@@ -63,7 +63,6 @@ struct ab8500_shared_mode {
* @voltage_reg: register to control regulator voltage
* @voltage_mask: mask to control regulator voltage
* @voltage_shift: shift to control regulator voltage
- * @delay: startup/set voltage delay in us
*/
struct ab8500_regulator_info {
struct device *dev;
@@ -87,7 +86,6 @@ struct ab8500_regulator_info {
u8 voltage_reg;
u8 voltage_mask;
u8 voltage_shift;
- unsigned int delay;
struct {
u8 voltage_limit;
u8 voltage_bank;
@@ -652,7 +650,7 @@ static int ab8500_regulator_set_voltage_time_sel(struct regulator_dev *rdev,
{
struct ab8500_regulator_info *info = rdev_get_drvdata(rdev);
- return info->delay;
+ return info->desc.enable_time;
}
static struct regulator_ops ab8500_regulator_volt_mode_ops = {
@@ -829,7 +827,6 @@ static struct ab8500_regulator_info
.volt_table = fixed_2000000_voltage,
.enable_time = 500,
},
- .delay = 500,
.load_lp_uA = 1000,
.update_bank = 0x03,
.update_reg = 0x80,
@@ -1100,7 +1097,6 @@ static struct ab8500_regulator_info
.volt_table = fixed_2000000_voltage,
.enable_time = 10000,
},
- .delay = 10000,
.load_lp_uA = 1000,
.update_bank = 0x03,
.update_reg = 0x80,
@@ -1366,7 +1362,6 @@ static struct ab8500_regulator_info
.volt_table = fixed_2000000_voltage,
.enable_time = 10000,
},
- .delay = 10000,
.load_lp_uA = 1000,
.update_bank = 0x03,
.update_reg = 0x80,
@@ -1664,7 +1659,6 @@ static struct ab8500_regulator_info
.n_voltages = 1,
.enable_time = 10000,
},
- .delay = 10000,
.load_lp_uA = 1000,
.update_bank = 0x03,
.update_reg = 0x80,
The regulator framework now has provisions to read a regulator's start-up time via the 'enable_time' attribute. So let's remove all 'enable_time'/'delay' duplication and just stick with 'enable_time' from now on. Signed-off-by: Lee Jones <lee.jones@linaro.org> --- drivers/regulator/ab8500.c | 8 +------- 1 file changed, 1 insertion(+), 7 deletions(-)