@@ -146,6 +146,43 @@ static int max7301_get(struct gpio_chip
return level;
}
+static unsigned max7301_get_block(struct gpio_chip *chip, unsigned mask)
+{
+ struct max7301 *ts = container_of(chip, struct max7301, chip);
+ int i, j;
+ unsigned result = 0;
+
+ for (i = 0; i < 4; i++) {
+ if ((mask >> (i * 8)) & 0xFF) { /* i/o only if necessary */
+ u8 in_level = ts->read(ts->dev, 0x44 + i * 8);
+ u8 in_mask = 0;
+ u8 out_level = (ts->out_level >> (i * 8 + 4)) & 0xFF;
+ u8 out_mask = 0;
+
+ for (j = 0; j < 8; j++) {
+ int offset = 4 + i * 8 + j;
+ int config = (ts->port_config[offset >> 2] >>
+ ((offset & 3) << 1)) &
+ PIN_CONFIG_MASK;
+
+ switch (config) {
+ case PIN_CONFIG_OUT:
+ out_mask |= BIT(j);
+ break;
+ case PIN_CONFIG_IN_WO_PULLUP:
+ case PIN_CONFIG_IN_PULLUP:
+ in_mask |= BIT(j);
+ }
+ }
+
+ result |= ((unsigned)(in_level & in_mask) |
+ (out_level & out_mask)) << (i * 8);
+ }
+ }
+
+ return result & mask;
+}
+
static void max7301_set(struct gpio_chip *chip, unsigned offset, int value)
{
struct max7301 *ts = container_of(chip, struct max7301, chip);
@@ -160,6 +197,27 @@ static void max7301_set(struct gpio_chip
mutex_unlock(&ts->lock);
}
+static
+void max7301_set_block(struct gpio_chip *chip, unsigned mask, unsigned values)
+{
+ struct max7301 *ts = container_of(chip, struct max7301, chip);
+ unsigned changes;
+ int i;
+
+ mutex_lock(&ts->lock);
+
+ changes = (ts->out_level ^ (values << 4)) & (mask << 4);
+ ts->out_level ^= changes;
+
+ for (i = 0; i < 4; i++) {
+ if ((changes >> (i * 8 + 4)) & 0xFF) /* i/o only on change */
+ ts->write(ts->dev, 0x44 + i * 8,
+ (ts->out_level >> (i * 8 + 4)) & 0xFF);
+ }
+
+ mutex_unlock(&ts->lock);
+}
+
int __devinit __max730x_probe(struct max7301 *ts)
{
struct device *dev = ts->dev;
@@ -183,8 +241,10 @@ int __devinit __max730x_probe(struct max
ts->chip.direction_input = max7301_direction_input;
ts->chip.get = max7301_get;
+ ts->chip.get_block = max7301_get_block;
ts->chip.direction_output = max7301_direction_output;
ts->chip.set = max7301_set;
+ ts->chip.set_block = max7301_set_block;
ts->chip.base = pdata->base;
ts->chip.ngpio = PIN_NUMBER;
This patch adds block GPIO API support to the MAX730x driver. Due to hardware constraints in this chip, simultaneous access to GPIO lines can only be done in groups of 8: GPIOs 0-7, 8-15, 16-23, 24-27. However, setting and clearing will be done at once. Signed-off-by: Roland Stigge <stigge@antcom.de> --- drivers/gpio/gpio-max730x.c | 60 ++++++++++++++++++++++++++++++++++++++++++++ 1 file changed, 60 insertions(+)