06-16 Stephen Boyd New
[05/10] ARM: dts: qcom: apq8084-ifc6540: Use stdout-path - - - --- 2015-06-16 Stephen Boyd New
[04/10] ARM: dts: qcom: apq8074-dragonboard: Use stdout-path - - - --- 2015-06-16 Stephen Boyd New
[03/10] ARM: dts: qcom: apq8064-ifc6410: Use stdout-path - - - --- 2015-06-16 Stephen Boyd New
[02/10] ARM: dts: qcom: apq8064-cm-qs600: Use stdout-path - - - --- 2015-06-16 Stephen Boyd New
[01/10] ARM: dts: qcom: Label serial nodes for aliasing and stdout-path - - - --- 2015-06-16 Stephen Boyd New
[5/5] ARM: qcom_defconfig: Enable options for KS8851 ethernet - - - --- 2015-06-16 Stephen Boyd New
[4/5] ARM: dts: qcom: Add ks8851 node for wired ethernet - - - --- 2015-06-16 Stephen Boyd New
[3/5] ARM: dts: qcom: Add MSM8960 CDP RPM regulators - - - --- 2015-06-16 Stephen Boyd New
[2/5] ARM: dts: qcom: Add MSM8960 RPM and RPM regulator nodes - - - --- 2015-06-16 Stephen Boyd New
[1/5] ARM: dts: qcom: Replace gpio node with pinctrl node - - - --- 2015-06-16 Stephen Boyd New
spmi: Select IRQ_DOMAIN instead of depend on it - - - --- 2015-06-16 Stephen Boyd New
regulator: qcom_spmi: Add missing braces for aligned code - - - --- 2015-06-16 Stephen Boyd New
regulator: Add docbook for soft start - - - --- 2015-06-12 Stephen Boyd New
[v3] regulator: Add QCOM SPMI regulator driver - - - --- 2015-06-12 Stephen Boyd New
[v2,6/6] regulator: qcom-spmi: Add vendor specific configuration - - - --- 2015-06-12 Stephen Boyd New
[v2,5/6] regulator: Add input current limit support - - - --- 2015-06-12 Stephen Boyd New
[v2,4/6] regulator: Add soft start support - - - --- 2015-06-12 Stephen Boyd New
[v2,3/6] regulator: Add pull down support - - - --- 2015-06-12 Stephen Boyd New
[v2,2/6] regulator: Add system_load constraint - - - --- 2015-06-12 Stephen Boyd New
[v2,1/6] regulator: Add QCOM SPMI regulator driver - - - --- 2015-06-12 Stephen Boyd New
[v2,6/6] regulator: qcom-spmi: Add vendor specific configuration - - - --- 2015-06-12 Stephen Boyd New
[v2,5/6] regulator: Add input current limit support - - - --- 2015-06-12 Stephen Boyd New
[v2,4/6] regulator: Add soft start support - - - --- 2015-06-12 Stephen Boyd New
[v2,3/6] regulator: Add pull down support - - - --- 2015-06-12 Stephen Boyd New
[v2,2/6] regulator: Add system_load constraint - - - --- 2015-06-12 Stephen Boyd New
[v2,1/6] regulator: Add QCOM SPMI regulator driver - - - --- 2015-06-12 Stephen Boyd New
[2/2] arm: perf: Don't use of_node after putting it - - - --- 2015-06-03 Stephen Boyd New
[1/2] arm64: perf: Don't use of_node after putting it - - - --- 2015-06-03 Stephen Boyd New
[v2,2/2] soc: qcom: spm: Fix idle on THUMB2 kernels - - - --- 2015-06-02 Stephen Boyd New
[v2,1/2] ARM: Add cpu_resume_arm() for firmwares that resume in ARM state - - - --- 2015-06-02 Stephen Boyd New
[6/6] power: avs: Add support for CPR (Core Power Reduction) - - - --- 2015-06-02 Stephen Boyd New
[5/6] cpufreq-dt: Handle OPP voltage adjust events - - - --- 2015-06-02 Stephen Boyd New
[RFC/PATCH,4/6] OPP: Allow notifiers to call dev_pm_opp_get_{voltage, freq} RCU-free - - - --- 2015-06-02 Stephen Boyd New
[3/6] PM / OPP: Support adjusting OPP voltages at runtime - - - --- 2015-06-02 Stephen Boyd New
[2/6] regulator: core: Print at debug level on debugfs creation failure - - - --- 2015-06-02 Stephen Boyd New
[1/6] regulator: core: Don't spew backtraces on duplicate sysfs - - - --- 2015-06-02 Stephen Boyd New
ARM: Enter CPU in ARM state for cpu_resume - - - --- 2015-06-01 Stephen Boyd New
amba: Support clk parents and rates assigned in DT - - - --- 2015-05-28 Stephen Boyd New
[v7,6/7] clk: hi6220: Clock driver support for Hisilicon hi6220 SoC - - - --- 2015-05-22 Stephen Boyd New
[v7,6/7] clk: hi6220: Clock driver support for Hisilicon hi6220 SoC - - - --- 2015-05-22 Stephen Boyd New
[1/2,v4] clk: sirf: add CSR atlas7 clk and reset support - - - --- 2015-05-20 Stephen Boyd New
[2/2,v4] ARM: dts: atlas7: add fixed frequency clocks in car node - - - --- 2015-05-20 Stephen Boyd New
regulator: of: Skip disabled regulator nodes - - - --- 2015-05-12 Stephen Boyd New
regulator: Add SPMI regulator driver - - - --- 2015-05-12 Stephen Boyd New
[v3,0/2] clk: improve handling of orphan clocks - - - --- 2015-05-07 Stephen Boyd New
[v3,0/2] clk: improve handling of orphan clocks - - - --- 2015-05-01 Stephen Boyd New
[RFC,v1,3/5] clk: remove unneeded __clk_enable and __clk_disable - - - --- 2015-04-30 Stephen Boyd New
ufs-qcom: Switch dependency to ARCH_QCOM - - - --- 2015-04-10 Stephen Boyd New
TTY: msm_smd_tty: Remove unused driver - - - --- 2015-04-10 Stephen Boyd New
phy: qcom-ufs: Switch dependency to ARCH_QCOM - - - --- 2015-04-10 Stephen Boyd New
drivers/char: Remove msm_smd_pkt driver - - - --- 2015-04-10 Stephen Boyd New
clocksource: qcom: Remove dead code - - - --- 2015-04-10 Stephen Boyd New
[v5] ARM: smp: Only expose /sys/.../cpuX/online if hotpluggable - - - --- 2015-04-10 Stephen Boyd New
[v4] ARM: smp: Only expose /sys/.../cpuX/online if hotpluggable - - - --- 2015-04-07 Stephen Boyd New
[v4] ARM: smp: Only expose /sys/.../cpuX/online if hotpluggable - - - --- 2015-04-06 Stephen Boyd New
[GIT,PULL] qcom SoC changes for v4.1 - - - --- 2015-04-02 Stephen Boyd New
[PATCHv2,2/2] mfd: qcom_rpm: add support for IPQ8064 - - - --- 2015-03-26 Stephen Boyd New
[PATCHv2,1/2] mfd: devicetree: qcom_rpm: document IPQ8064 resources - - - --- 2015-03-26 Stephen Boyd New
[v3,13/13] ARM: dts: qcom: Add necessary DT data for Krait cpufreq - - - --- 2015-03-21 Stephen Boyd New
[v3,12/13] cpufreq: Add module to register cpufreq on Krait CPUs - - - --- 2015-03-21 Stephen Boyd New
[v3,11/13] clk: qcom: Add Krait clock controller driver - - - --- 2015-03-21 Stephen Boyd New
[v3,10/13] clk: qcom: Add KPSS ACC/GCC driver - - - --- 2015-03-21 Stephen Boyd New
[v3,09/13] clk: qcom: Add support for Krait clocks - - - --- 2015-03-21 Stephen Boyd New
[v3,08/13] clk: qcom: Add IPQ806X's HFPLLs - - - --- 2015-03-21 Stephen Boyd New
[v3,07/13] clk: qcom: Add MSM8960/APQ8064's HFPLLs - - - --- 2015-03-21 Stephen Boyd New
[v3,06/13] clk: qcom: Add HFPLL driver - - - --- 2015-03-21 Stephen Boyd New
[v3,05/13] clk: qcom: Add support for High-Frequency PLLs (HFPLLs) - - - --- 2015-03-21 Stephen Boyd New
[v3,04/13] clk: Add safe switch hook - - - --- 2015-03-21 Stephen Boyd New
[v3,03/13] clk: Avoid sending high rates to downstream clocks during set_rate - - - --- 2015-03-21 Stephen Boyd New
[v3,02/13] clk: mux: Split out register accessors for reuse - - - --- 2015-03-21 Stephen Boyd New
[v3,01/13] ARM: Add Krait L2 register accessor functions - - - --- 2015-03-21 Stephen Boyd New
[11/12] ufs-qcom: Switch dependency to ARCH_QCOM - - - --- 2015-03-13 Stephen Boyd New
[10/12] phy: qcom-ufs: Switch dependency to ARCH_QCOM - - - --- 2015-03-13 Stephen Boyd New
[09/12] usb: phy: msm: Remove dead code - - - --- 2015-03-13 Stephen Boyd New
[08/12] ehci-msm: Remove dead dependency - - - --- 2015-03-13 Stephen Boyd New
[07/12] clocksource: qcom: Remove dead code - - - --- 2015-03-13 Stephen Boyd New
[06/12] mmc: Remove msm_sdcc driver - - - --- 2015-03-13 Stephen Boyd New
[05/12] net: smc91x: Remove dead code - - - --- 2015-03-13 Stephen Boyd New
[04/12] tty: serial: msm_serial: Remove dead code - - - --- 2015-03-13 Stephen Boyd New
[03/12] tty: serial: Remove orphaned serial driver - - - --- 2015-03-13 Stephen Boyd New
[02/12] gpio: Remove gpio-msm-v1 driver - - - --- 2015-03-13 Stephen Boyd New
[PATCH/RESEND] irqchip: gic: Don't complain in gic_get_cpumask() if UP system - - - --- 2015-03-12 Stephen Boyd New
clk: provide clk_is_match() dummy for non-common clk - - - --- 2015-03-12 Stephen Boyd New
[v2] clk: qcom: Properly change rates for ahbix clock - - - --- 2015-03-06 Stephen Boyd New
[v3,3/3] ARM: perf: Add support for Scorpion PMUs - - - --- 2015-02-28 Stephen Boyd New
[v3,2/3] ARM: perf: Only reset PMxEVCNTCR registers on reset - - - --- 2015-02-28 Stephen Boyd New
[v3,1/3] ARM: perf: Preparatory work for Scorpion PMU support - - - --- 2015-02-28 Stephen Boyd New
clk: qcom: Fix ipq806x LCC frequency tables - - - --- 2015-02-27 Stephen Boyd New
clk: qcom: Properly change rates for ahbix clock - - - --- 2015-02-25 Stephen Boyd New
[7/8] ASoC: fsl_spdif: fix struct clk pointer comparing - - - --- 2015-02-25 Stephen Boyd New
[0/3] arm: msm: Use timer DT node for qcom watchdog config - - - --- 2015-02-23 Stephen Boyd New
[Cocci,v13,3/6] clk: Make clk API return per-user struct clk instances - - - --- 2015-02-17 Stephen Boyd New
[v3] ARM: smp: Only expose /sys/.../cpuX/online if hotpluggable - - - --- 2015-02-14 Stephen Boyd New
ARM: shmobile: Remove redundant cpu_disable implementation - - - --- 2015-02-14 Stephen Boyd New
« 1 2 ... 3 4 5 … 13 14 »