| Message ID | 1351958348-7327-2-git-send-email-maxime.ripard@free-electrons.com (mailing list archive) |
|---|---|
| State | New, archived |
| Headers | show |
diff --git a/arch/arm/boot/dts/imx28-cfa10036.dts b/arch/arm/boot/dts/imx28-cfa10036.dts index 816cae9..8760b87 100644 --- a/arch/arm/boot/dts/imx28-cfa10036.dts +++ b/arch/arm/boot/dts/imx28-cfa10036.dts @@ -22,6 +22,18 @@ apb@80000000 { apbh@80000000 { + pinctrl@80018000 { + led_pins_cfa10036: leds-10036@0 { + reg = <0>; + fsl,pinmux-ids = < + 0x3043 /* MX28_PAD_AUART1_RX__GPIO_3_4 */ + >; + fsl,drive-strength = <0>; + fsl,voltage = <1>; + fsl,pull-up = <0>; + }; + }; + ssp0: ssp@80010000 { compatible = "fsl,imx28-mmc"; pinctrl-names = "default"; @@ -62,6 +74,8 @@ leds { compatible = "gpio-leds"; + pinctrl-names = "default"; + pinctrl-0 = <&led_pins_cfa10036>; power { gpios = <&gpio3 4 1>;
The leds-gpio driver recently got pinctrl support, so setup the power led gpio muxing through pinctrl. This avoids the warning: leds-gpio leds.X: pins are not configured from the driver Signed-off-by: Maxime Ripard <maxime.ripard@free-electrons.com> --- arch/arm/boot/dts/imx28-cfa10036.dts | 14 ++++++++++++++ 1 file changed, 14 insertions(+)