@@ -30,6 +30,12 @@ ab8500-fg : : vddadc : Fuel Gauge
: LOW_BAT_F : : LOW threshold battery voltage
: CC_INT_CALIB : : Coulomb Counter Internal Calibration
: CCEOC : : Coulomb Counter End of Conversion
+ab8500-btemp : : vtvout : Battery Temperature
+ : BAT_CTRL_INDB : : Battery Removal Indicator
+ : BTEMP_LOW : : Btemp < BtempLow, if battery temperature is lower than -10°C
+ : BTEMP_LOW_MEDIUM : : BtempLow < Btemp < BtempMedium,if battery temperature is between -10 and 0°C
+ : BTEMP_MEDIUM_HIGH : : BtempMedium < Btemp < BtempHigh,if battery temperature is between 0°C and“MaxTemp
+ : BTEMP_HIGH : : Btemp > BtempHigh, if battery temperature is higher than “MaxTemp
ab8500-gpadc : HW_CONV_END : vddadc : Analogue to Digital Converter
SW_CONV_END : :
ab8500-gpio : : : GPIO Controller
new file mode 100644
@@ -0,0 +1,16 @@
+=== AB8500 Battery Temperature Monitor Driver ===
+
+The properties below describes the node for btemp driver.
+
+Required Properties:
+- compatible = Shall be: "stericsson,ab8500-btemp"
+- battery = Shall be battery specific information
+
+ Example:
+ ab8500_btemp {
+ compatible = "stericsson,ab8500-btemp";
+ battery = <&ab8500_battery>;
+ };
+
+For information on battery specific node, Ref:
+Documentation/devicetree/bindings/power_supply/ab8500/fg.txt
@@ -357,6 +357,11 @@
thermistor-on-batctrl;
};
+ ab8500-btemp {
+ compatible = "stericsson,ab8500-btemp";
+ battery = <&ab8500_battery>;
+ };
+
ab8500-fg {
compatible = "stericsson,ab8500-fg";
battery = <&ab8500_battery>;
@@ -1046,8 +1046,13 @@ static struct mfd_cell __devinitdata ab8500_bm_devs[] = {
},
{
.name = "ab8500-btemp",
+ .of_compatible = "stericsson,ab8500-btemp",
.num_resources = ARRAY_SIZE(ab8500_btemp_resources),
.resources = ab8500_btemp_resources,
+#ifndef CONFIG_OF
+ .platform_data = &ab8500_bm_data,
+ .pdata_size = sizeof(ab8500_bm_data),
+#endif
},
{
.name = "ab8500-fg",
@@ -329,12 +329,6 @@ config AB8500_BM
help
Say Y to include support for AB8500 battery management.
-config AB8500_BATTERY_THERM_ON_BATCTRL
- bool "Thermistor connected on BATCTRL ADC"
- depends on AB8500_BM
- help
- Say Y to enable battery temperature measurements using
- thermistor connected on BATCTRL ADC.
endif # POWER_SUPPLY
source "drivers/power/avs/Kconfig"
@@ -29,7 +29,7 @@ static struct abx500_res_to_temp temp_tbl_A_thermistor[] = {
{65, 12500},
};
static struct abx500_res_to_temp temp_tbl_B_thermistor[] = {
- {-5, 165418},
+ {-5, 200000},
{ 0, 159024},
{ 5, 151921},
{10, 144300},
@@ -237,7 +237,7 @@ struct abx500_battery_type bat_type_thermistor[] = {
},
{
.name = POWER_SUPPLY_TECHNOLOGY_LIPO,
- .resis_high = 165418,
+ .resis_high = 200000,
.resis_low = 82869,
.battery_resistance = 300,
.charge_full_design = 900,
@@ -20,11 +20,13 @@
#include <linux/power_supply.h>
#include <linux/completion.h>
#include <linux/workqueue.h>
-#include <linux/mfd/abx500/ab8500.h>
+#include <linux/jiffies.h>
+#include <linux/of.h>
+#include <linux/mfd/core.h>
#include <linux/mfd/abx500.h>
+#include <linux/mfd/abx500/ab8500.h>
#include <linux/mfd/abx500/ab8500-bm.h>
#include <linux/mfd/abx500/ab8500-gpadc.h>
-#include <linux/jiffies.h>
#define VTVOUT_V 1800
@@ -76,7 +78,6 @@ struct ab8500_btemp_ranges {
* @parent: Pointer to the struct ab8500
* @gpadc: Pointer to the struct gpadc
* @fg: Pointer to the struct fg
- * @pdata: Pointer to the abx500_btemp platform data
* @bat: Pointer to the abx500_bm platform data
* @btemp_psy: Structure for BTEMP specific battery properties
* @events: Structure for information about events triggered
@@ -93,7 +94,6 @@ struct ab8500_btemp {
struct ab8500 *parent;
struct ab8500_gpadc *gpadc;
struct ab8500_fg *fg;
- struct abx500_bmdevs_plat_data *pdata;
struct abx500_bm_data *bat;
struct power_supply btemp_psy;
struct ab8500_btemp_events events;
@@ -955,48 +955,58 @@ static int __devexit ab8500_btemp_remove(struct platform_device *pdev)
flush_scheduled_work();
power_supply_unregister(&di->btemp_psy);
platform_set_drvdata(pdev, NULL);
- kfree(di);
return 0;
}
+static char *supply_interface[] = {
+ "ab8500_chargalg",
+ "ab8500_fg",
+};
+
static int __devinit ab8500_btemp_probe(struct platform_device *pdev)
{
- struct abx500_bmdevs_plat_data *plat_data = pdev->dev.platform_data;
+ struct device_node *np = pdev->dev.of_node;
struct ab8500_btemp *di;
int irq, i, ret = 0;
u8 val;
- if (!plat_data) {
- dev_err(&pdev->dev, "No platform data\n");
- return -EINVAL;
+ di = devm_kzalloc(&pdev->dev, sizeof(*di), GFP_KERNEL);
+ if (!di) {
+ dev_err(&pdev->dev, "%s no mem for ab8500_btemp\n", __func__);
+ return -ENOMEM;
}
- di = kzalloc(sizeof(*di), GFP_KERNEL);
- if (!di)
- return -ENOMEM;
+ di->bat = pdev->mfd_cell->platform_data;
+ if (!di->bat) {
+ if (np) {
+ ret = bmdevs_of_probe(&pdev->dev, np, &di->bat);
+ if (ret) {
+ dev_err(&pdev->dev,
+ "failed to get battery information\n");
+ return ret;
+ }
+ } else {
+ dev_err(&pdev->dev, "missing dt node for ab8500_btemp\n");
+ return -EINVAL;
+ }
+ } else {
+ dev_info(&pdev->dev, "falling back to legacy platform data\n");
+ }
/* get parent data */
di->dev = &pdev->dev;
di->parent = dev_get_drvdata(pdev->dev.parent);
di->gpadc = ab8500_gpadc_get("ab8500-gpadc.0");
- /* get btemp specific platform data */
- di->pdata = plat_data;
- if (!di->pdata) {
- dev_err(di->dev, "no btemp platform data supplied\n");
- ret = -EINVAL;
- goto free_device_info;
- }
-
/* BTEMP supply */
di->btemp_psy.name = "ab8500_btemp";
di->btemp_psy.type = POWER_SUPPLY_TYPE_BATTERY;
di->btemp_psy.properties = ab8500_btemp_props;
di->btemp_psy.num_properties = ARRAY_SIZE(ab8500_btemp_props);
di->btemp_psy.get_property = ab8500_btemp_get_property;
- di->btemp_psy.supplied_to = di->pdata->supplied_to;
- di->btemp_psy.num_supplicants = di->pdata->num_supplicants;
+ di->btemp_psy.supplied_to = supply_interface;
+ di->btemp_psy.num_supplicants = ARRAY_SIZE(supply_interface);
di->btemp_psy.external_power_changed =
ab8500_btemp_external_power_changed;
@@ -1006,8 +1016,7 @@ static int __devinit ab8500_btemp_probe(struct platform_device *pdev)
create_singlethread_workqueue("ab8500_btemp_wq");
if (di->btemp_wq == NULL) {
dev_err(di->dev, "failed to create work queue\n");
- ret = -ENOMEM;
- goto free_device_info;
+ return -ENOMEM;
}
/* Init work for measuring temperature periodically */
@@ -1085,12 +1094,15 @@ free_irq:
}
free_btemp_wq:
destroy_workqueue(di->btemp_wq);
-free_device_info:
- kfree(di);
return ret;
}
+static const struct of_device_id ab8500_btemp_match[] = {
+ { .compatible = "stericsson,ab8500-btemp", },
+ { },
+};
+
static struct platform_driver ab8500_btemp_driver = {
.probe = ab8500_btemp_probe,
.remove = __devexit_p(ab8500_btemp_remove),
@@ -1099,6 +1111,7 @@ static struct platform_driver ab8500_btemp_driver = {
.driver = {
.name = "ab8500-btemp",
.owner = THIS_MODULE,
+ .of_match_table = ab8500_btemp_match,
},
};