diff mbox

[2/5] ARM: Kirkwood: Convert DNSKW to use regulators

Message ID 1353163574-6362-3-git-send-email-andrew@lunn.ch (mailing list archive)
State New, archived
Headers show

Commit Message

Andrew Lunn Nov. 17, 2012, 2:46 p.m. UTC 
Control the power to SATA0 and SATA1 using a fixed regulator.

Signed-off-by: Andrew Lunn <andrew@lunn.ch>
Tested-by: Jamie Lentin <jm@lentin.co.uk>
---
 arch/arm/boot/dts/kirkwood-dnskw.dtsi |   29 +++++++++++++++++++++++++++++
 arch/arm/mach-kirkwood/board-dnskw.c  |    4 ----
 2 files changed, 29 insertions(+), 4 deletions(-)
diff mbox

Patch

diff --git a/arch/arm/boot/dts/kirkwood-dnskw.dtsi b/arch/arm/boot/dts/kirkwood-dnskw.dtsi
index 22aa07a..b6aeb4f 100644
--- a/arch/arm/boot/dts/kirkwood-dnskw.dtsi
+++ b/arch/arm/boot/dts/kirkwood-dnskw.dtsi
@@ -81,4 +81,33 @@ 
 			};
 		};
 	};
+
+	regulators {
+		compatible = "simple-bus";
+		#address-cells = <1>;
+		#size-cells = <0>;
+
+		sata0_power: regulator@1 {
+			compatible = "regulator-fixed";
+			reg = <1>;
+			regulator-name = "SATA0 Power";
+			regulator-min-microvolt = <5000000>;
+			regulator-max-microvolt = <5000000>;
+			enable-active-high;
+			regulator-always-on;
+			regulator-boot-on;
+			gpio = <&gpio1 7 0>;
+		};
+		sata1_power: regulator@2 {
+			compatible = "regulator-fixed";
+			reg = <2>;
+			regulator-name = "SATA1 Power";
+			regulator-min-microvolt = <5000000>;
+			regulator-max-microvolt = <5000000>;
+			enable-active-high;
+			regulator-always-on;
+			regulator-boot-on;
+			gpio = <&gpio1 8 0>;
+		};
+	};
 };
diff --git a/arch/arm/mach-kirkwood/board-dnskw.c b/arch/arm/mach-kirkwood/board-dnskw.c
index 549369e..653bbbe 100644
--- a/arch/arm/mach-kirkwood/board-dnskw.c
+++ b/arch/arm/mach-kirkwood/board-dnskw.c
@@ -76,10 +76,6 @@  void __init dnskw_init(void)
 	kirkwood_ehci_init();
 	kirkwood_ge00_init(&dnskw_ge00_data);
 
-	/* Ensure power is supplied to both HDDs */
-	dnskw_gpio_register(39, "dnskw:power:sata0", 1);
-	dnskw_gpio_register(40, "dnskw:power:sata1", 1);
-
 	/* Set NAS to turn back on after a power failure */
 	dnskw_gpio_register(37, "dnskw:power:recover", 1);
 }