[V3] ARM: dt: tegra: seaboard: add regulators

Commit Message

Stephen Warren Aug. 3, 2012, 6:08 p.m. UTC

From: Stephen Warren <[e-mail]>

Seaboard uses a TPS6586x regulator. Instantiate this, and hook up a
couple of fixed GPIO-controlled regulators too.

Two data sources were used for the data encoded here:
* The HW defaults, as extracted from real HW.
* The schematic, which specifies a voltage for each LDO rail.

In most cases these sources matched. The only differences is:

ldo6: The HW default on Springbank is 2.85v. The HW default on Seaboard
is 1.8v. The schematics for both Springbank and Seaboard match at 2.85v.
However, internal research indicates that the schematics are incorrectly
labelled, and 1.8v is correct. The ChromeOS kernel also uses 1.8v.

Note that these settings don't entirely match those in the ChromeOS
kernel found at the URL below. However, the selected values generally
cause no behavior change in the kernel, and so were picked to avoid
regressions.

repo http://git.chromium.org/chromiumos/third_party/kernel.git
branch chromeos-3.2
file arch/arm/mach-tegra/board-seaboard-power.c

Portions based on work by Laxman Dewangan <[e-mail]>

Signed-off-by: Stephen Warren <[e-mail]>
---
v3:
* Switch back to simple-bus compatible value for the /regulators node.
* Added supply properties for all TPS6586x regulators.
* Made SM* children of the new SYS regulator.
* Removed ldo0 configuration, since it isn't used.
v2:
* Made all constraints match the HW defaults to avoid behavior changes,
  with exceptions noted above.
* Removed vin-supply properties from LDO nodes; the driver and binding
  need to be updated to support specifying the parent regulators before
  we can put these into DT.
* Use the enumerated-bus compatible value for the /regulators node.
* Enhanced all regulator-name properties to list all signal names directly
  derived from the regulator pins.
* Added ldo_rtc regulator.

Signed-off-by: Stephen Warren <[e-mail]>
---
 arch/arm/boot/dts/tegra20-seaboard.dts |  184 ++++++++++++++++++++++++++++++++
 1 files changed, 184 insertions(+), 0 deletions(-)

Comments

Stephen Warren Aug. 10, 2012, 4:51 p.m. UTC | #1

On 08/03/2012 12:08 PM, Stephen Warren wrote:
> Seaboard uses a TPS6586x regulator. Instantiate this, and hook up a
> couple of fixed GPIO-controlled regulators too.

Applied to for-3.7/dt.

Patch

diff --git a/arch/arm/boot/dts/tegra20-seaboard.dts b/arch/arm/boot/dts/tegra20-seaboard.dts
index 85e621a..92deb36 100644
--- a/arch/arm/boot/dts/tegra20-seaboard.dts
+++ b/arch/arm/boot/dts/tegra20-seaboard.dts
@@ -374,6 +374,152 @@ 
 		status = "okay";
 		clock-frequency = <400000>;
 
+		pmic: tps6586x@34 {
+			compatible = "ti,tps6586x";
+			reg = <0x34>;
+			interrupts = <0 86 0x4>;
+
+			#gpio-cells = <2>;
+			gpio-controller;
+
+			sys-supply = <&vdd_5v0_reg>;
+			vin-sm0-supply = <&sys_reg>;
+			vin-sm1-supply = <&sys_reg>;
+			vin-sm2-supply = <&sys_reg>;
+			vinldo01-supply = <&sm2_reg>;
+			vinldo23-supply = <&sm2_reg>;
+			vinldo4-supply = <&sm2_reg>;
+			vinldo678-supply = <&sm2_reg>;
+			vinldo9-supply = <&sm2_reg>;
+
+			regulators {
+				#address-cells = <1>;
+				#size-cells = <0>;
+
+				sys_reg: regulator@0 {
+					reg = <0>;
+					regulator-compatible = "sys";
+					regulator-name = "vdd_sys";
+					regulator-always-on;
+				};
+
+				regulator@1 {
+					reg = <1>;
+					regulator-compatible = "sm0";
+					regulator-name = "vdd_sm0,vdd_core";
+					regulator-min-microvolt = <1300000>;
+					regulator-max-microvolt = <1300000>;
+					regulator-always-on;
+				};
+
+				regulator@2 {
+					reg = <2>;
+					regulator-compatible = "sm1";
+					regulator-name = "vdd_sm1,vdd_cpu";
+					regulator-min-microvolt = <1125000>;
+					regulator-max-microvolt = <1125000>;
+					regulator-always-on;
+				};
+
+				sm2_reg: regulator@3 {
+					reg = <3>;
+					regulator-compatible = "sm2";
+					regulator-name = "vdd_sm2,vin_ldo*";
+					regulator-min-microvolt = <3700000>;
+					regulator-max-microvolt = <3700000>;
+					regulator-always-on;
+				};
+
+				/* LDO0 is not connected to anything */
+
+				regulator@5 {
+					reg = <5>;
+					regulator-compatible = "ldo1";
+					regulator-name = "vdd_ldo1,avdd_pll*";
+					regulator-min-microvolt = <1100000>;
+					regulator-max-microvolt = <1100000>;
+					regulator-always-on;
+				};
+
+				regulator@6 {
+					reg = <6>;
+					regulator-compatible = "ldo2";
+					regulator-name = "vdd_ldo2,vdd_rtc";
+					regulator-min-microvolt = <1200000>;
+					regulator-max-microvolt = <1200000>;
+				};
+
+				regulator@7 {
+					reg = <7>;
+					regulator-compatible = "ldo3";
+					regulator-name = "vdd_ldo3,avdd_usb*";
+					regulator-min-microvolt = <3300000>;
+					regulator-max-microvolt = <3300000>;
+					regulator-always-on;
+				};
+
+				regulator@8 {
+					reg = <8>;
+					regulator-compatible = "ldo4";
+					regulator-name = "vdd_ldo4,avdd_osc,vddio_sys";
+					regulator-min-microvolt = <1800000>;
+					regulator-max-microvolt = <1800000>;
+					regulator-always-on;
+				};
+
+				regulator@9 {
+					reg = <9>;
+					regulator-compatible = "ldo5";
+					regulator-name = "vdd_ldo5,vcore_mmc";
+					regulator-min-microvolt = <2850000>;
+					regulator-max-microvolt = <2850000>;
+					regulator-always-on;
+				};
+
+				regulator@10 {
+					reg = <10>;
+					regulator-compatible = "ldo6";
+					regulator-name = "vdd_ldo6,avdd_vdac,vddio_vi,vddio_cam";
+					regulator-min-microvolt = <1800000>;
+					regulator-max-microvolt = <1800000>;
+				};
+
+				regulator@11 {
+					reg = <11>;
+					regulator-compatible = "ldo7";
+					regulator-name = "vdd_ldo7,avdd_hdmi,vdd_fuse";
+					regulator-min-microvolt = <3300000>;
+					regulator-max-microvolt = <3300000>;
+				};
+
+				regulator@12 {
+					reg = <12>;
+					regulator-compatible = "ldo8";
+					regulator-name = "vdd_ldo8,avdd_hdmi_pll";
+					regulator-min-microvolt = <1800000>;
+					regulator-max-microvolt = <1800000>;
+				};
+
+				regulator@13 {
+					reg = <13>;
+					regulator-compatible = "ldo9";
+					regulator-name = "vdd_ldo9,avdd_2v85,vdd_ddr_rx";
+					regulator-min-microvolt = <2850000>;
+					regulator-max-microvolt = <2850000>;
+					regulator-always-on;
+				};
+
+				regulator@14 {
+					reg = <14>;
+					regulator-compatible = "ldo_rtc";
+					regulator-name = "vdd_rtc_out,vdd_cell";
+					regulator-min-microvolt = <3300000>;
+					regulator-max-microvolt = <3300000>;
+					regulator-always-on;
+				};
+			};
+		};
+
 		temperature-sensor@4c {
 			compatible = "nct1008";
 			reg = <0x4c>;
@@ -387,6 +533,10 @@ 
 		};
 	};
 
+	pmc {
+		nvidia,invert-interrupt;
+	};
+
 	memory-controller@0x7000f400 {
 		emc-table@190000 {
 			reg = <190000>;
@@ -473,6 +623,40 @@ 
 		};
 	};
 
+	regulators {
+		compatible = "simple-bus";
+		#address-cells = <1>;
+		#size-cells = <0>;
+
+		vdd_5v0_reg: regulator@0 {
+			compatible = "regulator-fixed";
+			reg = <0>;
+			regulator-name = "vdd_5v0";
+			regulator-min-microvolt = <5000000>;
+			regulator-max-microvolt = <5000000>;
+			regulator-always-on;
+		};
+
+		regulator@1 {
+			compatible = "regulator-fixed";
+			reg = <1>;
+			regulator-name = "vdd_1v5";
+			regulator-min-microvolt = <1500000>;
+			regulator-max-microvolt = <1500000>;
+			gpio = <&pmic 0 0>;
+		};
+
+		regulator@2 {
+			compatible = "regulator-fixed";
+			reg = <2>;
+			regulator-name = "vdd_1v2";
+			regulator-min-microvolt = <1200000>;
+			regulator-max-microvolt = <1200000>;
+			gpio = <&pmic 1 0>;
+			enable-active-high;
+		};
+	};
+
 	sound {
 		compatible = "nvidia,tegra-audio-wm8903-seaboard",
 			     "nvidia,tegra-audio-wm8903";