diff mbox

[v4,17/21] serial: omap: make sure to put() on poll_get_char

Message ID 1346935540-1792-18-git-send-email-balbi@ti.com (mailing list archive)
State New, archived
Headers show

Commit Message

Felipe Balbi Sept. 6, 2012, 12:45 p.m. UTC 
if we would reach serial_omap_get_char() while
Data Ready bit isn't set, we would return from
it without kicking our pm timer. This would mean
we would, eventually, have an unbalanced
pm_runtime_get on our device which would prevent
it from ever sleeping again.

Tested-by: Shubhrajyoti D <shubhrajyoti@ti.com>
Signed-off-by: Felipe Balbi <balbi@ti.com>
---
 drivers/tty/serial/omap-serial.c | 9 +++++++--
 1 file changed, 7 insertions(+), 2 deletions(-)
diff mbox

Patch

diff --git a/drivers/tty/serial/omap-serial.c b/drivers/tty/serial/omap-serial.c
index 7531147..6a58f4f 100644
--- a/drivers/tty/serial/omap-serial.c
+++ b/drivers/tty/serial/omap-serial.c
@@ -1005,12 +1005,17 @@  static int serial_omap_poll_get_char(struct uart_port *port)
 
 	pm_runtime_get_sync(up->dev);
 	status = serial_in(up, UART_LSR);
-	if (!(status & UART_LSR_DR))
-		return NO_POLL_CHAR;
+	if (!(status & UART_LSR_DR)) {
+		status = NO_POLL_CHAR;
+		goto out;
+	}
 
 	status = serial_in(up, UART_RX);
+
+out:
 	pm_runtime_mark_last_busy(up->dev);
 	pm_runtime_put_autosuspend(up->dev);
+
 	return status;
 }