| Message ID | 1357725965-27342-3-git-send-email-lee.jones@linaro.org (mailing list archive) |
|---|---|
| State | New, archived |
| Headers | show |
On Wed, Jan 9, 2013 at 11:06 AM, Lee Jones <lee.jones@linaro.org> wrote: > Here we setup the GPIO pin responsible for illuminating the user > LED on the Snowball low-cost development board. > > Signed-off-by: Lee Jones <lee.jones@linaro.org> Patch applied to my ux500 tree, branch ux500-pinctrl. Yours, Linus Walleij
On Wed, 23 Jan 2013, Linus Walleij wrote: > On Wed, Jan 9, 2013 at 11:06 AM, Lee Jones <lee.jones@linaro.org> wrote: > > > Here we setup the GPIO pin responsible for illuminating the user > > LED on the Snowball low-cost development board. > > > > Signed-off-by: Lee Jones <lee.jones@linaro.org> > > Patch applied to my ux500 tree, branch ux500-pinctrl. Perhaps you can apply this to the for-next branch you pulled from me?
diff --git a/arch/arm/mach-ux500/board-mop500-pins.c b/arch/arm/mach-ux500/board-mop500-pins.c index 0a3f30d..d1a775c 100644 --- a/arch/arm/mach-ux500/board-mop500-pins.c +++ b/arch/arm/mach-ux500/board-mop500-pins.c @@ -747,6 +747,8 @@ static struct pinctrl_map __initdata snowball_pinmap[] = { DB8500_PIN_HOG("GPIO21_AB3", out_hi), /* Mux in "SM" which is used for the SMSC911x Ethernet adapter */ DB8500_MUX_HOG("sm_b_1", "sm"), + /* User LED */ + DB8500_PIN_HOG("GPIO142_C11", gpio_out_hi), /* Drive RSTn_LAN high */ DB8500_PIN_HOG("GPIO141_C12", gpio_out_hi), /* Accelerometer/Magnetometer */
Here we setup the GPIO pin responsible for illuminating the user LED on the Snowball low-cost development board. Signed-off-by: Lee Jones <lee.jones@linaro.org> --- arch/arm/mach-ux500/board-mop500-pins.c | 2 ++ 1 file changed, 2 insertions(+)