diff mbox

[4/9] ARM: shmobile: armadillo800eva: Use gpio_set_value() to set GPIO value

Message ID 1359613442-26038-5-git-send-email-horms+renesas@verge.net.au (mailing list archive)
State New, archived
Headers show

Commit Message

Simon Horman Jan. 31, 2013, 6:23 a.m. UTC 
From: Laurent Pinchart <laurent.pinchart+renesas@ideasonboard.com>

The GPIO is already configured as an output, there's no reason to use
gpio_direction_output() just to set the output value. Use
gpio_set_value() instead.

Signed-off-by: Laurent Pinchart <laurent.pinchart+renesas@ideasonboard.com>
Acked-by: Guennadi Liakhovetski <g.liakhovetski@gmx.de>
Signed-off-by: Simon Horman <horms+renesas@verge.net.au>
---
 arch/arm/mach-shmobile/board-armadillo800eva.c |    4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)
diff mbox

Patch

diff --git a/arch/arm/mach-shmobile/board-armadillo800eva.c b/arch/arm/mach-shmobile/board-armadillo800eva.c
index efd6a36..f107e82 100644
--- a/arch/arm/mach-shmobile/board-armadillo800eva.c
+++ b/arch/arm/mach-shmobile/board-armadillo800eva.c
@@ -708,9 +708,9 @@  static int mt9t111_power(struct device *dev, int mode)
 		/* video1 (= CON1 camera) expect 24MHz */
 		clk_set_rate(mclk, clk_round_rate(mclk, 24000000));
 		clk_enable(mclk);
-		gpio_direction_output(GPIO_PORT158, 1);
+		gpio_set_value(GPIO_PORT158, 1);
 	} else {
-		gpio_direction_output(GPIO_PORT158, 0);
+		gpio_set_value(GPIO_PORT158, 0);
 		clk_disable(mclk);
 	}