@@ -82,5 +82,15 @@
/* set partition map and/or chip-delay in board dts */
status = "disabled";
};
+
+ i2c@11000 {
+ compatible = "marvell,mv64xxx-i2c";
+ reg = <0x11000 0x20>;
+ #address-cells = <1>;
+ #size-cells = <0>;
+ interrupts = <29>;
+ clock-frequency = <100000>;
+ status = "disabled";
+ };
};
};
@@ -28,6 +28,8 @@ static struct of_device_id kirkwood_dt_match_table[] __initdata = {
struct of_dev_auxdata kirkwood_auxdata_lookup[] __initdata = {
OF_DEV_AUXDATA("marvell,orion-spi", 0xf1010600, "orion_spi.0", NULL),
+ OF_DEV_AUXDATA("marvell,mv64xxx-i2c", 0xf1011000, "mv64xxx_i2c.0",
+ NULL),
{},
};
@@ -17,6 +17,7 @@
#include <linux/dma-mapping.h>
#include <linux/clk-provider.h>
#include <linux/spinlock.h>
+#include <linux/mv643xx_i2c.h>
#include <net/dsa.h>
#include <asm/page.h>
#include <asm/timex.h>
@@ -241,6 +242,7 @@ void __init kirkwood_clk_init(void)
orion_clkdev_add("0", "pcie", pex0);
orion_clkdev_add("1", "pcie", pex1);
orion_clkdev_add(NULL, "kirkwood-i2s", audio);
+ orion_clkdev_add(NULL, MV64XXX_I2C_CTLR_NAME ".0", runit);
/* Marvell says runit is used by SPI, UART, NAND, TWSI, ...,
* so should never be gated.
@@ -47,6 +47,7 @@ void __init orion_clkdev_init(struct clk *tclk)
orion_clkdev_add(NULL, MV643XX_ETH_NAME ".2", tclk);
orion_clkdev_add(NULL, MV643XX_ETH_NAME ".3", tclk);
orion_clkdev_add(NULL, "orion_wdt", tclk);
+ orion_clkdev_add(NULL, MV64XXX_I2C_CTLR_NAME ".0", tclk);
}
/* Fill in the resources structure and link it into the platform
The MV64XXX I2C driver needs a clock in order to calculate the baud rate factors. So add an clk to the clk tree. Also add the base DT properties for kirkwood devices. Signed-off-by: Andrew Lunn <andrew@lunn.ch> --- arch/arm/boot/dts/kirkwood.dtsi | 10 ++++++++++ arch/arm/mach-kirkwood/board-dt.c | 2 ++ arch/arm/mach-kirkwood/common.c | 2 ++ arch/arm/plat-orion/common.c | 1 + 4 files changed, 15 insertions(+)