@@ -97,6 +97,8 @@ static void __init kirkwood_dt_init(void)
of_platform_populate(NULL, kirkwood_dt_match_table,
kirkwood_auxdata_lookup, NULL);
+
+ kirkwood_eth_clock_fixup();
}
static const char *kirkwood_dt_board_compat[] = {
@@ -18,6 +18,7 @@
#include <linux/clk-provider.h>
#include <linux/spinlock.h>
#include <linux/mv643xx_i2c.h>
+#include <linux/of.h>
#include <net/dsa.h>
#include <asm/page.h>
#include <asm/timex.h>
@@ -293,6 +294,27 @@ void __init kirkwood_ehci_init(void)
orion_ehci_init(USB_PHYS_BASE, IRQ_KIRKWOOD_USB, EHCI_PHY_NA);
}
+/* Fixup ethernet clocks for DT based kirkwood platforms.
+ * This is required because if the clock is not kept running, the
+ * Interface will forget its MAC address.
+ */
+#ifdef CONFIG_OF
+void __init kirkwood_eth_clock_fixup(void)
+{
+ struct device_node *np;
+
+ np = of_find_node_by_name(NULL, "egiga0");
+ if (np && of_device_is_available(np))
+ clk_prepare_enable(ge0);
+ of_node_put(np);
+
+ np = of_find_node_by_name(NULL, "egiga1");
+ if (np && of_device_is_available(np))
+ clk_prepare_enable(ge1);
+ of_node_put(np);
+
+}
+#endif
/*****************************************************************************
* GE00
@@ -36,6 +36,9 @@ void kirkwood_enable_pcie(void);
void kirkwood_pcie_id(u32 *dev, u32 *rev);
void kirkwood_ehci_init(void);
+#ifdef CONFIG_OF
+void kirkwood_eth_clock_fixup(void);
+#endif
void kirkwood_ge00_init(struct mv643xx_eth_platform_data *eth_data);
void kirkwood_ge01_init(struct mv643xx_eth_platform_data *eth_data);
void kirkwood_ge00_switch_init(struct dsa_platform_data *d, int irq);
This patch adds an ethernet setup helper function allowing the mv643xx clock to be kept enabled so that the MAC address(es) are not lost. Signed-off-by: Ian Molton <ian.molton@codethink.co.uk> --- arch/arm/mach-kirkwood/board-dt.c | 2 ++ arch/arm/mach-kirkwood/common.c | 22 ++++++++++++++++++++++ arch/arm/mach-kirkwood/common.h | 3 +++ 3 files changed, 27 insertions(+)